Whirlpool ADP 6837, GKN365 SHOCK A WS, GKN365 SHOCK A PT, GKNE 1870 A NF INSTRUCTION FOR USE

1. Control panel

2. Ice packs (inside - if proved for)

3. "Shock Freeze" compartment

(if present)

4. Rating plate (at side of drawer)

5. Freezing compartment

6. Zone for drawers and pull-out

baskets

Storage zone
Freezing zone

Note: The design of drawers and
accessories may vary, depending on
the model.

FINDKNPENLFGBD SGRI

PRODUCT SHEET

GB

A. Green Intelligence. "Green Intelligence"

activation indicator (see enclosed instructions).

B. On/Standby. Standby button. Press for at least

3 seconds to activate it. Press the icon once to
reactivate the keypad.

C. Temperature. Set temperature indicator.
D. Temperature. Temperature setting button
E. Fast Freeze. Fast Freeze function on indicator.

The Fast Freeze function switches off
automatically after 48 hours.

F. Eco night. Press to activate/deactivate the Eco

Night function (Nighttime Rate).(see the
specific section).

G. Key Lock. Key Lock activated indicator.

H. Stop alarm. Press in case of alarm. Press for 3

seconds to activate/deactivate the Key Lock.
When activated, pressing the other icons
activates an audible signal.

I. Black-out alarm. Long Black-out Alarm

indicator.(See the section "alarm signaling").

J. Shock Freeze/Fast Freeze. Press to switch

on and activate the Shock Freeze function (if
available-see enclosed instructions). The
function switches off automatically after about
4-5 hours. If the Shock Freeze is available,
pressing for 3 seconds activates the Fast Freeze
function (see enclosed instructions). If the
Shock Freeze is not available, just press once.

CONTROL PANEL

A

B

C

D

E

ABCDE

1

2

5

3

6

4

FGHI JFGHI J

FINDKNSGRIPENLFGBD

Freezer inside temperature adjustment

The appliance is normally factory-set for operation at the recommended temperature of -18°C.
The inside temperature setting can be adjusted between -16°C and -24°C, proceeding as follows:

• Press the inside temperature adjustment button D. The storage temperature can be changed by -1°C
with each press of the button: the value flashes cyclically between -16°C and -24°C.

• The Green Intelligence function is activated automatically in case of opening of doors and the
introduction of small amounts of food to be frozen. Its duration is variable and depends on the product
load conditions and the outside temperature. It does not require any intervention by the user and
switches off automatically when normal operating conditions are restored.

The Eco Night function enables appliance energy consumption to be concentrated in the reduced rate
hours (generally at night), when electricity is readily available and costs less than during the daytime (only
in countries that utilise a time based multi-rate system - check energy rates with the local electricity
company).
To activate the function, press the button F at the reduced rate start time (depending on the specific rates
plan). For example, if the reduced rate starts at 8 p.m., press the button F at that time. When the Eco
Night LED is ON, the function is on.
Once the function is activated, the appliance automatically adapts energy consumption according to the
time selected, i.e. consuming less energy during the day than at night.

IMPORTANT: To operate properly, the function must be on during the night and day.
The function remains on until deactivated (or it is deactivated in case of a power failure or appliance
switch-off). To deactivate the function, press the button F again. When the Eco Night LED is OFF, the
function is off.

Note: The declared appliance energy consumption refers to operation with the Eco Night function
deactivated.

ECO NIGHT FUNCTION (NIGHTTIME RATE)

This optional function can be used to save energy. To activate the Eco mode, press the buttons F and J
together for 3 seconds until an audible signal sounds. Two seconds after activation of the Eco mode, the
display goes off, except the "Green Intelligence" icon (and the audible signal is deactivated, if on). To
adjust the temperature or use other functions, it is necessary to activate the display by pressing any
button. After about 15 seconds without performing any action, the display goes off again and only the
Green Intelligence icon remains visible. To deactivate this function, press the buttons F and J together for 3
seconds until an audible signal sounds. The normal display is restored. The Eco mode is automatically
disabled after a power failure or a fault alarm. Remember that this function does not disconnect the
appliance from the power supply.

ECO MODE