Whirlpool ADP 6950 IX, ADP 6950 WH PROGRAM CHART

Quick reference guide

Chart

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY

READ THIS QUICK REFERENCE GUIDE AND THE INSTALLATION

INSTRUCTIONS!

Options and display description

FAULT INDICATION AND WASH TIME DISPLAY

In normal operation it indicates the remaining time (h:mm), whereas with “Delayed start” selected it

ON/OFF

PROGRAMME

RESET BUTTON

START BUTTON

indicates the time remaining until programme start (hh) and below 1h (0:mm).

If “F..” appears on the display, see chapter “What to do if...”.

BUTTON

SELECTION BUTTON

For programme change or indication of faults.

The indicator lights up

Press button “Program”

Press and hold for 3 sec. this button to cancel a started

during operation, and

(repeatedly) until the required

programme and selected extra options. Press this button to

goes off at the end of the

indicator of programme lights

cancel the main fault indicators “F..” also refer to the chapter

programme.

DELAY

RINSE AID

KEYBOARD

up (see “Table of

“What to do if...”. The programme can then be selected and

SALT

INDICATOR

INDICATOR

LOCK

programmes” below).

started.

INDICATOR

When lit, the time

When lit, the rinse

INDICATOR

(see at right for options

selection and

aid dispenser

When lit, the

When lit, the salt

reservoir needs to

description)

delay start

needs to be

keyboard lock

be refilled.

countdown.

refilled.

option is

activated.

Table of programmes

Detergent

Consumption

P

Programmes

Available

Loading instructions

Litres

Kwh

Minutes 1)

options

DELAYED START

POWER CLEAN

BUTTON

Thanks to the

Normally or heavily soiled crockery, including

Press the button

additional power jets

1

Delay

pots and pans. Thanks to steam action, soaking

(repeatedly) to delay the

this option provides

Aqua Steam

40-70°C

Multizone

or hand pre-treatment is no longer needed. In

X

7-17

0.99-1.75

65-220

start of the programme.

a more intensive and

Power Clean

addition hygiene is ensured due to the high

Adjustable from 1 to 24

powerful wash in the

temperature steam.

hours. With each press of

SET THE

lower rack, in the

the button, the delayed start

specific area.This

2

Pre-Wash

cold

Delay

indicator increases by one

DETERGENT

MULTIZONE

option is

Multizone

Crockery to be washed later.

—

4.0

0.03

14

hour and after 24 resets

Press to select

Allows you to choose

recommended for

from 0. Then press the Start

tablets. If not

the washing zones.

washing pots and

button. The dishwasher will

selected then

Press this button

casseroles (see

3

Glasses

40°C

Delay

Light soiling, for example glasses and cups.

X

10.0

0.85

100

start after the set time.

powder is a

(repeatedly) to select

page 4). Press this

Multizone

default detergent.

the wash zones:

button to activate

Power Clean (the

4

Quickwash

40°C

Delay

Lightly soiled crockery, with no dried-on food.

both racks

indicator lights up).

X *

10.0

0.65

30

Multizone

* Not recommended tablets use.

KEYBOARD LOCK

5

Eco 2)

Delay

This option allows you to lock the buttons on the

only lower

50°C

Multizone

Normally soiled crockery.

X

11.0

0.98

150

control panel. Children will not be able to

rack

Power Clean

accidentally start the dishwasher by pressing the

buttons on the control panel when this option is

only upper

Normally or heavily soiled crockery, with

Delay

selected. If you want to activate or deactivate this

6

additional antibacterial wash. Programme

rack

Antibacterial

3)

Multizone

X

13.0

1.50

115

option hold down the Multi Zone button for three

interruption (e.g. due to door opening) can

Power Clean

(3) seconds. “Keyboard lock indicator” will flash

compromise elimination of germs.

during activation and acoustic signal will confirm

7

Overnight

55°C

Delay

Normally soiled crockery, gentle and quiet

X

13.0

1.20

290

activation. Deactivation is done in the same way.

Multizone

thanks to the lower spray pressure (39dbA).

1)Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary

depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system.

2)Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

3)The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001. ADP 6950 5019 396 01718

GB -1-

How to set water hardness in order to always assure the best cleaning results

First time use

1- salt reservoir

2- rinse aid dispenser

3- detergent dispenser

4- racks system

5,6,7,8- available functions on the panel

9- filters

10spray arms

* only before the first wash or if the water hardness has been changed

Switch on the appliance

-Select the 2nd programme “P2” - consult the table in the Programme Chart.

-Press the START button for at least 5 seconds until the START indicator lamp flashes.

-The water hardness setting is shown on the display (if present) or the START button flashes.

-With each successive touch of the START button the setting increases and when it reaches 7 it returns to 1 again.

-The appliance must be switched off to memorise the new setting.

	1. Ask your water supply company what the water hardness is...			2. ...enter this value	Suggestions for detergent use
				on your
				dishwasher
	French		Water	Insert value is shown	Gel or Powder	Tablets
	degrees °fH		hardness	in the display	(rinse aid and salt)
	0	- 9	Soft	1
	10	- 18	Medium	2
	19	- 27	Average	3		if extra salt is
	28	- 37	Medium-hard	4	go to step 1	needed go to
					(see “Daily check”)	step 1
	38	- 50	Hard	5		(see “Daily check”)
	51	- 63	Very hard	6
	64 - 107		Extremely hard	7

Water hardness level is factory set for medium hard water (a number “4” is shown on the display).

Even if you use tablets which include salt, you must still add salt since such detergents are not effective enough at softening hard water.

Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!)

Daily check

1	Visual indicator	Visual indicator
	(depending	(depending on
	on model).	model). Screw
		on the cap. Salt
		residues around
		cap need to be
		removed.

Fill the salt reservoir	Add salt
with water before the	(never add detergent!).
first wash only.	min. 1.5 kg
	max. 2 kg

	The salt level indicator lamp may remain lit for the Salt indicator (depending on the model)
	duration of several wash cycles. If the water	The indicator lamp on the control panel lights up	orange: OK.	clear: NEEDS TO
	hardness level falls within category (soft), no salt is			BE ADDED

required.	when SALT NEEDS TO BE ADDED.

GB -2-

Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator

Daily check

	2	Visual	Add rinse aid
			to max.
		indicator B
			line ~100 ml

If required, open the cover (press lever).

The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). Press the lever to open the cover. Using a coin or similar object, turn the arrow to the desired setting. After adjusting the rinse aid setting, shut the cover again.

Rinse aid indicator (depending on model)	The indicator lamp on the control panel lights up when RINSE AID NEEDS		dark: OK.		clear: NEEDS TO BE ADDED
	TO BE ADDED.

Only use rinse aids recommended for use in domestic dishwashers. Immediately wipe away any rinse aid spilt accidentally. This prevents the formation of excess suds which can cause a fault function of the appliance.

If there are streaks: reduce the dosage by turning the dial to a lower setting (1-3). If crockery is not perfectly dry: increase the dosage by turning the dial to a higher setting (5-6). Plastic dishes have more difficulty drying and a higher rinse aid setting will not improve the situation.

Detergents with rinse aid incorporated may be effective only with longer programmes. In the case of shorter programmes, detergent residue may be a problem (if necessary, use powder detergent). Detergents with rinse aid incorporated tend to form excess suds.

Adding detergent - Use only detergent specifically for dishwashers in accordance with the supplier’s recommendations.

Daily use

	3		Tablet / gel / powder
		Only fill the	Use one tablet per one cycle, only placed in
	Open the cover A
	(press lever).	detergent dispenser	detergent dispenser.
		prior to starting a	All types of tablets can be used, but for 2 in 1
		wash programme.
			type adding of salt is mandatory.

GB -3-