Stainless Steel, Gas red
Up to 96% Thermal Efciency
Up to 5:1 Turndown Ratio
Industry rst for Condensing Water
Heaters: Top and Side Connection
Choices for Inlet and Outlet
Ease of Installation
Extremely lightweight tank fits virtually
anywhere; 100 gallon: 63” height &
80 gallon: 55“ height
316L Stainless Steel Tank
Eliminates the need for anode rods
Vents in Inexpensive PVC
or CPVC pipe
Combined vent lengths up to 200’ in 3”
pipe or vent lengths up to 85’ in 2” pipe
Beautiful Stainless Steel Look
80/100 Gallon - 130k/199k Btuh
Commercial Water Heater
This water heater will accommodate even the
most difficult installations with lower clearance
and multiple inlet and outlet connections making
it easier to replace traditional center ue heaters.
Inlet / Outlet Connections On Both The Top & Side
A Closer Look
Top hot water outlet
(stainless steel)
Side hot water outlet
(stainless steel)
Low water cutoff sensor
High limit safety sensor
Inlet / Outlet Connections On Top & Side
Top cold water inlet
(stainless steel)
Factory installed
ASME rated
temperature
and pressure
relief valve
Upper (hot water)
temperature sensor
Proprietary heat
exchanger: body
constructed of
90/10 cupronickel
top section constructed
of 800H stainless steel
Lower (cold water)
temperature sensor
Side cold water inlet
(stainless steel)
Exhaust adaptor to PVC /
CP VC / PolyPro venting
Tank constructed of
316L stainless steel
Insulated w/ water
blown foam
2” thick in the side wall
w/ a rating of R14.2
- 3” thick in the top
w/ a rating of R21.3
Stainless steel burner
- 120 volt motor w/
wave modulation
control
Digital LED display
system monitoring
and temperature
adjustment
Components located
on front of heater for
easy service access,
all related hardware is
made of stainless steel
studs and brass nuts
Venting Options:
- Direct vent side wall
- Direct vent vertical
- Unbalanced venting
- Room air
- Combined vent /air intake
length up to 200ft
Condensate trap
assembly
Laser Welded Tank
An advanced laser allows for more precise welding
through a concentrated heat source, producing
high quality 316L stainless steel tank construction
with stronger, long lasting seams.