Whirlpool ADG 3966 IXM, ADP 242 S WH, ADG 3340 NB, ADP 2966 WHM, ADG 3756 IXM User Manual

...
GB CONTENTS
BEFORE USING THE DISHWASHER
PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
CONNECTIONS
HOW TO FILL THE RINSE AID DISPENSER
HOW TO FILL THE DETERGENT DISPENSER
CARE AND MAINTENANCE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
53
53
53
54
55
56
57
58
To make the most of your new dishwasher, please read these user instructions and the quick reference guide carefully.
52
BEFORE USING THE DISHWASHER
1. Removing the packaging and check
After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer.
Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.
PROTECTING THE ENVIRONMENT
1. Packing
The packing box may be fully recycled as confirmed by the recycling symbol .
2. Energy and water saving tips
Do not rinse crockery under running water.
Always fully load the dishwasher before
switching on or set the wash programme to half load (if available) if loaded.
rack only is
one
2. Water and electrical connections
All water and electrical connections must be
carried out by a qualified technician in compliance with the manufacturer's instructions (refer to the enclosed installation booklet) and current local safety regulations.
The appliance must only be used in the household for the prescribed uses.
If ecological energy sources are available,
such as solar panel heating, heat pumps or centralised heating systems, the appliance may be connected to the hot water mains up to a maximum temperature of 60° C. Make sure the water inlet hose is of the correct type. Refer to the chapter “Connections” in these user instructions.
3. Disposing of packaging and old machine
The appliance is built from reusable materials. If you decide to scrap the dishwasher, it must be disposed of in compliance with local waste disposal laws.
Before scrapping, cut off the power cable so that the appliance cannot be connected to the mains.
PRECAUTIONS AND GENERAL RECOMMENDATIONS
1. Child safety:
Children must not be allowed to play with the dishwasher.
Store the detergent, rinse aid and salt in a dry place out of the reach of children.
2. General recommendations:
The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it:
over!
Do not use solvents inside the dishwasher:
risk of explosion!
Only use detergents, rinse aids and regeneration salts specially recommended for use in domestic dishwashers.
Before cleaning or carrying out
maintenance, switch off the appliance and turn off the water tap.
If a fault occurs, switch off the appliance and
turn off the water tap.
the appliance may topple
If necessary, the power cable may be
replaced with one the same obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician.
On completion of the programme switch off
the dishwasher and turn off the water tap.
3. For appliances with water stop system:
The water inlet hose and plastic casing contain electrical components. Do not therefore cut the hose or immerse the plastic casing in water. If the hose is damaged switch off the appliance immediately.
EC Declaration of conformity
This appliance has been designed, constructed and distributed in compliance with the safety requirements of EC Directives:
73/23/EC
89/336/EC
93/68/EC
Load capacity: 12 place settings
.
53
CONNECTIONS
Do not use the dishwasher if it has been damaged in transit. Consult your local retailer or our After-Sales Service.
(Refer to the separate installation instructions booklet)
Water inlet and drain:
Observe any special regulations issued by your local Water Board.
Make sure the inlet and drain hoses are kink­free and are not crushed.
If the hose length is not sufficient, please contact your local dealer or our After-Sales Service.
The inlet hose must be securely screwed on to the water tap to prevent leaks.
The inlet water temperature varies according to the model installed: inlet hose marked “25° C Max: maximum temperature 25°C. All other models: maximum temperature 60° C.
When installing the appliance, make sure the drain water discharges correctly (if necessary, remove the plug from the sink spigot).
Fix the drain hose to the spigot with a clamp to prevent it from coming off during operation.
For appliances with water-stop system only: if the water connections are made correctly, the water-stop system safeguards your home against damage caused by flooding.
Electrical connection:
Closely adhere to local Electricity Board regulations.
Voltage information is shown on the rating plate mounted inside the door on the right hand side.
The appliance must be earthed as prescribed by law.
Do not use extension leads or multiple adapters.
Before carrying out maintenance, disconnect
the mains plug.
The power cable must only be replaced by a qualified technician.
54
Loading...
+ 4 hidden pages