Whirlpool ADL 836 WH, ADL 833/2 WH, ADL 853/2 WH INSTRUCTION FOR USE
SUMMARY GB
BEFORE USING THE DISHWASHER
PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
ENERGY AND WATER SAVING TIPS
HOW TO FILL THE SALT CONTAINER
HOW TO FILL THE RINSE AID DISPENSER
HOW TO FILL THE DETERGENT DISPENSER
CONNECTIONS
MAINTENANCE AND CLEANING
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
4
4
4
4
5
6
6
7
9
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
For maximum satisfaction from your dishwasher, carefully read these user
instructions, consult the wash programme chart and the loading guide.
PAGE
PAGE
10
10
3
BEFORE USING THE DISHWASHER
After unpacking, make sure the appliance is
•
undamaged and that the door closes
correctly. Do not use the appliance if it is
damaged. If in doubt, consult your local
retailer.
Keep potentially hazardous packaging
•
(plastic bags etc.) out of the reach of children.
PROTECTING THE ENVIRONMENT
1. Packing
The packing box may be fully recycled as
confirmed by the recycling symbol .
PRECAUTIONS AND GENERAL RECOMMENDATIONS
Child safety
Do not allow children to play with the
•
dishwasher.
Store the detergent, rinse aid and salt in a dry
•
place out of the reach of children.
General recommendations
Only use detergents, rinse aids and
•
regeneration salts (not applicable for
Australia) specially recommended for use in
domestic dishwashers.
On completion of the wash programme
•
switch off the dishwasher and turn off the
water tap.
Before cleaning or carrying out maintenance,
•
switch off the appliance, disconnect the
mains plug and turn off the water tap.
If a fault occurs, switch off the appliance and
•
turn off the water tap.
The open dishwasher door can only support
•
the weight of the loaded rack when pulled
out. Do not rest objects on the open door or
sit or stand on it since the appliance may
topple over.
This appliance is designed for use in the
•
home in compliance with its intended
purpose.
All water and electrical connections must be
•
carried out by a qualified technician in
compliance with the manufacturer’s
instructions (refer to the enclosed installation
booklet) and current local safety regulations.
2. Appliance
The appliance is built from reusable
materials.
If you decide to scrap the dishwasher, it
must be disposed of in compliance with local
waste disposal laws. Before scrapping, cut
off the power cable so that the appliance
cannot be connected to the mains.
If necessary, the power cable may be
•
replaced with one the same obtained from
our After-Sales Service. The power cable
must only be replaced by a qualified
technician.
• For appliances with water-stop system:
The water inlet hose and plastic casing
contain electrical components. Do not
therefore cut the hose or immerse the plastic
casing in water. If the hose is damaged
switch off the appliance immediately.
Do not use solvents inside the dishwasher:
•
risk of explosion!
Load capacity: -12 place settings
•
EC Declaration of Conformity
This appliance has been designed,
constructed and distributed in compliance
with the safety requirements of
EC Directives:
73/23/EC
•
89/336/EC
•
93/68/EC.
•
ENERGY AND WATER SAVING TIPS
Do not rinse crockery under running water.
•
Always fully load the dishwasher before
•
switching on.
4
If ecological energy sources are available
•
such as solar panel heating, heat pumps or
centralised heating systems, the appliance
may be connected to the hot water mains up
to a maximum temperature of 60° C.
Make sure the water inlet hose is of the
correct type. Refer to the “Connections”
chapter in these user instructions.
HOW TO FILL THE SALT CONTAINER
(Not applicable for Australia).
Check the water hardness level in your
area. Consult your local Water Board or
check your last water bill.
• If the water hardness level exceeds
category 1, before using the dishwasher
for the first time, fill the salt container and
run a wash cycle so that any excess
saline solution discharged is immediately
removed by the water to prevent
corrosion. The pre-rinse cycle is not
sufficient for this purpose.
• Check the salt level regularly.
• Important: Only use regeneration salts
recommended for use in domestic
dishwashers.
Do not fill the salt container with
detergent as this will cause irreparable
damage to the water softener system.
To fill the salt container:
1.
Remove the lower rack.
2.
Unscrew the cap by turning it counter-clockwise.
3.
If the dishwasher is new, fill the salt container
to the rim with water.
4.
Fill the container to the rim with salt
(max. 2 kg) and stir with a spoon handle.
5.
Screw the cap back on by turning it
clockwise.
Salt level indicator
The green float is clearly visible in the cap
window when the salt container is full. The green
float lowers and is no longer visible when the salt
container is empty.
5
Loading...