Westinghouse WGCM080LP130, WGCM080LP199, WGCM080NG130, WGCM100LP130, WGCM080NG199 Brochure

Stainless Steel, Gas red

Up to 96% Thermal Efciency

Up to 5:1 Turndown Ratio

Industry rst for Condensing Water
Heaters: Top and Side Connection
Choices for Inlet and Outlet

Ease of Installation

Extremely lightweight tank fits virtually
anywhere; 100 gallon: 63” height &
80 gallon: 55“ height

316L Stainless Steel Tank

Eliminates the need for anode rods

Vents in Inexpensive PVC
or CPVC pipe

Combined vent lengths up to 200’ in 3”
pipe or vent lengths up to 85’ in 2” pipe

Beautiful Stainless Steel Look

80/100 Gallon - 130k/199k Btuh

Commercial Water Heater

This water heater will accommodate even the
most difficult installations with lower clearance
and multiple inlet and outlet connections making

it easier to replace traditional center ue heaters.

Inlet / Outlet Connections On Both The Top & Side

A Closer Look

Top hot water outlet
(stainless steel)

Side hot water outlet
(stainless steel)

Low water cutoff sensor

High limit safety sensor

Inlet / Outlet Connections On Top & Side

Top cold water inlet

(stainless steel)

Factory installed

ASME rated

temperature

and pressure

relief valve

Upper (hot water)
temperature sensor

Proprietary heat
exchanger: body
constructed of
90/10 cupronickel
top section constructed
of 800H stainless steel

Lower (cold water)
temperature sensor

Side cold water inlet
(stainless steel)

Exhaust adaptor to PVC /
CP VC / PolyPro venting

Tank constructed of

316L stainless steel

Insulated w/ water

blown foam

2” thick in the side wall

w/ a rating of R14.2

- 3” thick in the top

w/ a rating of R21.3

Stainless steel burner

- 120 volt motor w/
wave modulation

control

Digital LED display

system monitoring

and temperature

adjustment

Components located

on front of heater for

easy service access,
all related hardware is
made of stainless steel

studs and brass nuts

Venting Options:

- Direct vent side wall

- Direct vent vertical

- Unbalanced venting

- Room air

- Combined vent /air intake
length up to 200ft

Condensate trap

assembly

Laser Welded Tank

An advanced laser allows for more precise welding
through a concentrated heat source, producing
high quality 316L stainless steel tank construction
with stronger, long lasting seams.