Wasp Bar Code LabelWriter 330 User Manual

e. Navigate to Start>Printers and Faxes. On

the Printers and Faxes screen, right click on
the Wasp LabelWriter 330 Turbo-USB, then
select Properties:

g. While the test page is printing, a screen

similar to the following appears. Click OK
on the screen if the test page prints
correctly.

Wasp

LabelWriter 330

Turbo Printer

The Properties screen appears.

f. On the Properties screen, click Print Test

Page:

If it does not print correctly, click
Troubleshoot to access the Printer Help
and Support Page.

Note: The test page will consist of a
Windows Logo. The logo will appear
partially cut off on the label. This is
normal and should be a successfully
printed test page.

Quick Start

Guide

# 000000

© 2006 Wasp Technologies

Setting up the 330 Turbo Printer

1. Unpack

Remove the printer from the box and place it
on a stable, flat surface. The box will contain:

• Printer

• Power cord and adapter

• USB Cable

• 1 roll of labels

• Installation CD with printable documentation

2. Connect the Power

a. Plug the power cord into the power adapter

and then to the bottom of the printer (see
figure in Step 3).

b. Plug the wall plug into a grounded and surge

protected outlet or power strip.

3. Connect the USB Cable

a. Plug the USB cable into the USB Port on the

bottom of the printer:

USB

Power

The Found New Hardware Wizard will
appear.

4. Install the Printer

a. Insert the Installation CD. On the Found

New Hardware Wizard screen, click No, Not
This Time, then click Next:

b. Select Install the Software Automatically,

then click Next.

The install wizard will automatically search
for the Installation CD.

c. You may receive a message similar to the

one shown below:

If you receive this message, click Continue
Anyway to proceed with the installation.

The software will install.

d. When the installation is complete, click

Finish:

Cable Channel

b. Insert the power and USB cables into the

cable channel and set the printer down on
your work surface.

c. Plug the USB cable into an available USB

port on your computer. A message similar to
the following will appear: