Whirlpool 1163570 User Manual
IMPORTANT:
Read and save
Part No. 1163570 Rev. A
these instructions.
IMPORTANT:
Installer: Leave Installation Instructions
with the homeowner.
Homeowner: Keep Installation Instructions
for future reference.
Save Installation Instructions for local
electrical inspector’s use.
Air Conditioner
Proper installation is your responsibility.
Make sure you have everything
necessary for correct installation. It is
the customer’s responsibility to comply
with the installation specifications
provided.
9
/Electrical outlet
must be available
within the reach of
the P~~~;~s~PP~Y
\
supply cord is required
See Electrical requirements.
Important: Observe all
governing codes and
ordinances.
opening si2
re
Do Not use an
extension cord.
Tools
and
materials needed
for installation:
%
Parts supplied for installation:
-
2 screws
- gasket
-drain hose connector
Mounting Kit, Part No. 1158268 from
authorized parts distributor.
l
Check location where air
conditioner will be installed:
l
Correct opening size,
l
Adequate wall support for
weight of air conditioner,
l
An electrical outlet within
reach of power supply cord,
Electrical Shock Hazard
It is the customer’s responsibility: Electrical Code, ANSI/NFPA
l
To contact a qualified
electrical installer. local codes and ordinances.
. To assure that the electrical
installation is adequate and in
conformance with National
Personal Injury/Product Damage Hazard
l
Because of the weight and size falling out of opening during
of the air conditioner, more installation.
than one person is needed to
move, lift and safely install it.
l
Handle air conditioner with exposed to a heat source
care. Metal fins on front and that raises the surface
rear coils are sharp. temperature above 12O’F.
. Do Not drink the water that
collects inside the air
conditioner. It is not sanitary.
l
Maintain a firm hold on the air
conditioner to prevent it from
Copies of the standards listed may be obtained from:
‘National Fire Protecllon Association
Balierymarch Park
Quincy. Massachusetts 02269
Page 2
Free movement of air to
rooms to be cooled.
The opening dimensions must
have 24-7/8” width and a
15-l/4” height.
704atest edition”, and all
Failure to do so could result in
fire, electrical shock or other
personal injury.
l
Do Not locate air conditioner
where cabinet front is
Failure to follow these
instructions could result in
personal injury or damage to
air conditioner.
Electrical requirements
Electrical Shock Hazard
0 Electrical ground is required on
this appliance.
elf cold water pipe is interrupted by
plastic, non-metallic gaskets or
other insulating materials, Do Not
use for grounding.
*Do Not ground to a gas pipe.
*Do Not modify the power supply
cord plug. If it does not fit the
outlet, have a proper outlet
installed by a qualified electrician.
*Do Not have a fuse in the neutral
or grounding circuit. A fuse in the
neutral or grounding circuit could
result in electrical shock.
*Do Not use an extension cord with
this appliance.
*Check with a qualified electrician
if you are in doubt as to whether
the appliance is properly
grounded.
Failure to follow these instructions
could result in serious injury or
death.
If codes permit and a separate
grounding wire is used, it is
recommended that a qualified
electrician determine that the
grounding path is adequate.
Loading...