Whirlpool ADP 2756 WHM INSTRUCTION FOR USE
GB
ADP 2756
Programme selector
Start button
Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
Delayed start button
The wash cycle can be programmed to start after
3-6-9 hours. Then press the Start button.
The wash programme will start at the set time.
Programme Symbol
and Temperature
Option
Quick Reference Guide
Further indications are given in the pages to follow and in the user instructions.
Salt level indicator
Add regeneration salt; only add regeneration salt
immediately before starting a wash programme.
Half Load / Multizone button
Load the upper or lower rack
This function can be used with any
programme.
press once = upper rack (the indicator lamp comes on)
press twice = lower rack (the indicator lamp comes on)
press 3 times = Off (half load function deactivated).
Programme selection and
recommended load type
Place the detergent in the:
small compartment large compartment
only.
Programme progress indicator
Pre-rinse / Pre-wash
Washing
Drying
Programme end
Consumption
Normal Load /
(Half load / Multizone)
Water
(Litres)
Energy
(kWh)
1)
Time
(Min.)
Pre-wash
Rapid 30’
Delicate 40° C
Eco 50° C
2)
Daily 65° C
Daily plus 65° C
Intensive 70° C
1) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below
15° C - as well as water hardness and power supply voltage.
2) Programme recommended when using detergents of type B (enzyme-based detergents).
Reference programme for energy label.
3) Programme recommended when using detergents of type A (non enzyme-based detergents).
Crockery to be washed later.
Lightly soiled crockery with no dried-on food.
Light soiling, especially glasses and cups.
Normally or heavily soiled crockery with dried-on food.
Normally soiled crockery.
3)
Normally or heavily soiled crockery.
Heavily soiled pans and saucepans.
- - 5.0 (4.2) 0.02 (0.02) 9(9)
- X 13.0 (13.0) 0.85 (0.75) 30 (30)
- X 12.5 (10.5) 0.82 (0.78) 60 (59)
X X 16.0 (14.5) 1.26 (1.05) 133 (125)
- X 13.0 (11.0) 1.45 (1.38) 73 (71)
X X 16.0 (14.0) 1.60 (1.40) 86 (83)
X X 21.5 (18.2) 1.70 (1.60) 93 (90)
5019 100 91329
(We reserve the right to make technical modifications)
A
A
C
B
C
D
How to use the dishwasher
1. After loading the dishwasher, close
the door properly and open the water
supply tap.
2. The dishwasher switches on
automatically as soon as the
programme selector knob is turned.
One of the programme indicator
lamps will switch on.
3. Turn the selector knob to select the
desired programme.
indicator lamp lights up.
select options (if supplied).
4. Press the Start button to start the
selected programme.
indicator lamp will light up.
the programmed data cannot be alte red
by turning the programme selector knob.
once the Start button has been
Note:
pressed, the dishwasher memorises
the last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, press the Start
button for about 5 seconds.
The Start indicator lamp will switch
off. Select a new programme and
press the Start button.
If the dishwasher is switched
Note:
off during a wash programme,
when switched on again it will resume
the wash cycle from where it was
interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and
the End indicator lamp (if fitted)
lights up (for about 30 min.).
The corresponding
If required,
The Start
Once set,
6. Once the Start indicator lamp has
switched off, turn the programme
selector knob to the initial position
to switch off the dishwasher.
indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
All the
Upper rack
B
Half load / Multizone:
If the upper rack
the cutlery basket (B) in the upper rack.
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be chan ged
when loaded.
• To lower: pull out the
handles and gently lower the rack.
is to be loaded, place
only
side
two
Please read the user instructions carefully.
Upper and lower rack
• To raise: pull up the
until the rack clicks into place.
• The rack must be level on both
sides.
Crockery holders:
• Down: cups and long-stemmed glasses.
•
Up: plates.
“Flex 3”: multi-purpose support
• To be used, for example, for longhandled utensils
with the blade facing downwards),
cups and glasses.
• May be used in three different
positions (see also “Dishwasher
loading instructions” on Page 4).
1. Upon the left-hand side of the rack.
2. Upside-down, towards the centre of
the rack.
3. Upside-down, towards the left side.
Glass holder:
side handles
two
(arrange knives
Lower rack
Half load / Multizone:
Loading the lower rack
washing power, especially for plates and
saucepans.
Plate holders:
•(A) may be lowered to increase
available space.
gives greater
only
Cutlery basket:
The cutlery basket can be removed to
increase (
• It can be placed on the upper rack (B)
when the Half load/Multizone function
is selected.
• Some models are pro vided with a
grid (D) that can be fitted onto the
cutlery basket.
) available space.
B+C
Loading...