RIFERIMENTI NORMATIVE
REFERENCE TO LOCAL
REFERENTIES LOKALE
REFERENCE TO LOCAL
NAZIONALI
IT
Norma di areazione della stanza
Quando l’apparecchio non è provvisto di
Nota:
sicurezza sui bruciatori del piano di lavoro
(termocoppie), le aperture di ventilazione devono
essere maggiorate nella misura del 100% con un
minimo di 200 cm
1993.
2
, in conformità al D.M. 21 aprile
Collegamento all’alimentazione del gas
Prima di procedere al collegamento
dell’apparecchio, accertarsi che l’impianto di
alimentazione sia conforme alle norme
UNI-CIG 7129
e
UNI CIG 7131
.
Allacciamento al gas
Per il collegamento dell’apparecchio alla rete del gas o
bombola, utilizzare il tubo metallico rigido di rame o
acciaio con relativi raccordi conformi alla norma
UNI-CIG 7129
parete continua conforme alla norma
I tubi metallici flessibili devono avere una lunghezza
massima di 2 m.
I regolatori di pressione da utilizzare devono essere
conformi alla norma
bombola e
di rete).
, oppure il tubo flessibile in inox con
UNI-CIG 9891
UNI EN 12864
UNI EN 88
per gas canalizzati (metano
per gas in
RAPPELS SUR LES NORMES
DE SÉCURITE EN VIGUEUR
DANS LE PAYS
D’INSTALLATION
BE
L’appareil est équipé d’un embout conique fileté 1/2”
pour être raccordé à l’alimentation en gaz
(conformément aux réglementations
Le raccordement doit être réalisé conformément à
la norme
rigide, ou conformément au document des
spécifications
flexible.
Au moment de l’installation, l’appareil doit être doté
d’une valve d’arrêt
NBN D 51-003
A.R.G.B./03
au moyen d’un tuyau
à l’aide d’un tuyau
agréée AGB
ISO 7/1 RP 1/2
.
REGULATIONS: ENGLISH
VERSION FOR IT
REGULATION
IT
Regulation for room ventilation
If the appliance is not equipped with safety
Note:
devices on the burners (thermocouples), the air vents
must be increased by 100%, and must be at least
2
200 cm
), in compliance with M.D. 21 April 1993.
Connection to gas supply
Before connecting the appliance, make sure that the
gas supply system complies with standards
UNI-CIG 7129
and
UNI CIG 7131
.
Gas connection
The connection to the mains gas network or gas
cylinder must be made using a rigid copper or steel
pipe with fittings complying with standards
.
UNI-CIG 7129
stainless steel hose complying with standards
UNI-CIG 9891
The maximum length of the hose is 2 m.
The pressure control valves to be used must comply
with the
and the
UNI EN 88
, or using a continuous-surface
.
UNI EN 12864
standard for gas cylinders
standard for piped methane gas.
NATIONALER
NORMENBEZUG
BE
Das Gerät ist mit einem konischen Gewinde
(1/2 Zoll) für den Gasanschluss ausgerüstet
(gemäß
).
Der Gasanschluss muss gemäß
51-003
dem Spezifikationsblatt
flexiblen Schlauch erfolgen.
Das Gerät muss mit einem nach
zugelassenen
ISO 7/1 RP 1/2
mit einer starren Leitung oder entsprechend
Notstoppventil ausgerüstet sein.
).
NBN D
A.R.G.B./03
AGB
mit einem
VOORSCHRIFTEN
BE
Het apparaat is uitgerust met een kegelvormig 1/2”
uiteinde met schroefdraad voor de aansluiting op de
gastoevoer (overeenkomstig de ISO-voorschriften
ISO 7/1 RP 1/2
De aansluiting moet uitgevoerd worden ofwel met
een stijve leiding in overeenstemming met de norm
NBN D 51-003
overeenstemming met het specificatieblad
A.R.G.B./03
Het apparaat moet geïnstalleerd worden met een
door
AGB goedgekeurde
).
ofwel met een flexibele leiding in
.
afsluiter.
REFERENCE TO LOCAL
REGULATIONS
GB
Provision for ventilation
The room in which the appliance is installed must
have an air supply to current
standards.
All rooms require a permanent vent in addition to
the openable window.
If there are other fuel burning appliances in the same
room
B.S. 5440 - Part 2
determine the air vent requirements.
If the appliance is installed in a cellar or basement, it
is advisable to provide an air vent of 65 cm,
irrespective of the room volume.
B.S. 5440 - Part 2
should be consulted to
RAPPELS SUR LES NORMES DE
SÉCURITE EN VIGUEUR DANS
LE PAYS D’INSTALLATION
FR
L’installation et la maintenance de l’appareil doivent
être effectuées par un technicien qualifié qui travaille
en conformité avec les réglementations en vigueur,
et tout particulièrement :
- Décret du 2 août 1977
Règles techniques et de sécurité applicables aux
installations fonctionnant au gaz et au gaz
d’hydrocarbures liquéfiés situées à l’intérieur
d’immeubles résidentiels et des dépendances.
REGULATIONS: ENGLISH
VERSION FOR BE REGULATION
BE
The appliance is supplied with a 1/2” threaded conical
end to be connected to the gas supply (according to ISO
regulations
The connection must be effected in accordance with
standard
accordance with specifications sheet
using flexible tubing.
The appliance must be installed complete with an
AGB-approved
ISO 7/1 RP 1/2
NBN D 51-003
stop valve.
).
using rigid piping or in
A.R.G.B./03
Gas Safety Regulations
The law requires that all gas appliances are installed
by competent persons in accordance with the
current gas safety regulations. Failure to install
appliances correctly may lead to prosecution.
It is in your own interest, and that of safety, to ensure
that the law is complied with. The hob should be
installed in accordance with the
(Installation and Use) Regulations,
Regulations
Environment and the
(Scotland) (Consolidation) Regulations,
by the Scottish Development Department.
In the G.B.,
safe standards of practice.
issued by the Department of the
Building Standard
CORGI
registered installers work to
Gas Safety
the
Building
issued
REFERENCE TO LOCAL
REGULATIONS: ENGLISH
VERSION FOR FR
REGULATION
FR
The installation and maintenance of the appliance
must be carried out by a qualified skilled technician
in accordance with the regulations in force, and in
particular:
- Decree of 2 August 1977
Technical and Safety Rules applicable to fuel gas and
liquefied hydrocarbon installations located within
residential buildings and outbuildings.
5019 619 61831/B 5019 619 61831/B
- Standard DTU P 45 - 204
Installations au gaz (anciennement DTU no. 61-1 Installations au gaz avril 1982 + supplément no. 1
de juillet 1984).
- Réglementations du ministère de la santé.
Pour les appareils raccordés à l’alimentation
électrique principale.
- Standard NF C 15-100
Installations électriques basse tension - Standards.
- Standard DTU P 45 - 204
Gas installations (formerly DTU no. 61-1 - Gas
installations April 1982 + supplement no. 1
of July 1984).
- Departmental Health Regulations
For appliances connected to the mains electricity
supply.
- Standard NF C 15-100
Low-voltage electrical installations - Standards.
NATIONALER
NORMENBEZUG
DE
Gas-Sicherheitsbestimmungen
Es ist vorgeschrieben, dass alle Gasgeräte nur durch
konzessionierte Gasinstallateure installiert und
angeschlossen werden. Die Installation muss
entsprechend den
Gasinstallation) sowie den
Flüssiggas) erfolgen.
Die Folgen von fehlerhaften Installationen der Geräte
können strafrechtlich geahndet werden.
In ihrem eigenen Interesse und zu ihrer eigenen
Sicherheit sollten Sie für die Einhaltung dieser
Vorschrift Sorge tragen.
(Technische Regeln
TRGI
(Technische Regeln
TRF
REFERENCIA A LA
NORMATIVA LOCAL
ES
Las instalaciones de gas para cocinas domesticas
deberan atenerse a las
INSTALACIONES DE GAS EN EDIFICIOS
HABITADOS,
fecha 30 de Marzo de 1974.
NORMAS DE
publicadas en el
B.O.E. N° 77
de
REFERENCE TO LOCAL
REGULATIONS: ENGLISH
VERSION FOR DE REGULATION
DE
It is law that all gas appliances are installed and
connected to the gas supply by authorised
technicians. The installation must be performed in
accordance with the
gas connection) and/or
liquid gas).
Failure to install appliances correctly could lead to
prosecution. It is in your own interest, and that of
safety, to ensure that the law is complied with.
(technical regulations for
TRGI
(technical regulations for
TRF
REFERENCE TO LOCAL
REGULATIONS: ENGLISH
VERSION FOR ES REGULATION
ES
Gas installations for household cookers must comply
with the
INSTALLATIONS IN INHABITED
BUILDINGS,
State Gazette) No. 77
REGULATIONS ON GAS
published in the
B.O.E. (Official
, of March 30, 1974.
REFERENTIES LOKALE
VOORSCHRIFTEN
NL
De installatie moet worden uitgevoerd volgens de norm
NBN D 51-003
5019 619 61831/B
.
REFERENCE TO LOCAL
REGULATIONS: ENGLISH
VERSION FOR NL REGULATION
NL
Installation must be performed in accordance with
standard
NBN D 51-003
.