Whirlpool AFE 954/G, AFG 510/H, GTC 1101 PRODUCT SHEET
1
2
4
Controls
PRODUCT DESCRIPTION SHEET
Lid handle.
1.
Lock.
2.
Seal.
3.
5
3
6
Defrost water drain plug
4.
(depending on model).
Control panel.
5.
Basket (depending on model).
6.
GB
1. Thermostat
2. Red LED
1
1 2 3
1 2 3 4 5
The exact configuration of the controls may vary according to the model.
Notes:
For correct operation of the appliance and to allow the lid to open freely without damage,
leave at least 7 cm clearance at the sides and rear.
After installation, wait for at least two hours without moving the appliance before connecting
it to the power supply.
If the freezer is left empty for short periods, it is preferable not to switch it off.
Frost formation on the upper edges and interior walls of the appliance is a natural
phenomenon and will not affect the performance of the freezer.
temperature is not sufficiently low.
3. Green LED:
is on.
4. Yellow LED
function is active.
5. Fast Freeze button
fast freeze function.
: Temperature adjustment.
: Indicates that the freezer
Illuminates when the appliance
: Indicates that the fast freeze
: Press to activate the
D F NL E P GRGB I
S N FIN
DK
PRODUCT DESCRIPTION SHEET
Switching on the freezer for the first time
There is no need to set the freezer temperature on the thermostat because the appliance is factory
•
set for the recommended temperature of -18°C.
Plug in the appliance.
•
The green LED will illuminate.
•
Also the red LED will switch on because the temperature inside the freezer is not yet sufficiently
•
low for food storage. The red LED will normally switch off within the first six hours after the
appliance is switched on.
Place food inside the freezer only when the red LED has switched off.
•
It will prove difficult to open the lid immediately after closing it because the hermetic seal means
•
there is a partial vacuum inside the freezer. Wait a few minutes before re-opening the lid.
After connecting the freezer to the power supply make sure the fast freeze button is not
pressed.
Temperature adjustment
You can adjust freezer temperature as follows:
Turn the thermostat knob
•
Turn the thermostat knob
•
When the freezer is only partially full, it is advisable to set the thermostat to lower positions
•
(towards position “E”, if indicated on the thermostat scale).
to position 1 to set the
①
to position 6 / to set the
①
highest (least cold)
lowest (coldest)
storage temperature.
storage temperature.
Energy saving tips
Do not install the appliance in places exposed to direct sunlight or near heat sources.
•
Do not obstruct the ventilation grille or the air circulation openings.
•
Remove accumulated dust from the rear of the appliance at least once a year.
•
Use the thermostat to select the ideal storage temperature.
•
Never place hot foods in the freezer.
•
Restrict the number of times you open the lid.
•
Make sure the ice layer does not build up to more than 5-6 mm thick.
•
Changing the lid light bulb
Unplug the appliance.
•
Remove the diffuser by following the sequence
•
of steps shown in the figure.
Unscrew the light bulb and replace it with an
•
identical bulb of the same wattage and voltage.
Refit the diffuser and plug in the appliance.
•
2
3
1
5019 100 42002/A
D F NL E P GRGB I
S N FIN
DK
Printed in Italy 05/98
Loading...