OFFICIAL WARWICK
AMP OWNER MANUAL
BLUE CAB 15.1 - BLUE CAB 30.1 - BLUE CAB 60.1
Congratulations on the purchase of your new Warwick combo. Please read through these instructions before connecting and operating the device. Following the guidelines you will soon will benefit from your new
Warwick amplifier. Please keep this instruction booklet handy in case you need to consult it again. Please
send the PASSPORT to the address indicated therein.
IINNDDEEXX
Protective Circuits 5
Blue Cab 15.1 7
Blue Cab 30.1 8
Blue Cab 60.1 9
Suffix
Technical Data 102
Schematic Diagrams
Blue Cab 15.1 103
Blue Cab 30.1 104
Blue Cab 30.1 105
EENNGGLLIISSHH
SAFETY HINTS
!
- Please read these instructions
- Please heed all warnings
Caution: To reduce the risk of electric shock, do
not open the amplifier’s case. Avoid exposure to
rain or moisture. No user serviceable parts inside,
refer all service to a qualified technician. No vessel filled with liquids, such as vases shall be placed on top of the unit.
This symbol, wherever it appears, alerts you to
the presence of dangerous non-insulated voltage
inside the case. Risk of electric shock!
This symbol, wherever it appears, indicates to
important operating and maintenance instructions in this user manual. Please read the manual.
This recycling logo informs the end user that it is
forbidden to throw away the product in the trash.
It has to be disposed of accordingly.
Weee-Nr.: DE93670540
CB Approved
EENNGGLLIISSHH
4
GENERAL INFORMATION
For safe and reliable operation please follow these instructions:
•DO NOT open the amplifier case! You might receive an electrical shock. For any repair refer to qualified service personnel.
•Avoid dust, excessive moisture, direct sunlight and extremely high or low temperatures.
•Safeguard the device from impact. Always place the unit on a stable and horizontal surface.
•Do not block any of the ventilation openings.
•Avoid leaving the unit near radiators or other heat producing devices.
•Internal components should be adjusted or cleaned by qualified service technicians only. Make sure no object or liquid penetrates the device through its cooling vents.
•Fuse must be replaced with one of the same type and value to avoid damaging the amplifier.
•the mains cable or mains switch have been damaged,
•objects or liquids have penetrated the device,
•it has been exposed to excessive moisture,
•malfunctions or abnormal operating conditions have occurred,
•the device has been dropped or the case has been damaged.
Have the device examined by a qualified service technician in the following cases:
- Make sure the unit is plugged into a socket outlet with a protective grounding connection.
- Mains plug must be accessible at any time to disconnect it from mains in case of abnormal operation.
- If the device shows any malfunction, immediately disconnect the mains cable from the mains socket.
- Use effects pedals only between the instrument and the amplifier since these devices do not meet the electrical specifications
of the effects loop.
- Unplug the unit whenever changing a fuse.
- Replace fuse only with one of the same type and value. Never bridge defective fuses.
5
EENNGGLLIISSHH
GETTING STARTED
1. Make sure that the mains lead is connected and all external devices (effects) are properly connected and working.
2. Set the VOLUME control (Blue Cab 15.1, 30.1, 60.1) / MASTER control (Sweet 15.3, 25.2) to zero.
3. Plug your bass guitar into the amplifier's INPUT using a shielded cable.
4. Press the POWER switch to turn the device on.
5. Switch off MUTE - the red LED will turn off. (Sweet 15.3, 25.2)
6. Turn up all volume controls of your bass guitar.
7. Adjust the GAIN control until the clip LED flashes. (Sweet 15.3, 25.2)
8. Set VOLUME control (Blue Cab 15.1, 30.1, 60.1) / MASTER contol (Sweet 15.3, 25.2) to your desired volume.
9. Use the sound controls / switches to adjust the sound as described in the respective chapters FRONT PANEL CONTROLS.
10. If necessary readjust the GAIN. (Sweet 15.3, 25.2)
EENNGGLLIISSHH
6
FRONT PANEL CONTROLS
INPUT socket to plug in a bass guitar.
VOLUME control to determine the main volume level.
BASS control to boost / cut deep frequencies.
MID control to boost / cut mid frequencies.
TREBLE control to boost / cut high frequencies.
PHONES socket for connecting headphones (min 200 Ohm).
POWER switch for turning the amplifier on and off.
REAR PANEL
MAINS IN AC terminal with integrated fuse compartment for connecting the amplifier to mains.
EFF. LOOP for the insertion of an effects unit.
Connect EFF. SEND with the input and EFF. RETURN with the output of the effects device. The rear stand allows for a 45-degree
tilt of the amplifier.
7
EENNGGLLIISSHH BBLLUUEE CCAABB 1155..11
FRONT PANEL CONTROLS
PASSIVE IN socket to plug in a passive bass guitar.
ACTIVE IN socket to plug in an active bass guitar.
VOLUME control to determine the main volume level.
BASS control to boost / cut deep frequencies.
MID control to boost / cut mid frequencies.
TREBLE control to boost / cut high frequencies.
LINE OUT socket allows connecting additional power amplifiers, active cabinets or a mixing console.
PHONES socket for connecting headphones (min 200 Ohm).
POWER switch for turning the amplifier on and off.
REAR PANEL
MAINS IN AC terminal with integrated fuse compartment for connecting the amplifier to mains.
EFF. LOOP for the insertion of an effects unit.
Connect EFF. SEND with the input and EFF. RETURN with the output of the effect device. The rear stand allows for a 45-degree tilt
of the amplifier.
EENNGGLLIISSHH BBLLUUEE CCAABB 3300..11
8
FRONT PANEL CONTROLS
PASSIVE IN socket to plug in a passive bass guitar.
ACTIVE IN socket to plug in an active bass guitar.
VOLUME control to determine the main volume level.
BASS control to boost / cut deep frequencies.
MID control to boost / cut mid frequencies.
TREBLE control to boost / cut high frequencies.
AUX. LEVEL control determines the level of the sound source which is connected to the AUX IN socket.
AUX. IN Cinch socket (RCA jack) allows connecting auxiliary stereo sound sources with line output level (0 dB),
such as CD players.
LINE OUT socket allows to connect additional power amplifiers, active cabinets or a mixing console.
PHONES socket for connecting headphones (min 200 Ohm).
POWER switch for turning the amplifier on and off.
REAR PANEL
MAINS IN AC terminal with integrated fuse compartment for connecting the amplifier to mains.
EFF. LOOP for the insertion of an effects unit.
Connect EFF. SEND with the input and EFF. RETURN with the output of the effect device. The rear stand allows for a 45-degree tilt
of the amplifier.
9
EENNGGLLIISSHH BBLLUUEE CCAABB 6600..11
TECHNICAL DATA
BLUE CAB 15.1 BLUE CAB 30.1 BLUE CAB 60.1
INPUT 25 mV act. 25 mV
PREAMP transistor transistor transistor
POWER AMP convection cooled convection cooled fan cooled
SPEAKER 8” 10” 12”
EQUALIZER BASS, MID, TREB BASS, MID, TREB BASS, MID, TREB
COMPRESSOR - - -
HEADPHONE min 200 Ohm min 200 Ohm min 200 Ohm
EFFECT LOOP mono serial
REAR CONTROL
NOMINAL POWER 50 Watt 100 Watt 150 Watt
THD < 0.1% < 0.1% < 0.1%
WEIGHT
(NET / GROSS, kg)
DIMENSIONS COMBO
(cm)
DIMENSIONS CART.
BOX (cm)
send 0 dBu, 600 Ohm
return 0 dBu, 10 kOhm
10 / 13 15 / 18.5 19 / 22.5
30 x 25 x 39 34 x 33 x 41 40 x 33 x 51
37 x 32 x 50 41 x 40 x 52 46 x 40 x 62
pass. 50 mV
mono serial
send 0 dBu, 600 Ohm
return 0 dBu, 10 kOhm
act. 25 mV
pass. 50 mV
mono serial
send 0 dBu, 600 Ohm
return 0 dBu, 10 kOhm
10
CIRCUIT DIAGRAM
103
BBLLUUEE CCAABB 1155..11
CIRCUIT DIAGRAM
104
BBLLUUEE CCAABB 3300..11
CIRCUIT DIAGRAM
105
BBLLUUEE CCAABB 6600..11
Please see the new Warwick Bass Forum on www.warwick.de
For support information please refer to support@warwick.de
Headquarters: Warwick GmbH&Co.Music Equipment KG • Gewerbegeb iet Wohlhausen • 08258 Markneukirchen/Germany • E-Mail : info@warwick.de
Branch China: Warwick Music Equipment (Shanghai) Ltd., Co.•Shanghai Waigaoqiao Free Trade Zone • Shanghai 200131/P.R.China • E-Mail: info@warwick.cn
Branch UK: Warwick Music Equipment Trading (Manchester UK) Ltd. • 75 Bridge Street • Manchester M3 2RH / Great Britain • E-Mail: info@warwickbass.co.uk
Branch Switzer land: War wick Music Equipment Tradin g (Zurich) GmbH • Kriesbachstra sse 30 • 8600 Dübendorf / Swit zerland • E-Mail: inf o@warwick .ch
Branch CZ: Warwick Music Equipment Trading (Pr aha CZ) s.r.o. • Spá lená 23/ 93 • 11000 Praha 1 / Czech Republic • E-Mail : inf o@w ar wic k.cz
Visit us on the World Wide Web: http://www.warwick.de
Loading...