Whirlpool ADP 9621/2 WH INSTRUCTION FOR USE
GB
ADP 9621
Rinse aid level indicator
Add rinse aid.
Salt level indicator
Add regeneration salt; only add regeneration salt
immediately before starting a wash programme.
Programme progress indicator
Pre-rinse / Pre-wash
Washing
Drying
Programme end
Programme Symbol
and Temperature
Quick Reference Guide
Further indications are given in the pages to follow and in the user instructions.
Option
Delayed start button
The wash cycle can be programmed to start after 3-6-9
hours. Then press the Start button.
The wash programme will start at the set time.
Place the detergent in the:
small large
Programme selection and
recommended load type
compartment compartment
Start button
Indicator lamp lit while the dishwasher
is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
Programme selector
Consumption
1)
Normal load
Water
(Litres)
Energy
(kWh)
Time
(Min.)
Pre-wash
Glasses 40° C
Rapid 50° C
Eco 50° C
Universal 65° C
Intensive 70° C
1) Values may vary in relation to usage, e.g.: different loads, water
temperatures - above or below 15° C - water hardness and power supply voltage.
2) Reference programme for Test Institute and energy-label.
2)
Crockery to be washed later.
Light soiling, especially glasses and cups.
Lightly soiled crockery with no dried-on food.
Normally or heavily soiled crockery with dried-on food.
Normally soiled crockery.
Heavily soiled pans and saucepans.
--5.00.029
- X 12.5 0.82 60
- X 12.5 0.90 65
X X 16.0 1.40 86
- X 14.0 1.50 73
X X 21.5 1.70 93
5019 100 91233
(We reserve the right to make technical modifications)
C
C
How to use the dishwasher
1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. The dishwasher switches on
automatically as soon as the
programme selector knob is turned.
One of the programme indicator
lamps will switch on.
3. Turn the selector knob to select the
desired programme.
indicator lamp lights up.
select options (if supplied).
4. Press the Start button to start the
selected programme.
corresponding indicator lamp
switches on.
programmed data cannot be altered by
turning the programme selector knob.
once the Start button has been
Note:
pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the programme
selected, press the Start button for
about 5 seconds. The Start
indicator lamp will switch off. Select
a new programme using the
programme selector knob and
press the Start button.
if the dishwasher is switched off
Note:
during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and
the End indicator lamp (if fitted)
lights up
(about 30 min.)
The corresponding
If required,
The
Once set, the
.
6. Turn the programme selector knob to
the initial position to switch off the
dishwasher (only after the Start
indicator lamp has switched off).
All the indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
Upper rack
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.
• To lower: pull out the
handles and gently lower the rack.
• To raise: pull up the
until the rack clicks into place.
• The rack must be level on both
sides.
two
side handles
two
side
Please read the user instructions carefully.
Upper and lower rack
Crockery holders:
• Down: cups and long-stemmed glasses.
•
Up: plates.
“Flex 3”: multi-purpose support
• To be used, for example, for longhandled utensils
with the blade facing downwards),
cups and glasses.
• May be used in three different
positions (see also “Dishwasher
loading instructions” on Page 4).
1. Upon the left-hand side of the rack.
2. Upside-down, towards the centre of
the rack.
3. Upside-down, towards the left side.
Glass holder:
(arrange knives
Lower rack
Cutlery basket (C):
• With or without handle (depending
on model).
• The cutlery basket can be removed
to increase available space.
Loading...