Note: An EXPLODED DRAWING and a PART LIST are attached in the center of this manual.
WESLO is a registered trademark of ICON IP, Inc.
2
IMPORTANT PRECAUTIONS
WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the
following important precautions and information before operating the treadmill.
1. It is the responsibility of the owner to ensure
that all users of this treadmill are adequately
informed of all warnings and precautions.
2. Use the treadmill only as described.
3. Place the treadmill on a level surface, with at
least 2 m (8 ft.) of clearance behind it and 0.5
m (2 ft.) on each side. Do not place the treadmill on any surface that blocks air openings.
To protect the floor or carpet from damage,
place a mat under the treadmill.
4. Keep the treadmill indoors, away from moisture and dust. Do not put the treadmill in a
garage or covered patio, or near water.
5. Do not operate the treadmill where aerosol
products are used or where oxygen is being
administered.
6. Keep children under the age of 12 and pets
away from the treadmill at all times.
7. The treadmill should be used only by persons
weighing 115 kg (250 lbs.) or less.
8. Never allow more than one person on the
treadmill at a time.
9. Wear appropriate exercise clothes when
using the treadmill. Do not wear loose clothes
that could become caught in the treadmill.
Athletic support clothes are recommended for
both men and women.
shoes. Never use the treadmill with bare feet,
wearing only stockings, or in sandals.
10. When connecting the power cord (see page 10),
plug the power cord into a surge suppressor
(not included) and plug the surge suppressor
into a grounded circuit capable of carrying 15
or more amps. No other appliance should be on
the same circuit. Do not use an extension cord.
11. Use only a single-outlet surge suppressor that
meets all of the specifications described on
page 10.
Always wear athletic
12. Failure to use a properly functioning surge
suppressor could result in damage to the control system of the treadmill. If the control system is damaged, the walking belt may change
speed, accelerate, or stop unexpectedly,
which may result in a fall and serious injury.
13. Keep the power cord and the surge suppressor away from heated surfaces.
14. Never move the walking belt while the power
is turned off. Do not operate the treadmill if
the power cord or plug is damaged, or if the
treadmill is not working properly. (See BEFORE YOU BEGIN on page 5 if the treadmill is
not working properly.)
15. Never start the treadmill while you are standing on the walking belt. Always hold the
handrails while using the treadmill.
16. The treadmill is capable of high speeds.
Adjust the speed in small increments to avoid
sudden jumps in speed.
17. The pulse sensor is not a medical device.
Various factors, including your movement,
may affect the accuracy of heart rate readings.
The sensor is intended only as an exercise aid
in determining heart rate trends in general.
18. Do not use the hand weights at speeds faster
than walking speeds. Using weights and not
holding the handrails may compromise your
ability to maintain your balance. Exercises
using weights should be attempted only by
experienced users.
19. Never leave the treadmill unattended while it
is running. Always remove the key and unplug
the power cord when the treadmill is not in
use.
20. Do not attempt to raise, lower, or move the
treadmill until it is properly assembled. (See
ASSEMBLY on page 6, and HOW TO FOLD
TREADMILL on page 14.)
MOVE
AND
You must be able to safely lift 20 kg (45 lbs.) to
raise, lower, or move the treadmill.
THE
3
21. When folding or moving the treadmill, make
!
!
sure that the storage latch is fully closed.
Inspect and properly tighten all parts of the
22.
treadmill regularly.
23. Never insert any object into any opening.
maintenance and adjustment procedures described in this manual. Never remove the
motor hood unless instructed to do so by an
authorized service representative. Servicing
other than the procedures in this manual
should be performed by an authorized service representative only.
24. DANGER: Always unplug the power
cord immediately after use, before cleaning
the treadmill, and before performing the
25. This treadmill is intended for in-home use
only. Do not use this treadmill in a commercial, rental, or institutional setting.
WARNING: Before beginning this or any exercise program, consult your physician. This
is especially important for persons over the age of 35 or persons with pre-existing health problems.
Read all instructions before using. Sears assumes no responsibility for personal injury or property
damage sustained by or through the use of this product.
SAVE THESE INSTRUCTIONS
The decals shown have been placed on your
treadmill. If a decal is missing, or if it is not
legible, please call toll-free 1-888-936-4266
and order a free replacement decal. Apply
the decal in the location shown. Note: The
decals are not shown at actual size.
4
BEFORE YOU BEGIN
Thank you for selecting the new
WALK 365e treadmill. The CROSSWALK 365e treadmill
combines advanced technology with innovative design
to help you get the most from your exercise in the convenience of your home. And when you’re not exercising,
the CROSSWALK 365e treadmill can be folded up, requiring less than half the floor space of other treadmills.
For your benefit, read this manual carefully before
using the treadmill. If you have questions after read-
Watter Bottle Holder
(bottle not included)
Upper Body Arms
Handrail
WESLO
®
CROSS
-
ing this manual, see the front cover of this manual.
help us assist you, please note the product model num
ber and serial number before calling. The model number
of the treadmill is WCTL95335.0. The serial number can
be found on a decal attached to the treadmill (see the
front cover of this manual for the location).
Before reading further, please review the drawing
below and familiarize yourself with the labeled parts.
Bookrack
Console
Key/Clip
Upright
To
-
Storage Latch
Walking Belt
Foot Rail
BACK
Rear Roller
Adjustment Bolts
Reset/Off
Circuit Breaker
RIGHT SIDE
Power Cord
Cushioned Walking Platform
for maximum exercise comfort
5
ASSEMBLY
3/4” Screw (43)–12
Silver Ground
Screw (99)–1
Handrail Bolt (44)–2
1/2” Screw (97)–4
Extension Leg Screw (14)–2
Star Washer (25)–4
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrenches and your own phillips screwdriver ,
and rubber mallet .
For help identifying the assembly hardware, see the drawings below. If a part is not in the parts bag, first
check to see if it has been pre-assembled.
1. With the help of a second person, raise the Uprights (38)
to the position shown.
Next, insert one of the Extension Legs (15) into the
treadmill as shown; make sure that the Extension Leg is
turned so the Base Pad (33) is underneath it. Note: It
may be helpful to tip the Uprights (38)
shown by the arrow as you insert the Extension Leg.
Attach the Extension Leg (15) with an Extension Leg
Screw (14).
Extension Leg Screw while tightening it.
Attach the other Extension Leg (not shown) in the
same way.
Make sure to push on the head of the
in the direction
1
38
14
15
33
6
2. Insert the tab on one of the Handrail Brackets (17) into the
slot in the right Upright (38). Attach the Handrail Bracket
with a 3/4” Screw (43) and a Star Washer (25). Attach
the other Handrail Bracket to the left Upright (not
shown) in the same way.
2
38
Slot
17
43
25
3. Identify the Right Handrail (16), which has a large hole in
the left side. Feed the Wire Harness (53) into the hole in
the bottom of the Right Handrail and out of the large hole
in the side. Note: It may be helpful to use needlenose pliers to pull the Wire Harness out of the hole.
Press a Handrail Cap (103) onto the lower end of the
Right Handrail (16) as shown. Set the Right Handrail on
the right Upright (38), while sliding the lower end of the
Right Handrail onto the Handrail Bracket (17). Attach the
Right Handrail with an Upright Bolt (44) in the upper end
and a 3/4” Screw (43) and a Star Washer (25) in the
lower end.
Attach the Left Handrail (4) in the same way. Note:
There is not a wire harness on the left side.
4. Attach the ground wire to the small hole in the side of the
Right Handrail (16) with a Silver Ground Screw (99).
3
43
4
25
44
4
43
16
25
44
53
Hole
Hole
38
103
17
Ground
Wire
99
16
7
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.