Quick reference guide |
|
|
|
Chart |
|
|
|
|
|
|
|
|
|
|
PROGRAM SELECTION BUTTON
Push “Programs” button (repeatedly) until the indicator of the required program lights up (see “Table of programs” below).
START/RESUME BUTTON
Push this button to start the selected program: the indicator lights up and goes off at theendof the program. When the door is opened during a washing cycle, the cycle is temporarily paused: the Start indicator blinks. To resume the cycle close the door and push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel. If pressed when a program is running it cancels the program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see page 6 - chapter ”What to do if ...”.
|
Table of programs |
|
Consumption |
|
||||
|
|
|
|
Deter- |
|
|
|
Drying |
P |
Programs |
|
Loading instructions |
gent |
Litres |
kWh |
Minutes 1) |
Phase |
|
|
|
||||||
|
|
|
|
|
|
|
|
|
1 |
Rapid |
40°C |
Lightly soiled crockery, with no |
X |
13.0 |
0.70 |
30 |
NO |
|
|
|
dried-on food. |
|
|
|
|
|
2 |
Eco 2) |
50°C |
Normally soiled crockery. |
X |
15.0 |
1.15 |
165 |
Full |
Energy-saving program. |
||||||||
|
|
|
|
|
|
|
|
|
3 |
Daily |
60°C |
Normally to heavily soiled |
X |
16.0 |
1.35 |
120 |
Full |
|
|
|
crockery. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4 |
Intensive |
65°C |
Recommended program for |
|
|
|
|
|
heavily soiled crockery, especially |
X |
15.0 |
1.50 |
140 |
Full |
|||
|
|
|
suitable for pans and saucepans. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
5 |
Half Load |
50°C |
Ideal for washing a half load of |
X |
13.0 |
1.00 |
130 |
Full |
|
|
|
lightly or normally soiled crockery. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1)Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2)Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
Whirlpool is a registered trademark of Whirlpool USA
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
5019 396 03587
GB -1-
How to set water hardness in order to always assure the best cleaning results |
|
First time use |
||
Water hardness should be set only |
|
|
||
- |
Press and hold together Programs and CANCEL/Off buttons for minimum 3 seconds. |
|
||
before the first wash or if water |
- |
Programs LEDs will indicate the water hardness setting. |
||
hardness has been changed |
||||
|
|
|
-Press the Programs button to increase setting (when the level reaches 7, the next key press will set the level back to 1.
Water hardness level is factory set |
- Wait 30 seconds (control panel switches off) or press START/Resume button to save setting. |
for medium-hard water (level 4). |
|
|
|
|
|
1. |
Ask your water supply company what the water hardness is... |
2. |
...enter this value on |
Suggestions for detergent use |
|||||||
|
|
Even if you use tablets which |
|
|
|
|
|
|
|
your dishwasher |
|
|||
|
|
|
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
|
|
3 first PROGRAM LEDs |
|
|
|||
|
|
include salt functionality, you must |
|
German |
French |
English |
Water hardness |
|
Gel or Powder |
|
||||
|
|
still add regeneration salt since such |
|
|
lit on the panel |
(rinse aid and |
Tablets |
|||||||
|
|
degrees °dH |
degrees °fH |
degrees °eH |
level |
|
(see table of programs) |
|||||||
|
|
detergents are not effective enough |
|
salt) |
|
|||||||||
|
|
|
|
|
|
|
|
|
P1 |
P2 |
P3 |
|
||
|
|
at softening hard water. |
|
|
|
|
|
|
|
|
|
|||
|
|
|
0 - 5 |
0 |
- 9 |
0 - 6.3 |
Soft |
1 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||||||
|
|
At first time use, the salt |
|
6 - 10 |
10 |
- 18 |
7 - 12.6 |
Medium |
2 |
|
|
|
|
|
|
|
reservoir has to be filled |
|
11 - 15 |
19 |
- 27 |
13.3 - 18.9 |
Average |
3 |
|
|
|
|
|
|
|
independently from water |
|
|
|
|
go to step 1 |
|
||||||
10 |
|
|
|
|
|
|
|
|
|
|
|
|
||
|
hardness level (see |
|
16 - 21 |
28 |
- 37 |
19.6 - 25.9 |
Medium-hard |
4 |
|
|
|
(see “Daily |
if water is |
|
9 |
4 |
description below in step 1 |
|
22 - 28 |
38 |
- 50 |
26.6 - 35 |
Hard |
5 |
|
|
|
check”) |
HARD extra salt |
“Daily check”). |
|
|
|
|
|
needs to be |
||||||||
|
|
29 - 35 |
51 |
- 63 |
35.7 - 44.1 |
Very hard |
6 |
|
|
|
|
added |
||
|
|
|
|
|
|
|
|
|||||||
1 |
|
|
|
|
|
|
|
(go to step 1, |
||||||
|
|
|
36 - 50 |
64 |
- 90 |
44.8 - 62.4 |
Extremely hard |
7 |
|
|
|
|
||
|
|
|
|
|
|
|
“Daily check”) |
|||||||
|
|
|
|
|
|
|
|
|||||||
|
|
Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!) |
|
|
|
Daily check |
|
|
|
1 |
Visual indicator |
Screw on the cap. |
|
|
|
(depending |
Salt residual |
|
3 |
|
2 |
on the model). |
around the cap |
|
|
|
Unscrew cap. |
need to be |
||
|
|
|
|
|
removed. Some |
|
|
|
|
|
salt reservoir have |
|
|
|
|
|
a level indicator |
|
|
|
|
|
integrated in the |
5 |
6 |
7 |
8 |
|
cap (see below |
|
how to check). |
|
|
|
|
|
Fill the salt reservoir with water |
|
Add salt (never add detergent!) |
||
|
before the first wash only. |
|
min. 0.8 kg / max. 1 kg |
1- salt reservoir |
Once regeneration salt is added, immediately start a wash program (the “Pre-wash” program alone is not sufficient). Residual saline solution or grains of salt can |
||||
2- rinse aid dispenser |
|||||
lead to deep-down corrosion, irreparably damaging the stainless steel components. The guarantee is not applicable if faults are caused by such circumstances. |
|||||
3- detergent dispenser |
|||||
|
|
|
|
||
4- racks system |
|
(depending on the model) |
|
|
|
5,6,7,8- available functions on the panel |
|
|
|
||
The salt level indicator lamp may remain lit |
Salt indicator on the control panel |
Salt indicator on the salt reservoir cap |
|||
9- filters |
|||||
at the end of several wash cycles. If the |
The indicator lamp lights up when SALT |
|
clear: NEEDS TO |
||
10spray arms |
|
||||
water hardness level falls within category |
green: OK. |
||||
|
(soft), no salt is required. |
NEEDS TO BE ADDED. |
|
BE ADDED |
|
|
|
|
|
GB -2-
Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator |
Daily check |
2 |
Visual |
|
indicator |
If required, open the cover B (press the dedicated button).
(depending on the model)
Add rinse aid to the max. line ~150 ml
The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4).
Press the button to open the cover B. Using a coin or similar object, turn the arrow to the desired setting. After adjusting the rinse aid setting, shut the cover again.
Check the rinse aid indicator to check the level |
Rinse aid indicator on the control panel |
Rinse aid indicator on the dispenser |
|
into the dispenser. |
The indicator lamp lights up when RINSE AID NEEDS |
dark: OK. |
clear: NEEDS TO BE ADDED |
|
TO BE ADDED. |
||
|
|
|
|
|
|
|
|
Only use rinse aids recommended for use in domestic dishwashers. Immediately wipe away any rinse aid spilt accidentally. This prevents the formation of excess suds which can cause a fault function of the appliance.
If there are streaks: reduce the dosage by turning the dial to a lower setting (1-3). If crockery is not perfectly dry: increase the dosage by turning the dial to a higher setting (5-6). Plastic dishes have more difficulty drying and a higher rinse aid setting will not improve the situation.
Detergents with rinse aid incorporated may be effective only with longer programs. In the case of shorter programs, detergent residue may be a problem (if necessary, use powder detergent). Detergents with rinse aid incorporated tend to form excess suds.
Adding detergent - Use only detergent specifically for dishwashers in accordance with the supplier’s recommendations |
|
Daily use |
|
|
|
||
Open the cover A |
Insert detergent: Tablet / powder / liquid into the big chamber |
|
Shut the cover |
(press the dedicated button). |
Please look for the recommendation of the detergent manufacturer on the |
by pressing dedicated ribs. |
|
3 |
packaging of the detergent product. |
Use only one tablet per one cycle, only |
|
|
|
||
Only fill the |
placed in detergent dispenser. |
|
|
|
|
||
detergent dispenser |
All types of tablets can be used, but for |
|
|
|
prior to starting a |
|
|
|
2 in 1 type adding of salt is mandatory. |
|
|
|
wash program. |
|
|
|
|
|
|
|
|
Some type of tablets could not dissolve |
|
|
|
completely during the short programs |
|
|
|
(Rapid, Rapid, Handwash); placing the |
|
|
|
tablet on the tub bottom can help |
|
|
|
dissolving and washing. |
|
GB -3-