Weslo WLEL32912.1 Owner's Manual

www.weslo.com

Model No. WLEL32912.1 Serial No.

Write the serial number in the space above for reference.

Serial Number Decal

(under frame)

QUESTIONS?

If you have questions, or if parts are damaged or missing, DO NOT

CONTACT THE STORE; please contact Customer Care.

USER’S MANUAL

IMPORTANT: Please register this product (see the limited warranty on the back cover of this manual) before contacting Customer Care.

CALL TOLL-FREE:

1-866-699-3756

Mon.–Fri., 6 a.m.–6 p.m. MT Sat. 8 a.m.–4 p.m. MT

ON THE WEB: www.wesloservice.com

CAUTION

Read all precautions and instructions in this manual before using this equipment. Keep this manual for future reference.

TABLE OF CONTENTS

WARNING DECAL PLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2

IMPORTANT PRECAUTIONS ..................................................................3

BEFORE YOU BEGIN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

PART IDENTIFICATION CHART. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5

ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6

HOW TO USE THE ELLIPTICAL ..............................................................13

MAINTENANCE AND TROUBLESHOOTING ....................................................17

FCC INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17

EXERCISE GUIDELINES ....................................................................18

PART LIST. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20

EXPLODED DRAWING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22

ORDERING REPLACEMENT PARTS .................................................. Back Cover

LIMITED WARRANTY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Back Cover

WARNING DECAL PLACEMENT

This drawing shows the location(s) of the warning decal(s). If a decal is missing or illegible, see the

front cover of this manual and request a free replacement decal. Apply the decal in the location shown. Note: The decal(s) may not be shown at

actual size.

WESLO is a registered trademark of ICON IP, Inc.

IMPORTANT PRECAUTIONS

WARNING: To reduce the risk of serious injury, read all important precautions and

instructions in this manual and all warnings on your elliptical before using your elliptical. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of this product.

1. It is the responsibility of the owner to ensure that all users of the elliptical are adequately informed of all precautions.

2. Before beginning any exercise program, consult your physician. This is especially important for persons over age 35 or persons with pre-existing health problems.

3. Use the elliptical only as described in this manual.

4. The elliptical is intended for home use only. Do not use the elliptical in a commercial, rental, or institutional setting.

5. Keep the elliptical indoors, away from moisture and dust. Do not put the elliptical in a garage or covered patio, or near water.

6. Place the elliptical on a level surface, with at least 3 ft. (0.9 m) of clearance in the front and rear of the elliptical and 2 ft. (0.6 m) on each side. To protect the floor or carpet from damage, place a mat under the elliptical.

9. The elliptical should not be used by persons weighing more than 250 lbs. (113 kg).

10. Wear appropriate clothes while exercising; do not wear loose clothes that could become caught on the elliptical. Always wear athletic shoes for foot protection while exercising.

11. Hold the handlebars or the upper body arms when mounting, dismounting, or using the elliptical.

12. The heart rate monitor is not a medical device. Various factors may affect the accuracy of heart rate readings. The heart rate monitor is intended only as an exercise aid in determining heart rate trends in general.

13. The elliptical does not have a freewheel; the pedals will continue to move until the flywheel stops. Reduce your pedaling speed in a controlled way.

14. Keep your back straight while using the elliptical; do not arch your back.

7. Inspect and properly tighten all parts regularly. Replace any worn parts immediately.

8. Keep children under age 12 and pets away from the elliptical at all times.

15. Over exercising may result in serious injury or death. If you feel faint or if you experience pain while exercising, stop immediately and cool down.

BEFORE YOU BEGIN

Thank you for selecting the new WESLO® MOMENTUM CT 6.2 elliptical. The MOMENTUM CT

6.2 elliptical provides a selection of features designed to make your workouts at home more effective and enjoyable.

For your benefit, read this manual carefully before you use the elliptical. If you have questions after

Length: 6 ft. (183 cm) Width: 1 ft. 11 in. (58 cm)

Console

reading this manual, please see the front cover of this manual. To help us assist you, note the product model number and serial number before contacting us. The model number and the location of the serial number decal are shown on the front cover of this manual.

Before reading further, please familiarize yourself with the parts that are labeled in the drawing below.

Upper Body Arm

Heart Rate Monitor

Handlebar

Pedal Disc

Wheel

Pedal

Leveling Dial

PART IDENTIFICATION CHART

Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it

has been preassembled.

M8 Locknut

(27)–6

M3 x 20mm

Screw (79)–4

M8 x 20mm

Screw (7)–3

M10 Locknut

(32)–6

M4 x 16mm

Screw (2)–4

M8 x 36mm

Bolt (22)–4

M8 x 82mm

Screw (53)–4

M8 Split

Washer (8)–10

M4 x 20mm Self-tapping

Screw (45)–2

M8 Washer

(71)–10

M4 x 20mm

Screw (93)–6

M8 x 78mm Bolt (38)–2

M10 x 45mm

Bolt (39)–4

M10 Washer

(10)–6

M8 x 16mm

Screw (35)–4

M10 x 76mm

Bolt (30)–2

ASSEMBLY

• To hire an authorized service technician to assemble this product, call 1-800-445-2480.

• To watch an assembly video, go to http://productvideo.co/ assembly/kmart/weslo or use your mobile phone or smartphone to read the QR code at the right.

• Assembly requires two persons.

• Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing

materialsuntilyounishallassemblysteps.

1. Identify the Rear Stabilizer (52), which does not have wheels.

Set a sturdy piece of packing material under the

rear of the Frame (54). Have a second person

hold the Frame to prevent it from tipping while you complete this step.

• Left parts are marked “L” or “Left” and right parts are marked “R” or “Right.”

• To identify small parts, see page 5.

• In addition to the included tool(s), assembly

requires the following tools:

one adjustable wrench

one Phillips screwdriver

one rubber mallet

Assembly may be easier if you have a set of wrenches. To avoid damaging parts, do not use power tools.

Attach the Rear Stabilizer (52) to the Frame (54)

with two M8 x 82mm Screws (53), two M8 Split Washers (8), and two M8 Washers (71).

Remove the packing material.

Leveling

Dial

2. If there is a cardboard tube (not shown) on the front the Frame (54), remove and discard the attachment screw and the cardboard tube.

Set a sturdy piece of packing material under the

front of the Frame (54). Have a second person

hold the Frame to prevent it from tipping while you complete this step.

Attach the Front Stabilizer (37) to the Frame (54)

with two M8 x 82mm Screws (53), two M8 Split Washers (8), and two M8 Washers (71).

Remove the packing material.

3. Orient the Right Pedal (76) as shown.

Attach the Right Pedal (76) to the Right Pedal

Arm (75) with two M10 x 45mm Bolts (39), two M10 Washers (10), and two M10 Locknuts (32).

Attach the Left Pedal (not shown) to the Left

Pedal Arm (not shown) in the same way.

4. Attach the Right Pedal Arm Cover (85) to the Right Pedal Arm (75) with an M4 x 20mm Selftapping Screw (45).

Repeat this step on the other side of the

elliptical.

5. Orient the Upright (9) and the Lower Upright Cover (83) as shown. Slide the Lower Upright Cover upward onto the Upright.

Have a second person hold the Upright (9) and

the Lower Upright Cover (83) near the Frame (54). Connect the Extension Wire (16) to the Main Wire (26).

Tip: Avoid pinching the wires. Slide the

Upright (9) onto the Frame (54).

Attach the Upright (9) with two M8 x 78mm Bolts

(38), two M8 Split Washers (8), two M8 Washers (71), and two M8 Locknuts (27). Make sure that

the Locknuts are inside the hexagonal holes. Do not fully tighten the Bolts yet.

Then, attach the Upright (9) with four M8 x

16mm Screws (35), four M8 Split Washers (8), and four M8 Washers (71). Do not fully tighten

the Screws yet.

Slide the Lower Upright Cover (83) downward

to the Frame (54). Do not press the Lower

Upright Cover into place yet.

Avoid pinching

Hexagonal

Holes

the wires

+ 16 hidden pages