Whirlpool ADP 2966/1 WHM PROGRAM CHART

GB ADP 2966

Quick Reference Guide

6th SENSE: Optimum wash results coupled with maximum energy savings

The two sensor-controlled programmes are recommended for routine washes. They use double sensor technology designed to ensure optimum wash results with minimum water and energy consumption.

Further indications are given in the pages to follow and in the user instructions.

Programme selector

Options

Rinse aid level indicator

Delayed start button

Add rinse aid.

Start button

The wash cycle can be programmed to

Salt level indicator

start after 1 - 24 hours.

Add regeneration salt; only add regeneration

Indicator lamp lit while the dishwasher is operating.

Then press the Start button.

salt immediately before starting a wash

Flashes when a fault occurs.

The dishwasher will start at the

programme.

Switches off at the end of the programme.

set time.

Programme progress indicator

Options

Half load / Multizone button

Pre-rinse / Pre-wash

Load the upper or lower rack only.

Washing

This function can be used with any programme.

Drying

Press once = upper rack (the indicator lamp comes on)

Press twice = lower rack (the indicator lamp comes on)

Programme end

Press 3 times = Off (half load function deactivated).

Place the detergent in the:

Consumption 1)

Programme Symbol

Programme selection and

small

large

Normal Load / (Half Load / Multizone)

compartment compartment

and Temperature

recommended load type

Water

Energy

Time

(Litres)

(kWh)

(Min.)

Normal 40 - 55° C

Recommended programme for routine washes, for crockery

(13.5)

(1.3)

(80)

with little or no dried-on food.

(11.5)

(0.9)

(60)

Intensive 60 - 70° C

Recommended programme for heavily soiled crockery, with

(19.5)

(1.7)

(98)

dried-on food. Especially suitable for pans and saucepans.

(11.5)

(1.3)

(90)

Pre-wash

Crockery to be washed later.

5.0

(4.2)

0.02

(0.02)

(9)

Rapid 40° C

Lightly soiled crockery with no dried-on food.

13.0

(13.0)

0.85

(0.75)

(30)

Glasses 40° C

Light soiling, especially glasses and cups.

12.5

(10.5)

0.82

(0.78)

(59)

Standard 50° C 2)

Normally or heavily soiled crockery with dried-on food.

16.0

(14.5)

1.03

(0.90)

120

(117)

1)	Values may vary in relation to usage, e.g.: different loads,	5019 100 91297
	water temperatures - above or below 15° C - as well as water hardness and power supply voltage etc.	5019 100 91297
2)	Reference programme for Test Institute and energy-label.	(We reserve the right to make technical modifications)

How to use the dishwasher

Upper and lower rack

1.After loading the dishwasher, close the door properly and open the water supply tap.

2.The dishwasher switches on automatically as soon as the programme selector knob is turned. One of the programme indicator lamps will switch on.

3.Turn the selector knob to select the desired programme. The corresponding indicator lamp lights up. If required, select options (if supplied).

4.Press the Start button to start the selected programme. The Start indicator lamp will light up. Once set, the programmed data cannot be altered by turning the programme selector knob.

Note: once the Start button has been pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply.

To change the selected

programme, press the Start button for about 5 seconds. The Start indicator lamp will switch off. Select a new programme and press the Start button.

Note: if the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.

Only open the dishwasher door if strictly necessary during a wash

cycle and exercise maximum caution. Danger of scalding from steam.

5.To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (for about 30 min.).

6.Once the Start indicator lamp has switched off, turn the programme selector knob to the initial position to switch off the dishwasher. All the indicator lamps switch off.

7.Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap.

Upper rack

Half load / Multizone:

If the upper rack only is to be loaded, place the cutlery basket (B) in the upper rack.

Rack height adjustment:

(The dishwasher is delivered with the upper rack in the top position).

The rack height can also be changed when loaded.

•To lower: pull out the two side handles and gently lower the rack.

•To raise: pull up the two side handles until the rack clicks into place.

•	The rack must be level on both sides.	Lower rack
Crockery holders:		A
• Down: cups and long-stemmed
•	glasses.	A
	Up: plates.

“Flex 3”: multi-purpose support

•To be used, for example, for longhandled utensils (arrange knives with the blade facing downwards), cups and glasses.

•May be used in three different positions (see also “Dishwasher loading instructions” on Page 4).

1.Upon the left-hand side of the rack.

2.Upside-down, towards the centre of the rack.

3.Upside-down, towards the left side.

Glass holder:

Half load / Multizone:

Loading the lower rack only gives greater washing power, especially for plates and saucepans.

Plate holders:

•(A) may be lowered to increase available space.

Cutlery basket:

The cutlery basket can be removed to increase (B + C) available space.

•It can be placed on the upper rack (B) when the Half load/Multizone function is selected.

•Some models are provided with a grid (D) that can be fitted onto the cutlery basket.

B	D

Please read the user instructions carefully.

+ 2 hidden pages