Whirlpool ADG 944/3 WH, ADG 944/3 IX, ADG 944/3 AV, ADG 944/3 NB INSTRUCTION FOR USE

GB

PROGRAMME CHART

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Programme progress indicator

Prewash

Only lights up for programmes with pre-wash (the symbol “+” in the table below indicates that detergent must be added).

Rinsing/Washing

Drying

End Programme end

Start button indicator lamp

Switches on when the dishwasher is operating. Flashes when a fault occurs.

Switches off at the end of the programme.

 

 

Detergent

Consumption *

 

 

 

Programme

 

Normal load

 

 

 

 

Load

 

 

 

 

 

 

Symbol and

 

 

 

 

 

 

 

 

 

Crockery and cutlery

Pre-wash

Washing

Water

Energy

 

Time

 

 

 

temperature

 

 

 

 

 

(small

(large

 

 

 

 

 

 

(Litres)

(kWh)

 

(Min.)

 

 

 

 

 

compartment)

compartment)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Prewash

Crockery to be washed later.

-

-

5.0

0.02

 

9

-

-

-

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Rapid 40° C

Lightly soiled crockery with no dried-on food.

-

+

13.0

0.85

 

30

-

-

-

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Universal 65° C

Normally soiled crockery.

-

+

14.0

1.50

 

73

-

-

-

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Normal 65°C 1)

Normally or heavily soiled crockery.

+

+

20.0

1.63

 

98

-

-

-

*) Values for normal conditions. Values may vary in relation to usage, e.g different loads, water temperatures, water hardness and power supply voltage.

1) Reference programme for Test Institute and energy label.

5019 100 91163

 

(We reserve the right to make technical modifications)

Whirlpool ADG 944/3 WH, ADG 944/3 IX, ADG 944/3 AV, ADG 944/3 NB INSTRUCTION FOR USE

Daily check list

1. Arrange crockery so that items do not touch each other.

2. Load cups at an inclination to facilitate water circulation.

3. In general, place the cutlery in the basket with the handles positioned downwards, but ensure that sharp knives and forks that might cause injury are placed in the basket with

the handles positioned upwards.

4. Make sure the water jet can reach all loaded items and that the spray

arms rotate freely.

5. Turn on the water supply tap before starting the dishwasher.

Important

Switch off the dishwasher once the

“Start” indicator lamp has switched off. If you switch off the dishwasher during a wash cycle, when switched on again the dishwasher resumes the cycle from where it was interrupted.

• If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off! Refer to the “Troubleshooting Guide” in these user instructions to remedy any problems.

• If a regeneration salt is to be added, IMMEDIATELY start a washing programme, in order to eliminate any residual salt.

Sometimes even when the

regeneration salt container is full, the corresponding indicator lamp may illuminate during the first wash cycle.

Quick Reference Guide

Upper rack

Crockery holder:

Lowered: cups and longstemmed glasses.

• Positioned vertically: plates.

Height adjustment:

(The dishwasher is delivered with the upper rack in the top position).

The rack height can also be changed when loaded.

• To lower: pull out the two side handles and gently lower the rack.

• To raise: pull up the two side handles until the rack clicks into place.

• The rack must be level on both sides.

GB

Lower rack

Cutlery basket:

Can be removed to increase available space.

Plate holders:

The plate holders may be removed to increase available space.

To remove: pull the handle up.

To reposition: simply insert in the required position (normal or crosswise).

Loading...