Whirlpool ADP 972/3 WHM INSTRUCTION FOR USE
GB
ADP 972
Rinse aid level indicator
Add rinse aid.
Salt level indicator
Add regeneration salt; only add
regeneration salt immediately before
starting a wash programme.
Programme progress indicator
Pre-rinse/ Pre-wash
Washing
Drying
Programme end
Programme Symbol
and Temperature
Pre-wash
Further indications are given in the pages to follow and in the user instructions.
Half Load / Multizone button
Load the upper
This function can be used with any programme.
press once = upper rack (the indicator lamp comes on)
press twice = lower rack (the indicator lamp comes on)
press 3 times = Off (half load function deactivated).
Delayed start button
The wash cycle can be programmed to start after
3-6-9 hours. Then press the Start button.
The dishwasher will start at the set time.
Programme selection and
recommended load type
Crockery to be washed later.
Quick Reference Guide
Options
lower rack
or
only
.
Place the detergent in the:
small
compartment
- - 5.0 (4.2) 0.02 (0.02) 9 (9)
Start button
Indicator lamp lit while the dishwasher
is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
Programme selector
large
compartment
Normal load / (Half load / Multizone)
Water
(Litres)
Consumption
Energy
(kWh)
1)
Time
(Min.)
Glasses 40° C
Rapid 40° C
Eco 50° C
Universal 65° C
Normal 65° C
Intensive 70° C
1) Values may vary in relation to usage, e.g.: different loads, water
temperatures (above or below 15° C), water hardness and power supply voltage, etc.
2) Programme recommended when using detergents of type B (enzyme-based detergents).
Reference programme for energy label.
3) Programme recommended when using detergents of type A (non enzyme-based detergents).
2)
3)
Light soiling, especially glasses and cups.
Lightly soiled crockery with no dried-on food.
Normally or heavily soiled crockery with dried-on food.
Normally soiled crockery.
Heavily soiled crockery.
Heavily soiled pans and saucepans.
- X 12.5 (10.5) 0.82 (0.78) 60 (59)
- X 13.0 (13.0) 0.85 (0.75) 30 (30)
X X 16.0 (14.2) 1.40 (1.30) 86 (83)
- X 13.0 (11.0) 1.45 (1.38) 73 (71)
X X 20.0 (17.0) 1.63 (1.55) 98 (90)
X X 21.5 (19.2) 1.70 (1.60) 93 (90)
5019 100 91235
(We reserve the right to make technical modifications)
B
C
How to use the dishwasher
1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. The dishwasher switches on
automatically as soon as the
programme selector knob is turned.
One of the programme indicator
lamps will switch on.
3. Turn the selector knob to select the
desired programme.
indicator lamp lights up.
select options (if supplied).
4. Press the Start button to start the
selected wash programme.
corresponding indicator lamp
switches on.
programmed data cannot be altered by
turning the programme selector knob.
once the Start button has been
Note:
pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, press the Start button
for about 5 seconds,
indicator lamp switches off.
Select a new programme using the
programme selector knob and
press the Start button.
If the dishwasher is switched off
Note:
during a wash programme, when
switched on again the dishwasher
resumes the wash cycle from where it
was interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
5. To indicate the end of the programme,
steam.
the Start indicator lamp switches off
and
the End indicator lamp (if fitted)
switches on
The corresponding
Once set, the
(for about 30 min.)
If required,
The
until the Start
.
6. Turn the programme selector knob to
the “initial” position to switch off the
dishwasher (only after the Start
indicator lamp has switched off).
the indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
All
Upper rack
B
Half load / Multizone:
If the upper rack
the cutlery basket (B) on the upper rack.
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.
• To lower: pull out the
handles and gently lower the rack.
is to be loaded, place
only
two
side
Upper and lower rack
• To raise: pull up the
until the rack clicks into place.
• The rack must be level on both sides.
Crockery holders:
• Down: cups and long-stemmed glasses.
•
Up: plates.
“Flex 3” multi-purpose support:
• To be used, for example, for longhandled utensils
with the blade facing downwards),
cups and glasses.
• May be used in three different
positions (see also “Dishwasher
loading instructions” on Page 4).
1. Upon the left-hand sid e of the rack.
2. Upside-down, to wards the centre of
the rack.
3. Upside-down, towards the left side.
Glass holder:
side handles
two
(arrange knives
Lower rack
A
A
C
Half load / Multizone:
Loading the lower rack
greater washing power, especially for
plates and saucepans.
Plate holders:
•(A) may be lowered to increase
available space.
Cutlery basket:
The cutlery basket can be removed
to increase (
• It can be placed on the upper
rack (B) when the Half load/
Multizone function is selected.
) available space.
B+C
only
gives
Please read the user instructions carefully.
Loading...