Whirlpool ADG 934/1 WH, ADG 934/1 NB, ADG 934/1 AV, ADG 934/1 IX INSTRUCTION FOR USE

ADG 934

PROGRAMME CHART

Important:

• If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off ! Refer to the “Troubleshooting guide” in these user instructions to remedy any problems.

• Switch off the dishwasher once the “Start” indicator lamp has switched off. If you switch off the dishwasher during a wash cycle, when switched on again the dishwasher resumes the cycle from where it was interrupted.

Programme progress indicators

Start button indicator lamp:

Switches “on” when the dishwasher is

Pre-rinse

operating. Flashes when a fault occurs.

Washing

Switches “off” at the end of the programme.

Drying

Programme selector

0 = Off.

Programme

Symbol

Pre-rinse

Rapid 50 °C

Normal 65 °C 1)

Crockery to be washed later. - - Lightly soiled crockery with no dried-on food. 55 °C - + Normally or heavily soiled crockery. 65 °C + +

Programme end

Load

Crockery and cutlery

End

Final rinse

temperature:

Detergent dispenser:

+) with pre-rinse

-) without pre-rinse

** small

compartment

large

Consumption ***

Normal load

Water (Liter)

12.5 0.90 65

22.0 1.64 93

Energy

(kWh)

(Min.)

5.0 0.02 9

Time

50°

65°

Start

*) Recommended programme for use with “new generation” enzyme-based detergents. **) For pre-rinse. ***) Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, water temperatures, water hardness and power supply voltage.

1) Check the programme on the energy data plate.

5019 100 91058

Quick reference guide

Also refer to the "dishwasher loading instructions" which contain detailed information and useful tips.

Daily check list:

1. Turn on the tap.

2. Arrange crockery so that items do not touch each other.

3. Make sure the water jet can reach all loaded items and that the spray arms turn freely.

4. Fill the detergent dispenser and check the salt and rinse aid levels.

5. Close the dishwasher door.

Tips:

Crockery:

• Load crockery upside down on the racks.

Cutlery:

• The cutlery basket can be removed to increase available space.

• Place the cutlery unsorted in the cutlery basket with the handles positioned downwards.

• To avoid the risk of injury knives and forks placed in the basket

positioned upwards.

Cups:

• Load cups at an angle to facilitate water circulation.

Silver cutlery:

• Always hand wash silver cutlery immediately after use. Follow the detergent manufacturer's directions on the detergent pack.

, cutlery can also be

on sharp

with the handles

Important:

• Only load the appliance with dishwasher-proof crockery and cooking utensils.

• Certain wooden and aluminium articles may discolour.

• Glued, plastic utensils may be heat sensitive.

• Tin may become dull.

• Decorated crockery (unglazed) may

fade.

• Glasses may become dull.

Crockery holder:

• Down: cups and long-stemmed glasses.

• Up: plates.

Plate holders:

• The plate holders may be removed to increase available space.

• To remove, pull the handle up.

• To reposition, simply insert in the

required position (normal or crosswise).

Upper rack

Height adjustment:

(The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded.

• To lower: pull out the two side handles and gently lower the rack.

• To raise: pull up the two side handles until the rack clicks into place.

• The rack must be level on both sides.

Lower rack

Cutlery basket: the cutlery basket may be removed to increase available space.