V-ZUG GS60SZGVI Installation Guide

Dishwasher

EN – Installation instructions

Before installation, please read the safety precautions on the reverse side!

>40

Appliance components

Recess for pipes

>80

>40 × 80 mm

Front panel/decorative system Base

Water tap Power socket

Drain pipe

Drain trap connection

Aqua-Stop/inlet pipe

Mains connection

J163113-R06

Dishwasher

EN – Installation instructions

EN Safety precautions

Only move unpacked appliances using gloves. Do not lift appliance when on the plinth.

Do not press on the sides or top of the appliance.

Any old water supply and drain pipes must always be replaced with new ones.

Always observe the local water supply authority’s regulations.

Extending the water supply and drain pipes and mains cable is not permitted. Consult customer services if you want to make alterations like this.

If the water pressure is <0.1 MPa (1 bar), you need to remove the flow regulator from the appliance connection supports using pointed pliers. To do
this, unscrew Aqua-Stop.

Ventilation outlets in the base must be kept free and not be obstructed (e.g. by carpet).

Do not tip appliance over.

Electrical connections must be made by trained electricians in accordance with the guidelines and standards for low voltage installations and
the specifications of the local electricity supply companies. A plug-in appliance may only be connected to a socket outlet with earthing contact,
installed according to specifications. An all-pole mains isolating device with 3 mm contact opening should be provided in the house wiring system.
Switches, plug and socket devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching are
permissible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and fault-free operation. After
installation, live parts and cables with basic insulation must not be accessible. Old installations should always be checked. Refer to the identification
plate for specifications for the required mains voltage, current type and fuses. Application height of the appliance: up to max. 2000 m above sea level.

For Service and Spare Part Information please contact:
V-ZUG AUSTRALIA Pty. Ltd.
Tel [phone]

J163113-R06