Whelen RBKTHD1 User Manual

ENGINEERING COMPANY INC.
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
®
Installation Guide:
TIR3 Super LED® Lighthead Bracket Model RBKTHD1
Side Cowl Mount, Harley-Davidson® w/State Police Package
Internet: www.whelen.com Sales e-mail: autosale@whelen.com Canadian Sales e-mail: autocan@whelen.com Customer Service e-mail: custserv@whelen.com
Installation:
This bracket will install on either side of the front fork of the motorcycle. You will use the bolts that hold the windshield bracket on. This manual shows the Road King. If you have the Electra-Glide, installation is the same, except you will have Torx head bolts instead of acorn nuts.
1. Install the lighthead onto the bracket as shown.
2. Remove the 2 acorn nuts that secure the front spot bracket to the motorcycle (do not remove the bracket).
3. Mount the bracket (with lighthead and flange) onto the motorcycle and then reinstall the acorn nuts to secure the bracket in place.
4. Extend the lighthead wires to your power source and refer to the lighthead manual for hookup and operation.
Automotive: Lightheads
©2004 Whelen Engineering Company Inc. Form No.13932B (060707)
ENGINEERING COMPANY INC.
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Fig. 1
For warranty information regarding this product, visit www.whelen.com/warranty
Acorn Nut
Bracket
®
Flange 6-32 X 1/2"
PPHMS SS
Installation Guide:
TIR3 Super LED® Lighthead Bracket Model RBKTHD1
Side Cowl Mount, Harley-Davidson® w/State Police Package
Internet: www.whelen.com Sales e-mail: autosale@whelen.com Canadian Sales e-mail: autocan@whelen.com Customer Service e-mail: custserv@whelen.com
Installation:
This bracket will install on either side of the front fork of the motorcycle. You will use the bolts that hold the windshield bracket on. This manual shows the Road King. If you have the Electra-Glide, installation is the same, except you will have Torx head bolts instead of acorn nuts.
1. Install the lighthead onto the bracket as shown.
2. Remove the 2 acorn nuts that secure the front spot bracket to the motorcycle (do not remove the bracket).
3. Mount the bracket (with lighthead and flange) onto the motorcycle and then reinstall the acorn nuts to secure the bracket in place.
4. Extend the lighthead wires to your power source and refer to the lighthead manual for hookup and operation.
Automotive: Lightheads
©2004 Whelen Engineering Company Inc. Form No.13932B (060707)
Fig. 1
Page 1
For warranty information regarding this product, visit www.whelen.com/warranty
Acorn Nut
Bracket
Flange 6-32 X 1/2"
PPHMS SS
Loading...