Whirlpool AKP 700 WH, AKP 710 WH INSTRUCTION FOR USE

56832Gb.fm5 Page 21 Monday, September 17, 2001 3:23 PM

TABLE OF CONTENTS GB

INSTALLATION

ELECTRICAL CONNECTION

BEFORE USING THE OVEN

PROTECTING THE ENVIRONMENT

PRECAUTIONS AND GENERAL RECOMMENDATIONS

OVEN ACCESSORIES

COOKING CHART

CLEANING THE OVEN AND ACCESSORIES

TROUBLESHOOTING GUIDE

PAGE

AFTER-SALES SERVICE

DECLARATION OF CONFORMITY CE

PAGE

56832Gb.fm5 Page 22 Monday, September 17, 2001 3:23 PM

INSTALLATION

Technical information for the installer

•

After removing the oven from its packaging, before making the connections place it on the polystyrene foam base to protect it from damage.

•

Do not attempt to lift the oven by the handle. Lift at the sides as shown in the figure (see arrow).

•

Check that the appliance has not been damaged in transit.

•

Oven dimensions and kitchen unit dimensions are shown in the opposite figure.

•

Kitchen units in contact with the oven must be heat resistant (80° C min).

•

Connect the earth wire (A) of the cooktop to the oven (B) as illustrated.

•

Connect clamps (C) of the cooktop to the oven junction block (D) situated in the upper section, following the colour code indicated on the plate.

•

Connect clamp (E) of the cooktop (2 pole connector indicated with the red colour) to the junction block (F) situated on the top of the oven as shown in the picture.

•

Install the oven in the housing, lifting it at the sides, taking care not to trap the wires of the electrical supply cable.

•

For correct ventilation, follow the ventilation opening directions shown in the figure (at least 500 x 80 mm or an equivalent area). Also provide for at least 5 mm clearance between the top of the oven and the lower edge of the worktop.This space must not be obstructed by cross rails or other structural elements.

•

During oven installation, care must be taken to ensure that the sides are not touching the front edges of the housing or adjacent drawers and doors (see picture).

•

Carry out the electrical connections between cooktop and oven (see chapter “Electrical Connection”).

•

Secure the oven to the kitchen unit with screws (A) as shown.

No Contacts

56832Gb.fm5 Page 23 Monday, September 17, 2001 3:23 PM

ELECTRICAL CONNECTION

• Warning: Do not connect to the power supply before you have finished connecting the oven and cooktop.

• Make sure the oven is installed and connected to the electricity supply by a qualified technician in accordance with the manufacturer’s instructions and in compliance with local regulations.

• The installer is responsible for the correct electrical connection of the oven and the observance of the relative safety prescriptions.

Interconnecting cooktop and oven

•

Make sure that the voltage shown on the rating plate is the same as the power supply voltage in your home. The rating plate is on the front edge of the oven cavity (visible with oven door open).

•

Use a type H05RR-F power cord (minimum length 800 mm):

Conductors X number

Connection

• The oven must be connected to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm.

• The appliances must be earthed by law.

• Do not use multiple plug adapters or extension leads.

• After the oven has been installed, the electrical components must be inaccessible.

1N +

2N +

3 +

3N +

~ ~

H05 RR-F 3x4 mm²

H05 RR-F 4x2.5 mm²

H05 RR-F 5x1.5 mm²

+ 6 hidden pages