Wells RCP-7300 Installation Manual

WELLS MANUFACTURING

10 Sunnen Dr., St. Louis, MO 63143

telephone: 314-678-6314

fax: 314-781-2714

www.wellsbloomfield.com

OPERATIONS MANUAL

DROP-IN REFRIGERATED

COLD PANS, NSF7 RCP-7050, RCP-7067, RCP-7100, RCP-7200,

RCP-7300, RCP-7400,

RCP-7500, RCP-7600.

DROP-IN REFRIGERATED

COLD PANS, NSF2

RCP-050, RCP-067, RCP-100, RCP-200,

RCP-300, RCP-400,

RCP-500, RCP-600.

405

Model RCP-7200

This manual is considered to be part of the appliance and is to be given to the OWNER or

MANAGER of the restaurant, or to the person responsible for TRAINING the operators of

THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR

DROP-IN REFRIGERATED

COLD PANS, SLOPE TOP NSF7

RCP-7100ST, RCP-7200ST,

RCP-7300ST, RCP-7400ST,

RCP-7500ST, RCP-7600ST.

DROP-IN REFRIGERATED

COLD PANS, SLOPE TOP NSF2

RCP-100ST, RCP-200ST,

RCP-300ST, RCP-400ST,

RCP-500ST, RCP-600ST.

INCLUDES INSTALLATION, USE,

CARE, SERVICE AND DIAGRAMS.

IMPORTANT: DO NOT DISCARD THIS MANUAL

this appliance. Additional manuals are available from your WELLS DEALER.

INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any

questions concerning installation, operation or maintenance of this equipment.

p/n 2M-305101 Rev. G M405 150902

LIMITED WARRANTY STATEMENT

Unless otherwise specied, all commercial cooking

equipment manufactured by WELLS MANUFACTURING is

warranted against defects in materials and workmanship

for a period of one year from the date of original installation or 18 months from the date of shipment from our factory,

whichever comes rst, and is for the benet of the original

purchaser only. THIS WARRANTY IS THE COMPLETE AND ONLY WARRANTY, EXPRESSED OR IMPLIED IN LAW OR IN FACT, INCLUDING BUT NOT LIMITED TO, WARRANTIES OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE, AND/OR FOR DIRECT, INDIRECT OR CONSEQUENTIAL DAMAGES IN CONNECTION WITH WELLS MANUFACTURING PRODUCTS. This warranty is void if it is determined that, upon inspection by an authorized service agency,

the equipment has been modied, misused, misapplied, improperly installed, or damaged in transit or by re, ood or act of God. It also does not apply if the serial

nameplate has been removed, or if service is performed by unauthorized personnel. The prices charged by Wells

Bloomeld for its products are based upon the limitations

in this warranty. Seller’s obligation under this warranty is limited to the repair of defects without charge by a Wells

Bloomeld factory authorized service agency or one of its

sub-service agencies. This service will be provided on customer’s premises for non-portable models. Portable

models (a device with a cord and plug) must be taken

or shipped to the closest authorized service agency, transportation charges prepaid, for service. In addition to

restrictions contained in this warranty, specic limitations are

shown in the Service Policy and Procedure Guide. Wells authorized service agencies are located in principal cities. This warranty is valid in the United States and Canada and

void elsewhere. Please consult your classied telephone

directory, your foodservice equipment dealer or contact:

Wells Manufacturing

10 Sunnen Dr., St. Louis MO 63143 USA

phone (314) 678-6314 or fax (314) 781-2714

for information and other details concerning warranty.

SERVICE POLICY AND PROCEDURE GUIDE and ADDITIONAL WARRANTY EXCLUSIONS

1. Resetting of safety thermostats, circuit breakers, over

load protectors, and/or fuse replacements are not covered by this warranty unless warranted conditions are the cause.

2. All problems due to operation at voltages or phase

other than specied on equipment nameplates are

not covered by this warranty. Conversion to correct voltage and/or phase must be the customer’s responsibility.

3. All problems due to electrical connections not made in accordance with electrical code requirements and wiring diagrams supplied with the equipment are not covered by this warranty.

4. Replacement of items subject to normal wear, to

include such items as knobs, light bulbs; and, normal

maintenance functions including adjustments of

thermostats, adjustment of micro switches and replacement of fuses and indicating lights are not covered by warranty.

5. Damage to electrical cords and/or plug due to exposure

to excessive heat are not covered by this warranty.

6. Full use, care, and maintenance instructions supplied with each machine. Noted maintenance and preventative maintenance items, such as servicing and

cleaning schedules, are customer responsibility. Those miscellaneous adjustments noted are customer responsibility. Proper attention to preventative maintenance and scheduled maintenance procedures

will prolong the life of the appliance.

7. Travel mileage is limited to sixty (60) miles from an

Authorized Service Agency or one of its sub-service

agencies.

8. All labor shall be performed during regular working

hours. Overtime premium will be charged to the buyer.

9. All genuine Wells replacement parts are warranted

for ninety (90) days from date of purchase on non-

warranty equipment. This parts warranty is limited only

to replacement of the defective part(s). Any use of non-

genuine Wells parts completely voids any warranty.

10. Installation, labor, and job check-outs are not

considered warranty and are thus not covered by this

warranty.

11. Charges incurred by delays, waiting time or operating

restrictions that hinder the service technician’s ability to

perform service are not covered by warranty. This

includes institutional and correctional facilities.

SHIPPING DAMAGE CLAIM PROCEDURE

NOTE: For your protection, please note that equipment

in this shipment was carefully inspected and packaged by skilled personnel before leaving the factory. Upon

acceptance of this shipment, the transportation company assumes full responsibility for its safe delivery.

IF SHIPMENT ARRIVES DAMAGED:

1. VISIBLE LOSS OR DAMAGE: Be certain that any visible loss or damage is noted on the freight bill or express receipt, and that the note of loss or damage is signed by the delivery person.

2. FILE CLAIM FOR DAMAGE IMMEDIATELY:

Regardless of the extent of the damage.

3. CONCEALED LOSS OR DAMAGE: if damage is

unnoticed until the merchandise is unpacked, notify the transportation company or carrier immediately, and le

“CONCEALED DAMAGE” claim with them. This

should be done within fteen (15) days from the date

the delivery was made to you. Be sure to retain the container for inspection.

Wells cannot assume liability for damage or loss incurred in transit. We will, however, at your request, supply you with the necessary documents to support your claim.

M405 p/n 2M-305101 Owmers Manual Drop-In Refrigerated Cold Pans

TABLE OF CONTENTS

WARRANTY II INTRODUCTION & SPECIFICATIONS 1 FEATURES & OPERATING CONTROLS 2 PRECAUTIONS & GENERAL INFORMATION 3 AGENCY LISTING INFORMATION 4

INSTALLATION 5, 6, 7

OPERATION 8 CLEANING INSTRUCTIONS 9 MAINTENANCE INSTRUCTIONS 10, 11 OPERATING INSTRUCTIONS 12, 13 TROUBLESHOOTING SUGGESTIONS 14

WIRING AND REFR. DIAGRAMS 15

BLANK PAGE FOR NOTES 16 ACCESSORY PARTS & SERVICE DATA 17

INTRODUCTION

Thank you for purchasing this Wells Manufacturing appliance.

Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life.

This manual contains the information needed to properly install this appliance, and to use and care for the appliance in a manner which will ensure its optimum performance.

ELECTRICAL & REFRIGERATION SPECIFICATIONS

MODELS HP

RCP-050, RCP-067

RCP-7050, RCP-7067

RCP-100, RCP-200, RCP-300

RCP-7100, RCP-7200

RCP-100ST, RCP200ST, RCP300ST

RCP-7100ST, RCP7200ST

RCP-400, RCP-7300, RCP-400ST

RCP-7300ST

RCP-500, RCP-600, RCP-500ST,

RCP-600ST, RCP-7400, RCP-7400ST

M405 p/n 2M-305101 Owmers Manual Drop-In Refrigerated Cold Pans

RCP-7500, RCP-7500ST

RCP-7600, RCP-7600ST

1/4 5.5 8 15 38 R-134a 28 oz. 440 162 NEMA 5-15P

1/3 7 11 15 29 R-404a 24 oz. 500 174 NEMA 5-15P

1/2 7.5 12 15 33 R-404a 32 oz. 500 174 NEMA 5-15P

3/4 15.3 21 30 59 R-404a 54 oz. 500 174 NEMA 5-20P

AMPS 120VAC 1ø REFRIGERANT

TOTAL MCA MFS LRA TYPE AMT. HIGH LOW CORD

PRESSURE POWER

(psig) SUPPLY

FEATURES & OPERATING CONTROLS

IL2961

PAN RAIL SUPPORT

PAN RAIL

TEMPERATURE CONTROL UNIT

POWER SWITCH

POWER CORD

AIRFLOW

REFRIGERATION CONDENSER

DRAIN

OPTIONAL DRAIN SCREEN

PAN ADAPTER BAR

NOTE:

This is a general arrangement drawing only. Actual component positions may vary between units.

M405 p/n 2M-305101 Owmers Manual Drop-In Refrigerated Cold Pans

PRECAUTIONS AND GENERAL INFORMATION

This appliance is intended for use in commercial establishments only, and is intended to hold pre-chilled prepared food for human consumption. No other use is recommended or authorized by the manufacturer or its agents.

Operators of this appliance must be familiar with the appliance use, limitations and associated restrictions. Operating instructions must be read and understood by all persons using or installing this appliance.

Food must be kept in appropriate inserts. Never place food directly into the tank.

Cleanliness of this appliance is essential to good sanitation. Read and follow all included cleaning instructions and schedules to ensure the safety of the food product.

Disconnect this appliance from electrical power before performing any maintenance or servicing.

This appliance is not jet stream approved. Do not direct water jet or steam jet at this appliance, or at any control panel or wiring. Do not splash or pour water on, in or over any controls, control panel or

wiring. Do not wash oor around this appliance with water or steam

jet.

The technical content of this manual, including any wiring diagrams,

schematics, parts breakdown illustrations and/or adjustment procedures, is intended for use by qualied technical personnel.

Any procedure which requires the use of tools must be performed by a

qualied technician.

This manual is considered to be a permanent part of the appliance. This manual and all supplied instructions, diagrams, schematics, parts breakdown illustrations, notices and labels must remain with the appliance if it is sold or moved to another location.

This appliance is made in the USA. Unless otherwise noted, this appliance uses all American-sized hardware.

WARNING:

ELECTRIC SHOCK HAZARD

All servicing requiring access to non-insulated electrical components must be performed by a factory authorized technician. DO NOT open any access panel which requires the use of tools. Failure to follow this warning can result in severe electrical

shock.

CAUTION:

RISK OF DAMAGE

DO NOT connect or energize this appliance until all installation instructions are read and followed. Damage to the appliance will result if the instructions are not followed.

M405 p/n 2M-305101 Owmers Manual Drop-In Refrigerated Cold Pans

AGENCY LISTING INFORMATION

STD 2

STD 7

UL471

This appliance performance tested to NSF Standard 7 for storage of potentially hazardous foods. This appliance meets NSF Standard 7 only when pan rails are installed in the lowest position, otherwise it meets NSF Standard 2.

RCP units are ETL listed for US and Canada

RCP units are evaluated to UL standard 471.

Components used in the manufacture of this unit are Underwriters Laboratory recognized.

M405 p/n 2M-305101 Owmers Manual Drop-In Refrigerated Cold Pans

+ 14 hidden pages