Whirlpool ADP 8656 IXM INSTRUCTION FOR USE
GB
ADP 8656
Programme selector
Start button
Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
Half Load Button - Upper rack
Half Load Button - Lower rack
Load the upper or lower rack
This function can be used with any programme.
Press once = upper rack (the indicator lamp comes on).
Press twice = lower rack (the indicator lamp comes on).
Press 3 times = Off (half load function deactivated).
Programme Symbol
and Temperature
Options
Quick Reference Guide
Further indications are given in the pages to follow and in the user instructions.
Options
Delayed start button
The wash cycle can be programmed to start
after 3-6-9 hours.
Then press the Start button.
The dishwasher will start at the
set time.
Rinse aid level indicator
Add rinse aid.
Salt level indicator
.
only
Programme selection and
recommended load type
Add regeneration salt; only add regeneration salt
immediately before starting a wash programme.
small compartment large compartment
Place the detergent in the:
Programme progress indicator
Pre-rinse / Pre-wash
Washing
Drying
Programme end
Consumption
1)
Normal Load /
(Half Load / Multizone)
Water
(Litres)
Energy
(kWh)
Time
(Min.)
Pre-wash
Rapid 40° C
Bio 50° C2)
Routine 50° C
Normal 65° C
Intensive 70° C
1) Values may vary in relation to usage, e.g.: different loads, water temperatures (above or below 15° C),
water hardness and power supply voltage, etc.
2) Programme recommended when using detergents of type B (enzyme-based d etergents). Re ference programme for en ergy label.
3) Programme recommended when using detergents of type A (non enzyme-based detergents).
Crockery to be washed later.
Lightly soiled crockery with no dried-on food.
Normally soiled crockery.
2)
Normally soiled crockery, with dried-on food.
3)
Normally or heavily soiled crockery.
Heavily soiled pans and saucepans.
- - 5.0 (4.2) 0.02 (0.02) 9(9)
- X 13.0 (13.0) 0.85 (0.75) 30 (30)
- X 12.5 (10.5) 1.30 (1.20) 73 (71)
X X 16.0 (14.5) 1.24 (1.05) 135 (128)
X X 16.0 (14.0) 1.60 (1.40) 86 (83)
X X 21.0 (18.0) 1.90 (1.65) 110 (105)
5019 100 91370
(We reserve the right to make technical modifications)
A
A
C
B
C
D
How to use the dishwasher
1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. The dishwasher switches on
automatically as soon as the programme
selector knob is turned. One of the
programme indicator lamps will
switch on.
3. Turn the selector knob to select the
desired programme. The
corresponding indicator lamp lights
up. If required, select options
(if supplied).
4. Press the Start button to start the
selected programme. The Start
indicator lamp will light up. Once set,
the programmed data cannot be
altered by turning the programme
selector knob.
once the Start button has been
Note:
pressed, the dishwasher memorises
the last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the programme
selected, press the Start button for
about 5 seconds. The Start
indicator lamp will switch off.
Select a new programme and
press the Start button.
if the dishwasher is switched off
Note:
during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and the End indicator lamp (if fitted)
lights up (for about 30 min.).
6. Once the Start indicator lamp has
switched off, turn the programme
selector knob to the initial position to
switch off the dishwasher. All the
indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
Upper rack
B
Half load / Multizone:
If the upper rack only is to be loaded, place
the cutlery basket (B) in the upper rack.
Rack height adjustment:
(The dishwasher is delivered with the
upper rack in the top position).
The rack height can also be changed
when loaded.
• To lower: pull out the two side
handles and gently lower the rack.
Please read the user instructions carefully.
Upper and lower rack
• To raise: pull up the two side handles
until the rack clicks into place.
• The rack must be level on both
sides.
Crockery holders:
• Down:
cups and long-stemmed glasses.
•
Up: plates.
Glass holder:
Lower rack
Half load / Multizone:
Loading the lower rack only gives
greater washing power, especially for
plates and saucepans.
Plate holders:
•(A) may be lowered to increase
available space.
A
Cutlery basket:
The cutlery basket (B+C) can be
removed to increase available space.
• It can be placed on the upper rack (B)
when the Half load/Multizone function is
selected.
• Some models are provided with a grid (D)
that can be fitted onto the cutlery basket.
Loading...