One Shot Octal So cket
Pow er Su pply WSCC-102
P-239-38
819-0400
Installation Instructions
Part Number
901-00-019
Installation Instructions
Part # 901-00-019
Failure to follow these
instructions may result in product damage,
equipment damage, and serious or fatal injury
to personnel.
Introduction
Warner Electric's One Shot Octal Socket Power
Supply is a plug-in clutch/brake control
designed for operation of AC or DC wrap spring
clutches and brakes. The One Shot provides a
single voltage pulse of 160 or 325 VDC for
approximately 15MS, whether the customer
supplied switch is momentarily closed or held
closed, and can be used with all 12VDC, 24VDC,
90VDC, and 115VAC D-frame solenoid operated
products that contain an Actuator Limit Stop
option.
Solenoid
12 VDC
24 VDC
90 VDC
115 VDC
V
Input
120 200 CPM
240 35 CPM
120 300 CPM
240 40 CPM
120 400 CPM
240 60 CPM
120 350 CPM
240 45 CPM
Maximum Cycle
ate
R
AC
Table 1
Installation
1. Connect the two leads from the wrap spring
solenoid to terminals 6 and 7 of the octal
socket.
2. Connect the common of the relay to terminal
1 of the socket, the normally closed to
terminal 2, and the normally open to
terminal 8.
The One Shot Power Supply is UL Listed when
used with Warner Electric's octal socket, part no.
6001-101-001, or DIN rail mount octal socket,
part no. 6001-101-002 (each purchased
separately) and only UL Recognized when used
with other sockets. This unit may be mounted in
any convenient position using the two mounting
holes provided on the socket.
Specifications
Input: 120/240 VAC, 50/60 Hz
Output: 160/290 VDC peak
5 amps max. load
Ambient Temp.: +32° to +122°F (0° to 50°C)
Cycle Rate: The maximum cycle rate is
400 CPM*.
*See Table 1 for maximum cycle rates by input
and solenoid
3. Connect the HOT AC input wire to terminal
3 of the socket and the neutral wire to
terminal 4.
Reorder Information
Model Part No.
One Shot Power Supply 901-00-019
Octal Socket 6001-101-001
DIN Rail Mount Octal Socket 6001-101-002
Warner Electric’s Complete
Line of Wrap Spring Products
Series Torque Models
Ratings
Standard CB
Super CB
(SCB)
from 25 lb.in CB-2, CB-4,
to 2,500 lb.in CB-5, CB-6
and CB-8
from 250 lb.in Super CB-5,
to 2,500 lb.in Super CB-6
and Super CB-8
WSC
Controls
2
Warner Electric • 800-825-9050 P-239-38 • 819-0400
from 25 lb.in WSC-2, WSC-4,
to 2,500 lb.in WSC-5, WSC-6
and WSC-8
One Shot Power Supply WSCC101 and One Shot Octal Socket
Power Supply WSCC-102
1.97"
1.7"
2.4"
(49.5)
(43.2)
(61)
2.39"
1.57"
.70"
(39.9)
(60.7)
(17.8)
1.57" 2.40"
.71"
(18)
(39.9) (61)
1.57"
(39.9)
1.57"
(39.9)
2.40"
(61)
.71"
(18)
2.39"
(60.7)
.70"
(17.8)
6
43
5
7
12
8
OCTAL SOCKET
WRAP
SPRING
CLUTCH
COIL
HOT
NEUT
NC
NO
C
120/240 VAC
NOTE: Actuator Limit Stop required when
using the One Shot Power Supply
Connection Diagram
Dimensions
Figure 1
NOTE: Unit is 1.97” square
Note: All dimensions are nominal (millimeters).
Warner Electric • 800-825-9050 P-239-38 • 819-0400
Figure 2
3
Warranty
Warner Electric LLC warrants that it will repair or replace (whichever it deems advisable) any
product manufactured and sold by it which proves to be defective in material or workmanship
within a period of one (1) year from the date of original purchase for consumer, commercial or
industrial use.
This warranty extends only to the original purchaser and is not transferable or assignable without
Warner Electric LLC’s prior consent.
Warranty service can be obtained in the U.S.A. by returning any defective product, transportation
charges prepaid, to the appropriate Warner Electric LLC factory. Additional warranty information
may be obtained by writing the Customer Satisfaction Department, Warner Electric LLC, 449
Gardner Street, South Beloit, Illinois 61080, or by calling 815-389-3771.
A purchase receipt or other proof of original purchase will be required before warranty service is
rendered. If found defective under the terms of this warranty, repair or replacement will be made,
without charge, together with a refund for transportation costs. If found not to be defective, you
will be notied and, with your consent, the item will be repaired or replaced and returned to you
at your expense.
This warranty covers normal use and does not cover damage or defect which results from
alteration, accident, neglect, or improper installation, operation, or maintenance.
Some states do not allow limitation on how long an implied warranty lasts, so the above limitation
may not apply to you.
Warner Electric LLC’s obligation under this warranty is limited to the repair or replacement of the
defective product and in no event shall Warner Electric LLC be liable for consequential, indirect,
or incidental damages of any kind incurred by reason of the manufacture, sale or use of any
defective product. Warner Electric LLC neither assumes nor authorizes any other person to give
any other warranty or to assume any other obligation or liability on its behalf.
WITH RESPECT TO CONSUMER USE OF THE PRODUCT, ANY IMPLIED WARRANTIES WHICH
THE CONSUMER MAY HAVE ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF
ORIGINAL CONSUMER PURCHASE. WITH RESPECT TO COMMERCIAL AND INDUSTRIAL
USES OF THE PRODUCT, THE FOREGOING WARRANTY IS IN LIEU OF AND EXCLUDES ALL
OTHER WARRANTIES, WHETHER EXPRESSED OR IMPLIED BY OPERATION OF LAW OR
OTHERWISE, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so
the above limitation or exclusion may not apply to you. This warranty gives you specic legal
rights and you may also have other rights which vary from state to state.
Changes in Dimensions and Specifications
All dimensions and specications shown in Warner Electric catalogs are subject to change without
notice. Weights do not include weight of boxing for shipment. Certied prints will be furnished
without charge on request to Warner Electric.
Warner Electric LLC
31 Industrial Park Road • New Hartford, CT 06057
815-389-3771 • Fax: 815-389-2582
www.warnerelectric.com
P-239 -38 • 819 -040 0 11/07 Pr inte d in U S A
Loading...