9 volt DC, Center Neg. 100ma min*
Output Jack |
Input Jack |
|
|
Mode Switch Secondary
Function:
Wave shape selection
Depth knob Secondary
Function:
Modulation Rate
Bypass LED |
|
|
|
|
|
|
|
||
Bypass Switch/ |
|
|
|
Sustain Switch |
|
|
|||
Secondary Function |
|
|
||
SECONDARY FUNCTIONS – To access the secondary functions, with the pedal engaged, hold down the bypass switch and use the toggle to select the desired wave shape, and the depth knob to set the desired rate. The pedal remembers the wave shape and rate settings for the current algorithm until the next time they are modified. The pedal also maintains the algorithm and depth setting when modifying secondary functions.
TRAILS MODE – The Slö can run in trails or no trails mode. In trails mode, when you turn the pedal off, the reverb decay dies off naturally. In no trails mode, the decay is abruptly cut off when you turn the pedal off. To toggle between either mode, hold down the bypass switch for 1 second while applying power to the pedal. Unplug power and repeat to toggle to the other mode.
FACTORY RESET – To perform a factory reset, hold down the sustain switch for 1 second while applying power to the pedal. When the LED illuminates, the wave shape and rate for each algorithm is now set to default. The default rate for all algorithms is approximately 9 o’clock on the depth knob. The default wave shape are as follows:
Dark - Sink // Rise - Sine // Dream - Sink.
WALRUSAUDIO.COM
*The use of an isolated power supply is recommended for powering all Walrus Audio Pedals. |
Got questions? Shoot us an email at customerservice@walrusaudio.com. Need a repair? All our pedals come |
with a limited lifetime warranty. Email repairs@walrusaudio.com should your pedal need a tune up, or visit |
|
Daisy chain power supplies are not recommended. |
walrusaudio.com/pages/warranty-and-repair for more info. For life advice, refer to Buzzfeed’s top 10 lists. |
Loading...