Weidmuller WI GTWY-9 User Manual
WI-GTWY-9
Antennas should be installed by experienced contractors.
SUP1
- +
or
2A
+
-
+ -
DC Relay Supply
wired as either inputs or
Installation Guide
FCC Notice
This device complies with Part 15.247 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference and
2) This device must accept any interference received, including
interference that may cause undesired operation
Host Protocol Connection
WARNING !
EXPLOSION HAZARD
DO NOT DISCONNECT
WHILE CIRCUIT IS LIVE
UNLESS AREA IS
KNOWN TO BE NON
HAZARDOUS
WIRELESS GATEWAY
SURGE
ARRESTOR
(OPTIONAL)
INSTALL AERIAL ABOVE
LOCAL OBSTRUCTIONS
COAXIAL CABLE
ANT
WIGTWY
GND
Aerial Installation
COLINEAR
ANTENNA
WEATHERPROOF
CONNECTORS WITH
“3M 23” TAPE
MAST
PROVIDE GOOD
GROUND
CONNECTION TO
MAST, MODULE
AND SURGE
ARRESTOR
1m minimum
STRESS RELIEF LOOP
EARTH STAKE
IF GROUND CONDITIONS ARE
POOR, INSTALL MORE THAN
ONE EARTH STAKE
NOTES
1. DIO channels can be
outputs.
2. All I/O must be SELV.
CAUTION!
For continued
protection against
risk of fire, replace
the module fuse only
with the same type
and rating
GND
SUP1
SUP2
WI-GTWY-9-xx
GND
GND
DIO1
SUP1
SUP2
GND DIO8 DIO7 DIO6 DIO5 DIO4 DIO3 DIO2
BAT+
SUP2
ANTENNA INSTALLATION
WI-GTWY-9 Installation
DC Supply
9-30VDC
16VA
Power supply: (A) 12-24VAC 16VA CSA Certified Class 2
(B) 9-30VDC 16VA CSA Certified Class 2
To Earth
Connection
(C) 13.8V Lead Acid Battery or Gel-cell
Choose option and wire as shown
Weidmuller Inc., v1.2
AC Supply 12-24VAC
Do not earth SUP1
SUP2 connections
Digital Input
Voltage Free
Contact
OR
Transistor
Device
Optional 12V
Backup Battery up
to 100 Amphour
To Earth
Connection
Digital Output
Max 30VDC, 500mA
Loading...