Whirlpool ADP 2440 AL INSTRUCTION FOR USE

GB

ADP 2440

Further indications are given in the pages to follow and in the user instructions.

Programme selector

Start button

Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.

Quick Reference Guide

Programme Symbol

and Temperature

Pre-wash

Rapid 30’

Eco 50° C

Daily plus 65° C

1) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below
15° C - as well as water hardness and power supply voltage.

2) Programme recommended when using detergents of type B (enzyme-based detergents).
Reference programme for energy label.

3) Programme recommended when using detergents of type A (non enzyme-based detergents).

2)

Crockery to be washed later.

Lightly soiled crockery with no dried-on food.

Normally or heavily soiled crockery with dried-on food.

3)

Normally soiled crockery.

Programme selection and

recommended load type

small compartment large compartment

Place the detergent in the:

- - 8.0 0.02 12

- X 15.0 0.85 31

X X 19.0 1.40 87

X X 19.0 1.60 87

(We reserve the right to make technical modifications)

Consumption

Water

(Litres)

Normal load

Energy

(kWh)

1)

Time

(Min.)

5019 100 91331

C

How to use the dishwasher

1. After loading the dishwasher, close
the door properly and open the water
supply tap.

2. The dishwasher switches on
automatically as soon as the
programme selector knob is turned.

One of the programme indicator
lamps will switch on.

3. Turn the selector knob to select the
desired programme.

The corresponding indicator lamp
lights up.

(if supplied).

4. Press the Start button to start the
selected programme.

indicator lamp will light up.

Once set, the programmed data
cannot be altered by turning the
programme selector knob.

Note:

pressed, the dishwasher memorises
the last programme selected. This
information remains in the memory even
during interruption of the power supply.

off during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.

5. To indicate the end of the programme,
the Start indicator lamp switches off
and

lights up (for about 30 min.).

If required, select options

The Start

once the Start button has been

To change the programme
selected, press the Start button
for about 5 seconds. The Start
indicator lamp will switch off.
Select a new programme and
press the Start button.

if the dishwasher is switched

Note:

Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.

the End indicator lamp (if fitted)

6. Once the Start indicator lamp has
switched off, turn the programme
selector knob to the initial position to
switch off the dishwasher.

indicator lamps switch off.

7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.

All the

Upper rack

Rack height adjustment:

(The dishwasher is delivered with the
upper rack in the top position).
The rack height can also be chan ged
when loaded.

Upper and lower rack

• To lower: pull out the
handles and gently lower the rack.

• To raise: pull up the
until the rack clicks into place.

• The rack must be level on both
sides.

Crockery holders:

• Down: cups and long-stemmed
glasses.

•

Up: plates.

Glass holder:

two

side handles

two

side

Lower rack

C

Cutlery basket (C):

• With or without handle (depending
on model).

• The cutlery basket can be removed
to increase available space.

Please read the user instructions carefully.