Whelen 5BKT1 User Manual
ENGINEERING COMPANY INC.
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
®
Installation Guide:
500 Series TIR6™ Super-LED® Lighthead
Mounting Bracket (92-present Crown Victoria)
Internet: www.whelen.com
Sales e-mail: autosale@whelen.com
Canadian Sales e-mail: autocan@whelen.com
Customer Service e-mail: custserv@whelen.com
RADIATOR
10-24 X 1"
HOOD LATCH
MOUNTING SURFACE
GRILL
1. Following the manufacturers instructions, remove the vehicle grill. The lighthead bracket will mount to the flat surface area that the grill mounts to. You
will secure the bracket with one of the grill’s mounting studs and its nut.
2. Mount the lighthead to the mounting bracket. Line the bracket (with lighthead) up with one of the holes that the grill mounts to. As you remount the grill,
insert the selected stud through the brackets mounting hole as shown.
NOTE: The holes on the bracket that you mount the lighthead to are made so that you may level the lighthead after mounting.
3. After making sure that the lighthead is level, replace the nuts that secure the grill (and lighthead). Extend the lighthead wires to your power source.
NOTE: Refer to your lighthead manual for all wiring, lighthead specifications, and safety information.
Automotive: LightheadsAutomotive: Lightheads
©2004 Whelen Engineering Company Inc.
Form No.13884A (062807)
For warranty information regarding this product, visit www.whelen.com/warranty
MOUNTING
GRILL
STUD
GRILL
PPHMS
®
EXISTING GRILL NUT
Installation Guide:
500 Series TIR6™ Super-LED® Lighthead
ENGINEERING COMPANY INC.
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Mounting Bracket (92-present Crown Victoria)
Internet: www.whelen.com
Sales e-mail: autosale@whelen.com
Canadian Sales e-mail: autocan@whelen.com
Customer Service e-mail: custserv@whelen.com
10-24 STEEL or
CAD PLATED
WIZ NUT
RADIATOR
10-24 X 1"
HOOD LATCH
MOUNTING SURFACE
GRILL
1. Following the manufacturers instructions, remove the vehicle grill. The lighthead bracket will mount to the flat surface area that the grill mounts to. You
will secure the bracket with one of the grill’s mounting studs and its nut.
2. Mount the lighthead to the mounting bracket. Line the bracket (with lighthead) up with one of the holes that the grill mounts to. As you remount the grill,
insert the selected stud through the brackets mounting hole as shown.
NOTE: The holes on the bracket that you mount the lighthead to are made so that you may level the lighthead after mounting.
3. After making sure that the lighthead is level, replace the nuts that secure the grill (and lighthead). Extend the lighthead wires to your power source.
NOTE: Refer to your lighthead manual for all wiring, lighthead specifications, and safety information.
©2004 Whelen Engineering Company Inc.
Form No.13884A (062807)
Page 1
For warranty information regarding this product, visit www.whelen.com/warranty
MOUNTING
GRILL
STUD
GRILL
PPHMS
EXISTING GRILL NUT
10-24 STEEL or
CAD PLATED
WIZ NUT
Loading...