Whirlpool ADG 6557 User Manual

ENGLISH	Instructions for use	Page 3
FRANÇAIS	Mode d’emploi	Page 12
		20
3

INSTRUCTIONS FOR USE

BEFORE USING THE DISHWASHER/CONNECTIONS ELECTRICAL CONNECTION

PRECAUTIONS AND GENERAL

RECOMMENDATIONS

HOW TO FILL THE SALT CONTAINER HOW TO FILL THE RINSE AID DISPENSER HOW TO FILL THE DETERGENT DISPENSER CARE AND MAINTENANCE

3

Observe any special regulations issued by your local Water Board.

Water supply pressure: 0,03 - 1,0 MPa.

Make sure the inlet and drain hoses are kink-free and are not crushed.

If the hose length is not sufficient, please contact your local dealer or our After-Sales Service. The inlet hose must be securely clamped to the water tap to prevent leaks.

The inlet water temperature varies according to the model installed. Inlet hose marked “25°C Max”: maximum temperature 25°C.

All other models: maximum temperature 60°C. When installing the appliance, make sure the drain water discharges correctly (if necessary, remove the wire gauze from the sink siphon).

Fix the drain hose to the spigot with a clamp to prevent it from coming off during operation.

For appliances with water-stop system only: If the water connections are made correctly, the waterstop system safeguards your home against damage caused by flooding.

BEFORE USING THE DISHWASHER/CONNECTIONS

1.Removing the packaging and controls:

After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer.

•Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.

•This dishwasher has been factory tested to ensure it functions correctly.

Such testing may leave slight water marks that will disappear with the first wash.

2.Water and electrical connections:

All water and electrical connections must be carried out by a qualified technician in compliance with the manufacturer's instructions (refer to the enclosed installation booklet) and current local safety regulations.

The appliance must only be used in the household for the prescribed uses.

Do not use the dishwasher if it has been damaged in transit. Consult your local retailer or our After-Sales Service.

(Refer to the separate installation instructions booklet)

3.Water inlet and drain:

•

•

•

•

4. Electrical connection:

•Closely adhere to local Electricity Board regulations.

•Voltage information is shown on the rating plate mounted inside the door on the right hand side.

•The appliance must be earthed as prescribed by law.

•Do not use extension leads or multiple adapters.

•Before carrying out maintenance, disconnect the mains plug.

•If necessary, the power cable may be replaced with one the same obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician.

Warning for models provided with LCD display:

The mains plug must be positioned in an easily accessible place.

•For Austria: if the apparatus is series connected to a fault current switch, this must be sensitive to the pulsating current.

EC Declaration of conformity

This appliance has been designed, constructed and distributed in compliance with the safety requirements of EC Directives:

•73/23/EEC

•89/336/EEC

•93/68/EEC

Load capacity:

12 place settings.

•

•

•

4