Whirlpool 6LA932OXTWO User Manual

^ y ^
'WhirlDool
HomeAppliances
Use & Care Guide
SUPER CAPACITY TWO SPEED
AUTOMATIC WASHER
6LA9320XTWO
Cont ent s
Important Safety Instructions
Operating instructions
Starting your washer ................... 4
What happens in each cycle .. 5
Other Operating instructions
Rinse and spin .......................... 10
Extra rinse option....................... 10
Drain and spin Soak cycle
MAGIC CLEAN® lint filter .... 11
Liquid bleach dispenser Liquid fabric softener dispenser
if You Need Service Or Assistance Whirlpool Automatic Washer Warranty
©1990 Whirlpool Corporation
.......................
.......
...........................
.................................
.........
............................
........................
...........................
3
11
12
13
16
10 11
Thank you for buying a Whirlpool appliance. Please complete and mail the Owner Registration Card provided with this product. Then complete the form below. Have this information ready if you need service or call with a question.
• Copy model and serial numbers from plate (under lid near hinge) and the purchase date from the sales slip
• Keep this book, the Laundry Guide and the sales slip together in a handy place.
Model Number
Serial Number
Purchase Date
Service Company Phone Number
If your washer has a Consumer Buy Guide label, remove it. It will be easier to remove before the washer is used. To remove any remaining glue:
• Rub briskly with thumb to make a ball,
then remove. or
• Soak area with liquid hand dishwash
ing detergent before removing glue as described above.
Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners. These can damage the finish. See “Important Safety Instructions” on page 3.
Impo rta nt Saf ety Ins tru cti ons
Awarning
To reduce the risk of fire, electrical shock, or injury to persons when using your washer, fol low basic precautions, including the following:
• Read all instructions before
using the washer.
• NEVER wash items cleaned,
washed, soaked in or spotted with wax, paint, gasoline, or flammable fluids in the washer. The fumes can create a FIRE HAZARD or
EXPLOSION. ALWAYS hand
launder and air dry fabrics contain ing these materials.
• NEVER allow children to operate, play with, or crawl inside the washer. Close supervision of children is necessary when the washer is used near children.
• When discarding an old washer,
ALWAYS remove the lid to prevent accidental entrapment.
• NEVER put your hands Into the
washer until all motion stops. If the lid is opened while the basket is spinning, the basket will automati cally stop in a few seconds.
• DO NOT tamper with controls.
• NEVER use or store flammable
fluids (dry-cleaning solvents, kerosene) in or near your washer. DO NOT add flammable fluids to the wash water. These substances give off vapors that can create a
FIRE HAZARD or EXPLOSION.
- SAVE THESE INSTRUCTIONS -
• If hot water has not been used recently (usually 2 weeks or longer), hydrogen gases may build up in the water heater and the hot water pipes HYDROGEN GAS IS
EXPLOSIVE. To prevent injury or
damage, before using your washer, turn on all hot water faucets and allow water to run for several minutes. This will allow gases to escape. DO NOT smoke or use any open flame near the faucet while it is open.
• You are responsible for mak ing sure that your washer:
- is installed, repaired, and has
parts replaced by a qualified person.
- is properly installed and leveled on a floor that can support the weight.*
- is connected to the correct 3­prong outlet, electric supply, water supply and drain.*
- is properly grounded.*
- is properly maintained.*
- is protected from the weather and kept where the temperature will not fall below freezing.
*See the Installation Instructions.
Additional safety instructions and your responsibilities
• ALWAYS store detergent, laundry aids and other materials in a cool, dry place where children can’t reach them
- in a locked cabinet if possible.
• ALWAYS read and follow instructions on packages of detergent and laundry aids - especially warnings and precautions.
• HAZARDOUS FUMES can be formed if chlorine bleach is used in the same wash as ammonia or acids such as vinegar or rust remover.
• ALWAYS unplug the power supply cord before attempting to service the washer.
• DO NOT machine wash glass fiber materials. Small particles can stick to fabrics washed in following loads and cause skin irritation.
• You are responsible for making
sure that your washer:
- is used only for jobs normally ex
pected of home automatic washers.
- IS not run by children or anyone
unable to operate it properly. 3
Oper ati ng Ins tru cti ons
Starting your washer
Be sure to measure and add detergent, then place a sorted load in the washer before
starting it.
1. Select a load size
RESET
EX SMALL MEDIUM EX LARGE
INFINITE WATER SAVING
LOAD SIZE SELECTOR
• Position the Load Size Selector at the setting that describes the size of load you want to wash.
• The selector can be set anywhere on or between EX SMALL (a tew small items) and EX LARGE (a full load).
• To change the water level after the washer has started to fill, slide the selector to RESET, then to the desired water level.
NOTE; For best washing results, items should move freely in the washer. Do
not overload the washer or choose a
water level that is too low for your wash
load.
For best results with permanent press clothes, use the EX LARGE water level.
Reduce wash time when using EX
SMALL or SMALL water level settings.
Loads with only a few small items need less wash time for best results.
dicOyn. yÓÓcA
WARM COLD COLD COLD
□□□□
ENERGY SAVING
TEMPERATURE SELECTOR
----------
2. Touch a temperature selection
• Match the water temperature to the type of fabric and soils being washed.
• The top temperature is the wash selection and the bottom temperature is the rinse selection.
• An indicator shows which temperature has been selected.
NOTE: Use warm wash water with the
PERMANENT PRESS or KNITS
GENTLE Cycles.
For heavily soiled permanent press or knit clothes, pre-soak before washing in warm water.
ALWAYS use cold rinse water for permanent press fabrics.
3. Select cycle and wash time
Start the washer
• Push in the Cycle Control Knob and turn it clockwise.
• Stop when the indicator on the knob's outer ring points to the number in the wash cycle you want. The numbers are minutes of wash time.
• Start the washer by pulling out the Cycle Control Knob. The washer will fill to the selected water level with the selected wash water temperature. After filling, the washer will agitate for the selected number of minutes.
• To stop the washer at any time, push in the Cycle Control Knob. To restart the washer, pull out the Cycle Control Knob.
What happens in each cycle
Each cycle has different agitation and spin speeds designed for different kinds of fabrics.
Numbers on the dial In each cycle are
the minutes of wash agitation time.
When the Cycle Control Knob is set to a number and pulled out, the washer fills before agitation and timing starts. After agitation starts, the knob turns clockwise until it points to OFF and the cycle ends.
The washer will pause briefly throughout each cycle. These pauses are normal. They allow for the reversing of the motor, normal washer operation and the cool-down portion of the PERMANENT PRESS Cycle.
NOTE: You may hear the sound of
water spraying during the spin parts of some cycles. In some cycles, water is sprayed on the spinning load to help with the rinsing.
Gentle Wash System
For better fabric care in the REGULAR and PERMANENT PRESS Cycles, the agitation speed is reduced during the last few minutes of wash agitation time.
>iT-
i’
W-:L
Loading...
+ 11 hidden pages