5-5STATUS LED ............................................................................................................................................................... 7
6. ACCESSORIES AND OPTIONAL SERIAL KIT ........................................................................................8
6-1ACCESSORY LIST (STU-500B) .................................................................................................................................... 8
6-2OPTIONAL SERIAL KIT (FUZ-A147-01/-02/-03) ........................................................................................................... 8
8. REPLACING THE PEN TIP ......................................................................................................................... 14
9. HOW TO INSTALL PEN TETHER .............................................................................................................. 15
1
WACOM Co., Ltd.
1. Scope
This instruction manual applies to the LCD Signature tablet STU-500B.
2. Summary
The Wacom® STU-500B LCD signature tablet combines the benefi ts of a liquid crystaldisplay (LCD) with
the control, comfort, and productivity of Wacom’s cordless, batteryfree pen technology. This gives you a
direct pen-on-screen interface that leads to a truer pen-on-paper writing experience.
The basic components of the LCD signature tablet include a Wacom pen tablet internally mounted behind a
5" diagonal TFT monochrome LCD display, and a Wacom pen.
The LCD signature tablet is equipped with a USB and RS-232C interfaces.
3. Precautions on use and handling
Be sure to follow all instructions, cautions, and warnings found within this guide.
Failure to do so could cause the loss of data or damage to your computer. Failure to do so could also void
your warranty, in which case Wacom shall have no responsibility to repair or replace the product.
Usage
WARNING
Do not use the STU-500B LCD signature tablet in a facility control system that requires extremely
high reliability; it may cause other electronic devices to malfunction, or other devices may cause the LCD
signature tab let to malfunction.
Where use is prohibited, power off the STU-500B to prevent the possibility of it causing other electronic
devices to malfunction. Wacom does not accept any liability for direct or consequential damages.
For details, please refer to your Warranty located at the end of this guide.
Environment
Temperature and humidity
Operating temperature and humidity: 5° to 35°C, 20 to 80% RH
Storage temperature and humidity: -10° to 60°C, 20 to 90% RH
CAUTION
Do not use or store the LCD signature tablet where:
Temperature changes are severe or exceed specifications (e.g., outdoors or inside a vehicle).
The LCD signature tablet and pen are exposed to direct sunlight or heat from an appliance, or are
exposed to water or any other kind of liquid.
Do not use the LCD signature tablet in a dusty environment; this may damage the unit.
2
WACOM Co., Ltd.
Handling
WARNING
If using a power adapter with the STU-500B, only use the power adapter (Serial kit FUZ-A147) that
designed for use with the STU-500B.
If a different type of power adapter is used, the LCD signature tablet will not work properly or may be
damaged. Using a different type of power adapter also has the potential to result in fi re. Use of a different
power adapter will void your warranty.
When not using the LCD signature tablet for long periods of time, unplug the power adapter from the AC
outlet.
WARNING
High Voltage. Do not open or disassemble the STU-500B LCD signature tablet.
There is a risk of electrical shock when the casing is open. This will also void your warranty and
Wacom shall have no responsibility to repair or replace the product.
If the LCD screen has been damaged, DO NOT touch any liquid that may be leaking from it; this liquid
is an irritant. In case of contact with skin, eyes, or mouth,
rinse immediately with running water for at least 15 minutes or more. If contact is made with the eyes or
mouth, also consult a physician.
Prevent children from swallowing the pen tip. The pen tip may accidentally be pulled out if children are
biting on them.
CAUTION
Do not disassemble the pen. This may cause the device to malfunction. In this case, Wacom shall have
no responsibility to repair or replace the product.
Do not scratch the display screen. Avoid placing sharp objects on the display screen surface.
Avoid intensive shock or vibration to the STU-500B or the pen. Hitting or dropping the LCD signature
tablet may damage the display screen or other components.
Do not put heavy articles on the LCD signature tablet or push against it with a strong force; This may
damage the display screen.
Do not place heavy articles on the STU-500B cabling, repeatedly bend the cables sharply, or apply
heavy stress to the cable connectors; this may damage the unit or cabling.
If the pen tip becomes sharp or angular, it may damage the coating on the display screen. Please
replace the pen tip if necessary.
Do not use any organic solvent (e.g., alcohol) or even mild detergent to clean the display screen.
Use of these cleaners can damage the coating on the screen.
Please note that damage of this kind is not covered by the manufacturer's warranty.
To clean the display screen, use an anti-static cloth or a slightly damp cloth. When cleaning, apply only
a light amount of pressure to the display screen and do not make the surface wet.
To clean the LCD signature tablet casing or pen, use a soft cloth with mild detergent (such as dish
washing liquid) diluted with water.
Do not expose the STU-500B to high voltage electrostatic discharges or to a build-up of an
electrostatic charge on the LCD screen. This may result in a temporary blotching of the LCD monitor. If
3
WACOM Co., Ltd.
blotching occurs, leave the STU-500B’s display on and the blotching should disappear within a few hours.
Wacom LCD signature tablet products comply with the European Union RoHS Directive 2002/95/EC (RoHS
Directive).
Federal Communications Commission (FCC) notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
You can determine whether the equipment is causing interference by powering it off. If the interference
stops, it was probably caused by the equipment.
If the equipment does cause interference to radio or television reception, you may be able to correct the
interference by using one or more of the following measures:
• Rotate the television or radio antenna until the interference stops.
• Move the equipment farther away from the television or radio.
• Plug the equipment and computer into an outlet that is on a different circuit from the television or radio.
If necessary, consult your Wacom dealer or an experienced radio/television technician for help.
Changes or modifications to this product not authorized by Wacom could void the FCC Certification and
negate your authority to operate the product.
INDUSTRY CANADA (CANADA ONLY)
Industry Canada, Class B
“This Class (B) digital apparatus complies with Canadian ICES-003”
“Cet appareil numérique de la classe (B) est conforme à la norme NMB-003 du Canada.”
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the
device.
RF exposure compliance
1) To comply with FCC/IC RF exposure compliance requirements, a separation distance of at least 20 cm
must be maintained between the antenna of this device and all persons.
4
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.