WHIRLPOOL ACO450 User Manual

INSTRUCTIONS FOR USE

IMPORTANT SAFETY INSTRUCTIONS

• WARNING: to avoid a hazard due to instability, positioning or fixing of the
appliance must be done in accordance with the manufacturer instructions.

• WARNING: keep the appliance ventilation openings clear of obstruction.

• WARNING: do not damage the appliance refrigerant circuit pipes.

• WARNING: Do not use mechanical, electric or chemical means other than

those recommended by the Manufacturer to speed up the defrost process.

• WARNING: Do not use or place electrical devices inside the appliance
compartments if they are not of the type expressly authorised by the
Manufacturer.

• This appliance does not contain CFCs. The refrigerant circuit contains
R600a (HC) which is a natural gas without environmental impact, but is
flammable. Therefore, make sure the refrigerant circuit pipes are not
damaged. Keep special attention in case of damaged pipes emptying the
refrigerant circuit.

• C-Pentane is used as blowing agent in the insulation foam and it is a
flammable gas. Pay special attention during disposal operations.

• Your new appliance is for commercial use, and has been designed to deliver

outstanding performance and safe, efficient operation.

• Do not store explosive substances such as aerosol cans with a flammable
propellant in this appliance.

• This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved.

• Cleaning and user maintenance shall not be made by children without

supervision.

• To avoid the risk of children becoming trapped and suffocating, do not allow
them to play or hide inside the appliance.

• It must be possible to disconnect the appliance from the power supply by

unplugging it if plug is accessible, or by means of an accessible multi-pole
switch installed upstream of the socket in conformity with national safety
standards.

• Plug the appliance into a grounding socket: the appliance must be correctly

connected to an approved earthing system.

• Do not use single/multi adapters or extension cords.

• During installation, make sure the appliance does not damage the power

cable.

• Do not pull the appliance power cable

• The appliance must be handled and installed by two or more persons.

• Installation and maintenance including replacement of the supply cord must

be carried out by the manufacturer or a qualified technician, in compliance
with the manufacturer’s instructions and the local safety regulations in force.

In order to avoid a hazard do not repair or replace any part of the appliance

including the supply cord, unless specifically stated in the user manual.

SAFEGUARDING THE ENVIRONMENT

1. Packing

The packing material is 100% recyclable and bears the recycling symbol . For disposal, comply with the local
regulations. Keep the packing materials (plastic bags, polystyrene parts, etc.) out of the reach of children, as they are
a potential source of danger.

2. Scrapping/Disposal

The appliance is manufactured using recyclable material. This appliance is marked in compliance with European
Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring the correct disposal of this
appliance, you can help prevent potentially negative consequences for the environment and the health of persons.

The symbol on the appliance, or on the accompanying documents, indicates that this appliance should not be
treated as domestic waste but must be taken to a special collection centre for the recycling of electrical and electronic
equipment.
When scrapping the appliance, make it unusable by cutting off the power cable and removing the doors and shelves
so that children cannot easily climb inside and become trapped.
Scrap the appliance in compliance with local regulations on waste disposal, taking it to a special collection centre; do
not leave the appliance unattended even for a few days, since it is a potential source of danger for children.
For further information on the treatment, recovery and recycling of this product, contact your competent local office,
the household waste collection service or the shop where you purchased the appliance.

DECLARATION OF CONFORMITY

• This appliance has been designed for preserving food and is manufactured in compliance with Regulation (CE) No.
1935/2004.

• This appliance has been designed, manufactured and marketed in compliance with:

- safety objectives of the “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE and subsequent
amendments);

- the protection requirements of Directive “EMC” 2004/108/EC and also integrated with the safety principles of the
“Machinery” Directive 2006/42/EC of the European Parlament and of the Council of 17 May 2006.

• The appliance has a noise emission which do not exceed 70 dB(A).

BEFORE USING THE APPLIANCE

To ensure best use of your appliance, carefully read the operating instructions which contain a description
of the product and useful advice. Keep these instructions for future reference.

1. After unpacking the appliance, make sure it is not damaged and that the door closes properly. Any damage must
be reported to the dealer within 24 hours of delivery of the appliance.

2. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient.

3. Clean the inside of the appliance before using it.

PRECAUTIONS AND GENERAL RECOMMENDATIONS

INSTALLATION

• Be careful not to damage the floors (e.g. parquet) when moving the appliance.

• Make sure the appliance is not near a heat source.

• Install and level the appliance on a floor strong enough to take its weight and in a place suitable for its size and use.

• Install the appliance in a dry and well-ventilated place. The appliance is designed for operation in rooms with

temperature and humidity below the values indicated in the table, according to the climatic class given on the data
plate (Fig.7). The appliance may not work properly if left to operate for a prolonged period at a temperature and
humidity above the specified values.

• Make sure the voltage specified on the rating plate corresponds to that of your home.

SAFE USE

• Do not store or use petrol, flammable liquids or gas in the vicinity of this or other electrical appliances. The fumes
can cause fires or explosions.

• Do not swallow the contents (non-toxic) of the ice packs (in some models).

• Do not eat ice cubes or ice lollies immediately after taking them out of the freezer since they may cause cold burns.

• Before carrying out any maintenance or cleaning operation, unplug the appliance or disconnect it from the power

supply.

• Use the freezer compartment only for storing frozen food, freezing fresh food and making ice cubes.

• Do not store glass containers with liquids in the freezer compartment since they may break.

• Avoid storing unwrapped food in direct contact with internal surfaces of freezer compartments.

• “The bulb used inside the appliance is specifically designed for domestic appliances and is not suitable for general

room lighting within the home

(EC Regulation 244/2009)”.

• Maximum load per shelf 12Kg

• This appliance features “skin condenser” technology: the condensing unit is integrated into the walls of
the freezer. For this reason the side and front walls of the product may become hot while the product is
running. This is entirely normal and also reduces the risk of condensation forming in particularly critical
environmental conditions (see paragraph “Troubleshooting guide”).

The Manufacturer declines any liability for injury to persons or animals or damage to property if the above
advice and precautions are not respected.

ENERGY-SAVING TIPS

• Install the appliance in a dry, well ventilated room far away from any heat source (e.g. radiator, cooker, etc.) and in a
place not exposed directly to the sun. If required, use an insulating plate.

• To guarantee adequate ventilation follow installation instructions.

• Insufficient ventilation on back of the product increases energy consumption and decreases cooling efficiency.

• The internal temperatures of the appliance may be affected by the ambient temperature, frequency of door opening,

as well as location of the appliance. Temperature setting should take into consideration these factors.

• Allow warm food and drinks to cool down before placing in the appliance.

• After placing the food check if the door of compartments closes properly, especially the freezer door.

• Reduce to a minimum door opening.

• Damaged gasket must be replaced as soon as possible.

• High energy class products are fitted with high efficiency motors that remain operational for longer, but have a low

power consumption. Do not worry if the engine continues to run for longer periods.

APPLIANCE DIAGRAM (Fig. 1)

A. Handle.
B. Safety closure (if provided).
C. Seal.
D. Separator (if provided).
E. Defrost water drain plug.
F. Control panel.
G. Side motor ventilation grille.

CONTROL PANEL DIAGRAM (Fig. 2)

1. Red light: when blinking, it indicates an alarm condition (see the section “TROUBLESHOOTING GUIDE”).

2. Blue light: when on, it indicates that the STOP FROST function is activated (see the section “STOP FROST

FUNCTION”)

3. Green lights: they indicate that the product is working, the set temperature and possible activation of the quick

freeze function (“Shopping”).

4. Setting button: for updating the set temperature, activation/deactivation of the quick freeze function (“Shopping”)
and activation/deactivation of the “STOP FROST” function.

INSTALLATION

• Unpack the product.

• Remove the 4 spacers inserted between the lid and the product. (Fig. 3)

• Make sure the defrost water drain plug (if provided) is correctly positioned (E).

• For optimum operation and to avoid damage when the lid is opened, maintain a distance of at least 7 cm from the
front wall and 7 cm at the sides. (Fig. 4)

• Insert the accessories (if provided).

STARTING THE PRODUCT

• Connect the product to the power supply.

• The green light (“Normal”) comes on.

• The red light (1) blinks, since the temperature inside the product is not yet low enough for loading food. This light

normally goes off within six hours after startup.

• Place food inside only when the red light has gone off.

Note: If the STOP FROST function is deactivated, the lid cannot be immediately reopened after closing it, because
the seal is tight. It is necessary to wait a few minutes before reopening the lid.