Whirlpool ADG 934/3 IX, ADG 934/3 WH INSTRUCTION FOR USE

ADG 934

PROGRAMME CHART

Salt level indicator

Add regeneration salt.

Programme progress indicator Prewash

Only lights up for programmes with prewash (the symbol “+” in the table below indicates that detergent must be added).

Start button indicator lamp

Switches on when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Rinsing / Washing Drying

End

Programme end

Programme Symbol and

temperature

Prewash Rapid 40° C

Normal 65° C

*) Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, water temperatures, water hardness and power supply voltage.

Crockery to be washed later. Lightly soiled crockery with no dried-on food. Normally or heavily soiled crockery.

Load

Crockery and cutlery

Detergent

Pre-wash

(small

compartment)

--5.00.029---

- + 13.0 0.85 30 - - -

+ + 22.0 1.64 93 - - -

Pre-wash

(large

compartment)

Consumption *

Normal load

Water

Energy

(Liter)

(kWh)

Time

(Min.)

1) Reference programme for Test Institute and energy label.

(We reserve the right to make technical modifications)

5019 100 91111

Quick Reference Guide

Daily check list

1. Arrange crockery so that items do not touch each other.

2. Load cups at an inclination to facilitate water circulation.

3. In general, place the cutlery in the basket with the handles positioned downwards, but ensure that sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards.

4. Make sure the water je t can reach all loaded items and that the spray arms turn freely.

5. Turn on the water supply tap before starting the dishwasher.

Important:

• Switch off the dishwasher: once the “Start” indicator lamp has

switched off. If you switch off the dishwasher during a wash cycle, when switched on again the dishwasher resumes the cycle from where it was interrupted.

• If a fault occurs or you wish to change the current programme, press the “START” button fo r about 5 seconds until the Start indicator lamp switches off ! Refer to the “Troubleshooting Guide” in these user instructions to remedy any problems.

• If regeneration salt is to be added, IMMEDIATELY

start a washing programme, to eliminate any residual salt.

Crockery holders:

• Down: cups and long-stemmed glasses.

• Up: plates.

Upper rack

Height adjustment:

(The dishwasher is delivered with the upper rack in the top position).

The rack height can also be changed when loaded.

• To lower: pull out the two side handles and gently lower the rack.

• To raise: pull up the two side handles until the rack clicks into place.

• The rack must be level on both sides.

Lower rack

Cutlery basket:

The cutlery basket can be removed to increase available space.

Plate holders:

• The plate holders may be removed to increase available space.

• To remove: pull the handle up.

• To reposition: simply insert in the

required position (normal or crosswise).