Whirlpool ADP 2442 WH INSTRUCTION FOR USE

ADP 2442

Quick Reference Guide

Further indications are give n in the pages to follow and in the user instructions.

Programme selector

Start button

Indicator lamp lit while the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Programme Symbol

and Temperature

Pre-wash

Rapid 40° C

Bio-Eco 50° C

Normal 65° C

1) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15° C - as well as water hardness and power supply voltage.

2) Programme recommended when using detergents of type B (enzyme-based detergents). Reference programme for energy label.

3) Programme recommended when using detergents of type A (non enzyme-based detergents).

Crockery to be washed later.

Lightly soiled crockery with no dried-on food.

Normally or heavily soiled crockery with dried-on food.

Normally soiled crockery.

Programme selection and

recommended load type

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt; only add regeneration salt immediately before starting a wash programme.

Place the detergent in the:

small large

compartment compartment

- - 5.0 0.02 9

- X 13.0 0.85 30

X X 16.0 1.25 133

X X 16.0 1.55 86

Water

(Litres)

Consumption

Normal load

Energy

(kWh)

5019 100 91328

(We reserve the right to make technical modifications)

Time

(Min.)

How to use the dishwasher

1. After loading the dishwasher, cl ose the door properly and open the water supply tap.

2. The dishwasher switches on automatically as soon as the programme selector knob is turned.

One of the programme indicator lamps will switch on.

3. Turn the selector knob to select the desired programme.

indicator lamp lights up.

select options (if supplied).

4. Press the Start button to start the selected programme.

indicator lamp will light up.

the programmed data cannot be altered by turning the programme selector knob.

once the Start button has been

Note:

pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply.

To change the selected programme, press the Start button for about 5 seconds

Start indicator lamp switches

Select a new programme and

off.

press the Start button.

if the dishwasher is switched off

Note:

during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.

Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. Danger of scalding from steam.

5. To indicate the end of the programme, the Start indicator lamp switches off and

the End indicator lamp (if fitted)

lights up

(for about 30 min.)

The corresponding

If required,

The Start

Once set,

, until the

6. Once the Start indicator lamp has switched off, turn the programme selector knob to the initial position to switch off the dishwasher.

indicator lamps switch off.

7. Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap.

All the

Upper rack

Rack height adjustment:

(The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded.

• To lower: pull out the handles and gently lower the rack.

• To raise: pull up the until the rack clicks into place.

side

two

side handles

two

Please read the user instructions carefully.

Upper and lower rack

• The rack must be level on both sides.

Crockery holders:

• Down: cups and long-stemmed glasses.

•

Up: plates.

Glass holder:

Lower rack

Plate holders:

•(A) may be lowered to increase available space.

Cutlery basket:

• The cutlery basket can be removed to

increase (C) available space.

• Some models are provided with a grid (D) that can be fitted onto the cutlery basket.

+ 2 hidden pages