Wells RCP-7100 Installation Manual
SPECIFICATIONS
VOLTS
115
AMPS SINGLE PHASE
HP
LRA
1/4 5.515
38
MFS L1-N
REFRIGERANT
R-134-A 28 OZ
DESIGN PRESSURE
HIGH LOWQUANTITYTYPE
162440
INSTALLATION INSTRUCTIONS
REFRIGERATED COLD PAN
MODEL RCP-7100
POWER
SUPPLY
CORD
NEMA 5-15P
CUTOUT DETAILS
25 7/8
(657)
AIR
FLOW
17 7/8
(454)
ELECTRONIC
TEMPERATURE
CONTROLLER
PRODUCT DIMENSIONS
19 1/8
(486)
13 7/8
(352)
27 1/8
(689)
21 7/8
(556)
19 7/8
(505)
PLAN VIEW
11 7/8
(302)
REMOVEABLE
1-PIECE
PAN RAIL
AIR
FLOW
26 1/8
(664)
ADD
SUPPORTS
CLEARANCES
MINIMUM CLEARANCE REQUIRED FROM
UNIT TO THE NEAREST SURFACE.
BACK0SIDE1BOTTOMNAFRONT
0
FRONT VIEW
CONTROL SIDE OR
OPERATOR SIDE
INSTALLATION INSTRUCTIONS
INSTALLER MUST MEET CONDITIONS OF ACCEPTABILITY
OUTLINED BELOW UPON INSTALLATION:
1. This unit may be installed in stainless steel, wood, Formica,
or Corian tables and countertops.
2. This unit is shipped completely assembled and requires
only a 15 AMP dedicated grounded outlet (NEMA 5-15R) and
drain connection. Power cord and Power Switch should be
accessible from the front of the unit.
3. When installing the unit it is essential to provide
side openings twice the surface area of the condenser for
adequate air circulation. Louvered grills with proper size
may be placed in each opening.
TO INSTALL:
1. Lay out "cutout" dimensions on countertop or table.
2. Cut out hole and add stiffeners to support weight
as shown. Countertop must be flat and level before
installing cold pan.
3. Apply a generous bead of silicone sealant to underside of mounting flange before setting unit into cutout.
Remove any excess sealant from top flange and countertop.
4. Connect 1 inch drain to drain pan or floor drain.
Consult local codes for approved drain connections.
AIR
FLOW
17 5/8
(473)
POWER
SWITCH
WELLS/BLOOMFIELD * VERDI, NV
11 3/8
(289)
POWER
SUPPLY
CORD
3
(76)
5/16
(8)
1" NPT DRAIN
1
(25)
CROSS-SECTION OF COLD PAN
17
(432)
25 5/8
(651)
RIGHT SIDE VIEW
2 5/8
(67)
9 1/2
(241)
022403 FCN12397 305895-1 REV (-)
Loading...