Water Creation F5001001AL User Manual

TOOLS AND MATERIALS

MODEL: F5-0010

FAUCET INSTALLATION GUIDE

BEFORE YOU BEGIN

1) Shut off water supply.

2) Carefully inspect waste and supply tubing for signs of damage.

3) Replace waste or supply tubing if necessary

A) FAUCET INSTALLATION

1) Set the faucet in place, insert the inlet shanks through the sink holes
and press down.

2) Assemble the washers and locknuts on the inlet shanks, then tighten the
lock nut with wrench. Do not over tighten.

3) Set the sprayer holder in place, insert the shank through sink hole.

4) Assemble the washer and locknut on the shank, then tighten the lock nut
with wrench. Do not over tighten.

Basin Wrench

Pipe Wrench

Adjustable wrench

Screwdriver

Teflon Tape

Flexible Water
Supply Line

B) SPRAYER INSTALLATION

1) Hand tighten the sprayer with hose together.

2) Insert the hose through the sprayer holder under to sink.

3) Connect the hose to faucet inlet and tighten with wrench.
Do not over tighten.

C) SUPPLY CONNECTION

1) Connect hoses (not included) to angle stops.

2) Tighten all connections.

3) Flush out water for two minutes before connect hose to faucet shank

MODEL: F5-0010

D) FINAL INSPECTION

1) Ensure all connections are tightened properly.

2) Turn on main water supply.

3) Turn on and off cold and hot water respectively.

4) Turn on both hot and cold water and turn off. Check for leaks.

5) Remove the aerator cap and aerator. Check for debris. Clean if necessary .

6) Reinstall aerator.