Whirlpool 1.32E-13 User Manual

ELECTRIC

SELF CLEANING SET-IN UNIT

WITH CONVERTIBLETOP

-

­Part No. 13199991868842 Rev. A

FOR CUT-OUT DIMENSIONS
SEE FRONT AND
TOP VIEWS OF
CABINETS BELOW.

ELECTRIC SUPPLY JUNCTION BOX. LOCATE ON

FLOOR OR ON WALL NEAR FLOOR LINE, IN ADJOIN-

ING CABINETS.

CAUTION: To eliminate the hazard of reaching over

heated surface units, cabinet storage space located

above the surface units should be avoided. If cabinet
storage IS to be provided, the hazard can be reduced by

lnstalllng a range hood that projects horizontally a mini­mum of 5 inches beyond the bottom of the cabinet.

,-WALL LINE

I

-23” MIN.
CABINET ‘p

FRONT

/

_I

------

CABINET TOP

f

i--I

El:

/

0

1

22-518” /
TO
CABINET
FRONT

A

.--I

-- - TOP VIEW

1

- 29” -

OF COUNTER TOP

l-114” MAX.

-f
29”

314” MIN. -

I

FLOOR LINE

b

FRONT VIEW

FIGURE 1

“A” = 30” MIN. CLEARANCE BETWEEN TOP OF THE

COOKING PLATFORM AND THE BOTTOM OF AN
UNPROTECTED WOOD OR METAL CABINET.

“A” = 24” MIN. WHEN BOTTOM OF WOOD OR METAL

CABINET IS PROTECTED BY NOT LESS THAN

V4”

ASBESTOS MILLBOARD COVERED WITH

NOT LESS THAN NO. 28 MSG. SHEET STEEL,

0.015” STAINLESS STEEL, 0.024” ALUMINUM OR

0 020” COPPER

NOTES:

1. Product hangs from burner box flange over counter­top and is secured by four screws through front
frame into cabinets.
When product is installed in a countertop with a

2.
formed front edge, it may be necessary to “shave” it
to the flat area height of countertop and the width held
to the 30” dimension. (See sketch.)

1. GENERAL

The rnstallation must conform to any local codes. Remove
all cords, tape and wire used to hold various parts in

positron during transportatron.

2. CARPENTRY

Prepare the cutout space, shown in Figure 1. in the
desired location in the countertop and cabinet. Note
countertop to cabrnet face mounting dimension in Figure

2. Install 1” x 2” braces as shown in Figure 2 on both sides
of cutout to prevent any sag of countertop. All dimensions

In Figures 1 and 2 must be adhered to, and adjoining
cabinets must be plumb and level before attaching
countertop to cabinets.

COUNTER TOP (FORMED OR SQUARE EDGE)

NOTE: FIT BACK OF

COUNTER TOP TIGHT

\

TO WALL.

i” X 2” BRACE

ORAihcERw

FRONT

CABiNET

UNDERSIDE OF

SCREWED To

COUNTER TOP

FIGURE 2

(Contrnued)