Watts WP24B User Manual

For Residential and Commercial Applications

ES-WP-BrassTestPlugs

Job Name

Job Location

Engineer

Approval

Brass CrimpRing

–––––––––––––––––––––––––––––––––––––––––––

–––––––––––––––––––––––––––––––––––––––––

–––––––––––––––––––––––––––––––––––––––––––––

™

Test Plugs

Brass CrimpRing™Test Plugs are used for pressure testing the system.

Specifications

System shall be plumbed using Watts WaterPEX®cross-linked polyethylene pipe, and all joints shall be made using Watts brass CrimpRing either the Watts copper CrimpRing CinchClamp WaterPEX

Installation Note

CrimpRing™Test Plugs must be installed in accordance with all Watts WaterPEX provided in WaterPEX

™

and/or polyalloy CrimpRing™fittings using

™

* crimping methods as outlined in the Watts

Installation Guidelines.

installation procedures, including information

installation manual and guidelines.

™

or stainless steel

Contractor

Approval

Contractor’s P.O. No.

Representative

––––––––––––––––––––––––––––––––––––––––––––

–––––––––––––––––––––––––––––––––––––––––––––

––––––––––––––––––––––––––––––––––––––––

–––––––––––––––––––––––––––––––––––

WP24

CrimpRing™Test Plug

Approvals

• Manufactured in accordance with American Society for Testing and Materials (ASTM) F-877 and F-1807

• Listed by the National Sanitation Foundation to NSF Standards 14 and 61 for use in potable water systems

• Listed by NSF to be in compliant to the Uniform Plumbing Code

• Labeled B137.5 which indicates that it is compliant to the CSA Standards B137.5

Dimensions – Weights

MODEL CONNECTION PKG. WEIGHT

in. mm type lbs. kgs.

WP24B-06PB3⁄8 10 Crimp Fitting 1 0.4 WP24B-08PB1⁄2 15 Crimp Fitting 1 0.4 WP24B-12PB3⁄4 20 Crimp Fitting 2 0.9 WP24B-16PB 1 25 Crimp Fitting 2 0.9

Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements, please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials without prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.

* Note: Watts WaterPEX CinchClamp™fittings should not be

used with wrot copper PEX fittings.

arning!

If connections must be made in temperatures below 30°F, caution must be taken to allow the WaterPEX to form a proper seal against the barb. Apply the connection slowly to ensure the PEX material conforms to the barb.

USA: 815 Chestnut St., No. Andover, MA 01845-6098; www.watts.com Canada: 5435 North Service Rd., Burlington, ONT. L7L 5H7; www.wattscanada.ca

WaterPEX Plumbing Products