Westinghouse WRH605I Installation Manual
RETRACTABLE RANGEHOOD
OPERATION GUIDE
INSTALLATION INSTRUCTIONS
Models: WRH605I • WRH608I • WRH908I • REHR6 • RRE634 • RRE635 • RRE934
These cooker hoods are domestic appliances which have been manufactured and tested to comply with
Australian and New Zealand
Standard AS/NZS 3350.2.31.
Safety Warnings
• Young children should be supervised to ensure they do not play with the cooker hood.
• The cooker hood is not intended for use by young children or infi rm persons without supervision.
• Ensure the cooker hood is switched off before carrying out maintenance, to avoid any possibility of electric shock.
• Grease fi lters must be removed every four weeks (maximum) for cleaning to reduce the risk of fi re.
• Do not fl amb¢e under the cooker hood.
• This cooker hood is not recommended for barbeques.
• The exhaust air from the cooker hood must not be discharged into any heating fl ue, which may carry combustion
products from other sources.
• Exhaust air must not be discharged into a wall cavity, unless the cavity is designed for the purpose.
• There must be adequate ventilation of the room when the cooker hood is used at the same time as appliances burning
gas or other fuels.
• Always cover lit gas burners with pots or pans when the cooker hood is in use.
• Always switch off gas burners before you remove pots or pans.
Cleaning
Wipe the cooker hood body and fl ue with a sponge or soft cloth soaked in warm soapy water. Do not use oven cleaners
or other abrasive materials.
Electrical Connection
• Check that the mains voltage matches with the voltage on the data plate inside the cooker hood.
• Check that the installation complies with standards of local gas and electricity authorities.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualifi ed
person in order to avoid a hazard.
Accessories
• Use 125mm round exhaust ducting for best performance.
• When using fl exible duct always install duct with the wire helix pulled taut to minimise pressure loss.
• Try to keep exhaust duct short and straight.
• Keep bends in the exhaust duct to a minimum.
• Do not reduce the size or restrict exhaust duct.
P1
RETRACTABLE RANGEHOOD
INSTALLATION INSTRUCTIONS
Please read instructions carefully. Service calls resulting from incorrect installation will be charged for.
Exhaust air from the Rangehood must not be discharged into any heating fl ue which may carry
combustion products from other sources. In addition, exhaust air must not be discharged into a wall
cavity, unless the cavity is designed for the purpose. Adequate ventilation of the room must be
ensured when the Rangehood is operating simultaneously with appliances burning gas or other
fuels. Installation must comply in all respects with your gas and electrical authorities. This
Rangehood is an indoor domestic appliance, and has been manufactured and tested to comply
with Australian and New Zealand Standard AS/NZ3350,2,31
It is recommended that the unit be positioned as close as possible to 600mm (electric hobs),
650mm (gas hobs), and no further from the hob than 800mm. The unit becomes less effective as
the distance from the cooking surface to the hood increases.
FIXING POINT DIMENSIONS
650
GAS
ELECTRIC
600
Retractable cooker hood 600mm
FIXING POINT DIMENSIONS
Retractable cooker hood 900mm
OPERATION GUIDE & INSTALLATION INSTRUCTIONS
P2
INSTALLATION INSTRUCTIONS
STANDARD DUCTED INSTALLATION
Models: WRH605I • WRH608I • WRH908I • REHR6 • RRE634 • RRE635 • RRE934
DUCTING ACCESSORIES
For best performance 125mm ducting is recommended.
AR125RC
AR125F
AR125FD
AR125FJ (without damper)
AR125FJD (with damper)
AR125WV
ACCESSORIES CAN ONY BE BOUGHT THROUGH THE SALES DEPARTMENT.
THESE PARTS ARE NOT AVAILABLE THROUGH SPARE PARTS.
P3
RETRACTABLE RANGEHOOD
AR125B
Loading...