Whelen 0AC0EDCR User Manual

www. .com
ENGINEERING COMPANY INC.
51 Winthrop Road Chester, Connecticut 06412-0684 Phone: (860) 526-9504 Fax: (860) 526-4078 Sales Email:autosale@whelen.com Canadian Sales:autocan@whelen.com Customer Service:custserv@whelen.com
WARNING! All customer supplied wires that connect to the positive terminal of the battery must be sized to supply at least 125% of the maximum operating current and at the battery to carry the load. DO NOT USE CIRCUIT BREAKERS WITH THIS PRODUCT!
1.
Place the assembly onto the mounting surface and mark the location for the two mounting screws
and the wire access hole location between the two screw holes.
provided on the bottom of the flange if you prefer the wires to exit the bottom of
sure the installation will not interfere with anything behind the mounting surface.
2.
Drill two pilot holes for the two #4 X 3/8" sheet metal mountingscrews and a3/8” wire accesshole. Be sure
to thoroughly deburr this hole and install an appropriately sized grommet (customer supplied).
3.
Feed the wires through the gasket and wire access hole and mount the lighthead using the supplied
mounting screws.
4. .
Extend the wires to a switched, 12VDC power source andfuse the positive wire @ 1 amp Test the lighthead
and confirm proper operation
®
NOTE: An optional wire exit hole is
NOTE: Make sure the Whelen logo on the lens is oriented correctly aftermounting.
CORRECT ORIENTATION
1.883"
LED Courtesy Light
FUSED
the lighthead.
Be
1.382"
0.475"
3/8" Wire Hole
0.950"
0.660"
Mounting Hole
for #4 Sheet Metal Screw
Wiring White Wire: Black Wire:
Specifications Input Voltage: Input Current:
IMPORTANT! Before returning this vehicle to active service, visually confirm proper operation of this product, as well as all vehicle components/equipment.
+12VDC Ground
12.8 VDC 30mA (TYP)
(2 plcs.)
IMPORTANT WARNING!
CAUTION! DO NOT LOOK DIRECTLY AT THESE LEDS WHILE THEY ARE ON. MOMENTARY BLINDNESS AND/OR EYE DAMAGE COULD RESULT!
For warranty information regarding this product, visit www.whelen.com/warranty
©2008 Whelen Engineering Company Inc. Form No. 14174 (020108)
Loading...