Wells RW-16 Installation Manual

ELECTRICAL

INSTALLATION INSTRUCTIONS

BUILT-IN DRAWER WARMERS

RW-16 (T, HD)

FIELD

WIRINGPHASEAMPSWATTSVOLTSMODEL

GAUGE

RW-16
RW-16 SINGLE 14 AWB Cu 90°C
RW-16

RW-16HD, RWT-16/16HD MODELS HAVE THE SAME ELECTRICAL
SPECIFICATIONS AS THE STANDARD UNITS

208
240 450 1.9

450120
338

3.8

1.6
SINGLE

14 AWB Cu 90°C

CUTOUT DETAILS PRODUCT DIMENSIONS

23

(584)

29 1/4

(743)

TEMP.

RATING

90°C14 AWB CuSINGLE

INCHES

(MM)

FIELD WIRE CONNECTION
6" PIGTAIL

5 5/8

(143)

21 1/2

(546)

14 3/8

(365)

REAR
SUPPORT

9 7/8
(251)

28 1/8

(714)

FRONT PANEL CUT-OUT DIMENSIONS

INSTALLATION INSTRUCTIONS

INSTALLER MUST MEET CONDITIONS OF ACCEPTABILITY
OUTLINED BELOW UPON INSTALLATION:

TO FABRICATE:

1. Layout front panel cutout dimensions and cutout hole
in counter front panel.

2. Position attaching flange (supplied) in hole cutout to
determine screw hole location. Drill holes using #34 drill.

3. Attach flange to front panel using #6 screws provided.

4. Fabricate rails and rear support in locations shown.
TO INSTALL:

1. For ease of installation, remove drawer from unit.

2. Slide unit through front panel opening until rear of
unit engages rear support.

3. Remove control knob and control panel.

4. Install #8-32 speednuts on attaching flange, secure
attaching flange to front panel, then secure unit to
attaching flange using #8-32 flathead screws provided.

5. Connect service leads to the unit including ground wire.

6. Replace control panel and control knob.

7. Replace drawer.

RAILS
FLUSH TO
BOTTOM OF
CUT-OUT

21 1/2

(546)

10 7/8

(276)

FROM OUTSIDES

23

OF RAILS

(584)

21 1/2

(546)

REAR
SUPPORT

9 1/2

(241)

WELLS/BLOOMFIELD * VERDI, NV

37119-1 REV (-)