Webasto ALTOX WBUS-4 Owner's Manual

Owner’s manual

GSM control module Webasto

ALTOX WBUS-4

 control heaters Webasto o n protocol WBUS
 manage any heaters by analog signal
 automatically id ent ify type of hea ter
 DTMF, SMS, TCP commands and voice menu (optional)
 manage and co ntrol by mobile Web-
 processin g any USSD-requests from device SIM-card
 start heater from car interior by pressing the button
 all adjustments are done by SMS commands
 SMS message about the heater Webasto status
 manage the Webasto work by temperature
 reading and erasing errors of Webasto heaters

application

2014

1. Operation descripti on

Led NET

Description

1. Light is on constantly

Checking SIM, find and register i n the net work

2. Flashes 1 time in 3sec.

Standby mode (connected)

3. Flashes 1 time in 5sec.

Set GPRS connects/RING/SMS/USSD

Getting started

1. Before insert a SIM-card set to off PIN-code request. Insert and change
SIM-card when the device is off power supply.

2. The first income call number is saved automatically into the sell num1 (the
sell num1 shou ld be empt y).

3. The device processes USSD-commands only in Latin alphabet, in case reply
by numbers, request the operator to change the encoding to the transliteration.

4. The defau lt setup is "heater_type0" - automatically identifies type of
connected heater (digital TTC/TTV or analog).

5. Summer mode – heater_type7 (only interior ventilation control).

6. Setup "bind1" sets interfacing with other controls Webasto (GSM module
activated heater, Timer 1533 deactivated).

7. When using the fixed-type button (setup key0) the heater will not tur n of f
automatically at time expiration "time1".

8. At "setsms1" the user gets SMS about start an d s top Webasto.

9. At "errorsms1" the user gets SMS a bout errors of Webasto work.

10. Before set up function of control heater temperature (if the value is above
"temp_high" - Webasto stops, if lower "temp_low" – starts), request the status
message, to contr ol the precise defin ition by the d evi ce temperature of the
Webasto heater.
Mobile Web-application (description: http://altox.by/mobile_webasto)

1. To activate GPRS - input the APN of acce s s point SIM-card operator of the
device (see setup apn1, apn2, apn3). To deactivate GPRS - delete APN access
point, by sending SMS command "apn1:".

2. All setup GPRS changes will come into force after one minute.

3. Size of TCP-packs: ping -

less 10byte, status - less 100byte.

Incoming call

At "voice0" (voice is off) an d incoming call of saved number, the call is
rejected, but Webasto starts (1beep) / stops (2 beeps).
If the number is not saved /not identified, the call is rejected only.
At "voice1" (voice menu is on) possible to in put DTMF-commands:

o Activate/deactivate the heater – push 1.
o Request a balance – push 2.
o Request a status – push 3.

After one minute the connection automatically discontinued.

Page 2