Wells M4200-3 Service Manual

2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439

WELLS BLOOMFIELD, LLC

telephone: [phone]

fax: [phone]

www.wellsbloomfield.com

270

INSTALLATION INSTRUCTIONS

KIT# 22914

RETROFIT OVEN DOOR

A. REMOVE OLD DOOR AND STRIKE ASSEMBLIES

1. Remove oven top panel and lower front panel as required to
access door pivots. Retain all panels and screws for later
reinstallation.

2. Remove door. On left side of new door, retract hinge pins:
a. Remove and save two inner screws
b. Loosen two outer screws
c. Slide hinge pins into door
Remove and save hinge pins, brackets and screws.

3. Remove and save two screws holding strike assembly.
Discard strike assembly.

4. Remove and discard oven door gaskets.

5. Remove two screws holding upper pivot. Discard upper pivot.

REMOVE AND DISCARD

TOP

UPPER PIVOT ASSEMBLY

REMOVE AND SAVE

UPPER AND LOWER HINGE PIN,
BRACKETS AND SCREWS

CAUTION:

SHOCK HAZARD

Disconnect appliance from electric
power before opening any access
panel.

CAUTION:

BURN HAZARD

Allow appliance to cool completely
before servicing.

NOTE: DO NOT remove or discard
lower pivot.

REMOVE AND DISCARD

DOOR ASSEMBLY

REMOVE AND DISCARD

STRIKE ASSEMBLY

SAVE SCREWS

DO NOT REMOVE

LOWER HINGE PIVOT ASSEMBLY

p/n 305607 Rev. B ECN-13360 I 270 071023 cps

Page 1 of 3

CAUTION:

SHOCK HAZARD

Disconnect appliance from electric
power before opening any access
panel.

CAUTION:

BURN HAZARD

Allow appliance to cool completely
before servicing.

HINGE PIN

BRACKET

OUTER

HINGE

SCREWS

INNER
HINGE
SCREWS

B. PREPARE OVEN CAVITY

1. Examine oven door gaskets.

2. Install new set of oven door gaskets if old gaskets are worn,
warped, cracked or burnt.

C. INSTALL NEW DOOR ASSEMBLY

1. Clean as necessary all hinge pins, brackets and screws
saved from Step A.

2. Remove all packing materials and protective plastic from new
door assembly.

3. On left side of new door, loosely install hinge pins:
a. Slide hinge pins into door.
b. Install brackets and outer screws.
Do not tighten screws at this time.

4. Insert upper pivot bushing into hole in frame. Insert from the
bottom.

5. Set new door in place. Slide hinge pins out until they are fully
engaged in upper and lower pivots. Install inner screws, then
tighten.

6. Install strike. Flat side of strike mounts away from the oven
cavity.

UPPER PIVOT

BUSHING

STRIKE

LOWER
PIVOT
ASSEMBLY

Page 2 of 3