Welch Allyn 48850 User manual

Base

Diagnostic Instructions

Locking
Caster

Mobile Stand Assembly Instructions
Model 48850

Components

•Column (1)

•Base (1)

•Locking Casters (2)

•Non-Locking Casters (3)

•.25 inch (.64 cm) Lock Washer (1)

•.75 inch (1.9 cm) Flat Washer (1)

•Socket Head Bolt (1)

•Hex Socket Wrench (1)

Locking Caster

Figure 1

•.50 inch (1.27 cm) mounting screws (2)

Caster/Base Assembly Instructions (figure 1):

Push casters into the holes of the base until they “snap”
into place. Alternate casters as shown.

Base/Column Assembly Instructions (figure 2):

1. Insert column into center hole of base.

2. Insert .25 inch (.64 cm) lock washer, .75 inch (1.9 cm)
flat washer and 1 1/4” (3.2 cm) socket head bolt into
center hole. Tighten socket head bolt with hex socket
wrench.

.75 inch (1.9 cm)
Flat Washer

.25 inch (.64 cm)
Lock Washer

Socket Head Bolt

Hex Socket Wrench
(Allen Wrench)

Column

Base

Mounting Plate

Figure 2

Exam Light/Mounting Plate Instructions, see reverse.

Printed in USA Part No. 488057 Rev. B

Exam Light/Mounting Plate Instructions (figure 3):

1. Place the keyhole pins on the back of the Exam Light into the slots on the top of the mounting plate and slide down.

2. Line up the screw holes on the bottom of the Exam Light with the screw holes on the mounting plate .

3. Insert the .50 inch (1.27 cm) screws through the bottom of the mounting plate and tighten with a phillips head screw driver
(not included).

Exam Light

Keyhole
Pin in slot.

.50 inch (1.27 cm) mounting
screw

Figure 3

Welch Allyn, Inc.

4341 State Street Road

Skaneateles Falls, New York 13153-2002 USA

Telephone: [phone]

PO Box 220

Fax: [phone]