Weed Eater 530163346 User Manual

R Trademark

Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l’outil au détaillant.

1-800-554-6723

www.weedeater.com

Instruction Manual

Manual de Instrucciones

Manuel d’Instructions

XT 200/XT 25

FeatherLite

Wild ThingtWT21

Series

ENGLISH ESPAÑOL

For Occasional Use Only

WARNING:

Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury.

ADVERTENCIA:

Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves.

A VERTISSEMENT:

Lire le manuel d’instructions et bien respecter tous les avertissements ettoutesles instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves.

Electrolux Home Products, Inc. 250 Bobby Jones Expressway Augusta, GA 30907

CopyrightE2002 Electrolux Home Products, Inc.

530163346 12/5/02

FRANÇAIS

SAFETY RULES

WARNING:

appliances, basic safety precautions must always befollowed to reduce the risk of fire and serious injury. Read and follow all instructions.

This power unit can be dangerous!

responsible for following instructions and warnings on unit and in manual. Read entire instruction manual before using unit! Be thoroughly familiarwiththe controls andtheproperuse of the unit. Restrict the use of this unit to persons who have read, understand, and will follow the instructions and warnings on the unit and in the manual. Never allow children to operate this unit.

INSTRUCTION MANUAL

DANGER:

devices. This unit is designed for line trimmer use only. Use of any other accessories or attachments will increase the risk of injury.

WARNING:

jects violently.Youandotherscan beblinded/injured. Wear eye and leg protection. Keep body parts clear of rotating line.

Eye Protection

Boots

Keep children, bystanders, and animals 50 feet (15 meters) away. If approached stop unit immediately.

If situations occur which are not covered in this manual, use care and good judgment. If youneedassistance, contact your authorized service dealer or call 1-800-554--6723.

OPERATOR SAFETY

Dress properly. Always wear safety glasses

or similar eye protection when operating, or performing maintenance, on your unit (safety glasses areavailable). Eye protectionshould be marked Z87. Always wearface ordustmaskif operation is

dusty.

When using gardening

Operator is

SAFETY INFORMATION

ON THE UNIT

Neveruseblades or flailing

Trimme rline throws ob-

HazardZone

50 ft.

(15 m)

Alwayswearheavy, longpants,longsleeves,

boots, andgloves. Wearingsafetylegguards is recommended. Always wearfoot protection. Do not go bare-

foot or wear sandals. Stay clear of spinning line. Securehairaboveshoulderlength. Secureor

removeloose clothing or clothingwithloosely hanging ties, straps, tassels, etc. They can be caught in moving parts. Being fully covered also helps protect you

from debris and pieces of toxic plants thrown by spinning line. Stay Alert. Do not operate this unit when you

are tired, ill, upset orundertheinfluence ofalcohol, drugs, or medication. Watch what you are doing; use common sense. Wear hearing protection.

Never start or run inside a closed room or

building. Breathing exhaust fumes can kill. Keep handles free of oil and fuel.

UNIT / MAINTENANCE SAFETY

Disconnect the spark plug before performing

maintenance except carburetor adjustments. Look for and replace damaged or loose parts

before each use. Look for and repair fuel leaks before use. Keep in good working condition. Replace trimmerheadpartsthat arechipped,

cracked, broken, or damaged in any other way before using the unit. Maintain unit accordingtorecommended pro-

cedures. Keep cutting line at proper length. Use only 0.065!(1.65 mm) diameter Weed

Eater"brand line. Never use wire, rope, string, etc. Install required shield properly before using

the unit. Use only specified trimmer head; makesureit is properly installed andsecurely fastened. Make sure unit is assembled correctly as

shown in this manual. Make carburetor adjustments with lower end

supported to prevent line from contacting any object. Keep others away when making carburetor

adjustments. Use only recommended Weed Eater"ac-

cessories and replacement parts. Have all maintenance and service not ex-

plained inthismanualperformedbyanauthorized service dealer.

FUEL SAFETY

Mix and pour fuel outdoors.

Keep away from sparks or flames.

Use a container approved for fuel.

Do not smoke or allow smoking near fuel or

the unit. Avoidspilling fuel oroil. Wipe up all fuelspills.

Move at least 10 feet (3 meters) away from

fueling site before starting engine. Stop engine and allow to cool before remov-

ing fuel cap. Always store gasoline in a container ap-

proved for flammable liquids.

CUTTING SAFETY

WARNING:

each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by or become entangled in line. Hard objects can damage the trimmer head and be thrown causing serious injury.

Use only for trimming, scalping, mowing and

sweeping. Do not use for edging, pruning or hedge trimming. Keep firm footing and balance. Do not over-

reach. Keep all parts of your bodyawayfrommuf fler

and spinning line. Keep engine below waist level. A hot muffler can cause serious burns. Cut from yourrighttoyourleft. Cutting on left

side of the shield will throw debris away from the operator. Use only in daylight or good artificial light.

Use only for jobs explained in this manual.

Inspect the area before

TRANSPORTING AND STORAGE

Allow engine to cool; secure unit before stor-

ing or transporting in vehicle. Empty the fuel tank before storing or trans-

portingtheunit.Useup fuelleftinthe carburetorbystartingtheengineand letting it rununtil it stops. Store unit and fuel in area where fuel vapors

cannot reachsparksor openflamesfromwater heaters, electric motors or switches, furnaces, etc. Storeunitso line limiterbladecannot acciden-

tally causeinjury.Theunit canbehung bythe tube. Store unit out of reach of children.

SAFETY NOTICE:

through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swellings. Prolonged use in cold weather has beenlinked tobloodvesseldamage inotherwise healthy people. Ifsymptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seekmedical attention. An anti--vibration system does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condition of this tool.

SPECIAL NOTICE:

with a temperature limiting muffler and spark arresting screen which meets the requirements of California Codes 4442 and 4443. All U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington require by law that many internal combustion engines be equipped with asparkarresting screen. Ifyou operate inalocale where such regulations exist, you are legally responsible formaintaining the operating condition of these parts. Failure to do so is a violation of the law. For normal homeowner use, the muffler and sparkarresting screen will not require any service. After 50 hours of use, we recommend that your muffler beserviced orreplaced byyourauthorized service dealer.

Exposure to vibrations

This unit is equipped

ASSEMBLY

WARNING:

repeat all steps to ensure your unit isproperly assembled and all fasteners are secure.

Examine parts for damage. Do not use damaged parts.

NOTE:

missing or damaged, call 1-800-554-6723. It is normal for the fuel filter to rattle in the

empty fuel tank. Finding fuel or oil residue on muffler is normal

due to carburetor adjustments and testing done by the manufacturer.

If you need assistance or find parts

ADJUSTING THE HANDLE

WARNING:

dle, be sure it remains between the trigger and the safety label.

1. Loosen wing nut on handle.

2. Rotate the handle on the tube to an upright position; retighten wing nut.

ATTACHING SHIELD

WARNING:

erly installed. The shield providespartialprotection from the riskofthrownobjectsto theopera-

If received assembled,

When adjusting the han-

The shield must be prop-

tor and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on underside of shield) is sharp and can cut you.

For proper orientation of shield, see KNOW YOUR TRIMMER illustration in OPERATION section. Assemble your shield (Style A or B)as shown.

STYLE A

1. Remove wing nut from shield.

2. Insert bracket into slot as shown.

3. Pivot shield untilboltpassesthrough holein bracket.

4. Securely tighten wing nut onto bolt.

Slot

Shield

Bracket

Wing

Line Limiter Blade

Nut

STYLE B

1. Remove washer and wing nut from shield.

2. Assemble parts as shown in illustration.

3. Securely tighten wing nut onto bolt.

Shield

NOTE:

and use washer and wing nut from this bolt for assembling shield.

Remove

Line Limiter

Blade

Wing Nut

Washer

OPERATION

KNOW YOUR TRIMMER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT.

Comparethe illustrations withyourunit to familiarizeyours elfwith the location of the variouscon tr o ls

and adjustments. Save this manual for future reference.

STYLE A

Throttle Trigger

Assist Handle

Shield

Line Limiter Blade

Starter Rope Handle

Tube

STYLE B

Throttle Trigger

Trimmer Head

ON/STOP Switch

Assist Handle

Tube

Trimmer Head

Shield

Line Limiter Blade

Spark Plug

Choke Lever

ON/STOP SWITCH

TheON/STOPswitch is used tostop engine.To stop the engine, push and release the engine ON/STOP switch.

PRIMER BULB

The PRIMER BULB removes airfromthe carburetor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate the primer bulb by pressing it and allowing it to return to its original form.

Primer Bulb

Fuel Mix Fill Cap

CHOKE

The CHOKE helps to supply fuel to the engine to aid in cold starting. Activate the choke by moving the choke lever to the FULL CHOKE position. Aftertheengineattempts to start,move the choke lever to the HALF CHOKE position. Once engine hasstarted, movethechokelever to the OFF CHOKE position.

+ 7 hidden pages