Vulcan Hart VSC2, VSC3 General Manual
Item # __________________________
VSC SERIES
C.S.I. Section 11420
PRESSURE STEAM COOKER, REGENERATED STEAM
GENERATOR, TWO OR THREE COMPARTMENT MODELS
■■ VSC2 Two compartment steamer
■■ VSC3 Three compartment steamer
STANDARD FEATURES
■ Regenerated steam generator requires direct steam supply
at 40 to 50 psi with a flow of 200 lbs. of steam per hour.
Includes high pressure limit control and 15 psi safety relief
valve, low water control with automatic fill and blow down.
■ 6 psi pressure steam cooker.
■ Cooker body is 8 gauge satin finish type 304 stainless steel
exterior. Doors have a removable aluminum alloy inner
liner with full perimeter gasket and sealed by turning a
Acme type hand wheel. A spring loaded stainless steel
catch latches automatically when door is closed and cannot
be opened when steamer is on.
■ Automatic compartment controls with 60 minute timer.
■ Compartments have lift out universal pan supports (eight
2.5", four 4", or four 6" deep food pans).
■ Cooker mounted on 28" high base cabinet with stainless
steel front full height doors, slip-off stainless steel side and
aluminized steel rear panel with welded 6" stainless steel
legs rear with flange foot and front with bullet.
■ One year limited parts and labor warranty.
Vulcan-Hart Co.
ISO9001
A2780
MODELS: VSC SERIES
SPECIFICATIONS:
Regenerated steam generator steam cooker, Vulcan-Hart
Model No. (VSC2) (VSC3). 6 psi pressure steam cooker.
Cooker body is 8 gauge satin finish type 304 stainless steel
exterior. Doors have a removable aluminum alloy inner liner
with full perimeter gasket and sealed by turning an Acme type
hand wheel. A spring loaded stainless steel catch latches
automatically when the door is closed and cannot be opened
while the steamer is on. Automatic compartment controls with
60 minute timer. Compartments have lift-out universal pan
supports (eight 2.5", four 4", or four 6" deep food pans).
Cooker mounted on 28" high base cabinet with stainless steel
front full height doors, slip-off stainless steel side and aluminized
steel rear panel with welded 6" stainless steel legs rear with
flange foot and front with bullet. Regenerated steam generator
requires direct steam supply at 40 to 50 psi with a flow of
200 lbs. of steam per hour. Includes high pressure limit control
and 15 psi safety relief valve, low water control with automatic
fill and blowdown.
Exterior dimensions:
VSC2: 36"w x 33"d x 60
VSC3: 36"w x 33"d x 76
NSF listed. Meets ASME code.
3
/4"h.
1
/8"h.
OPTIONS
■■ Stainless steel cabinet base back.
■■ Stainless steel main frame.
■■ Controls with automatic load compensated timed, cooking
with automatic exhaust.
■■ Correction package:
a. Cabinet door with hasp (lock by others).
b. Security type tamper resistant fasteners.
c. Control cover (lock by others).
d. Front feet flanged.
■■ Control circuit step down transformer to 120V, if higher than
120 volt.
■■ Second year extended limited parts and labor warranty.
ACCESSORIES:
■■ Wire rack.
■■ Interconnecting steam supply plumbing kit.
■■ Water treatment system.
Pressure Steam Cooker, Regenerated Steam Generator
F-32475 (5-04)
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
VSC SERIES
PRESSURE STEAM COOKER, REGENERATED STEAM
GENERATOR, TWO OR THREE COMPARTMENT MODELS
EQUIPMENT CLEARANCE:
Rear: 0" Right and left side: 0"
DIRECT STEAM DATA:
Steam supply to the regenerated steamer must:
1. Maintain a steady 40 to 50 psi flow under operating conditions.
2. Have a minimum flow rate of 200 lbs. per hour, dry steam.
3. Be adequately trapped to provide dry steam. (See ball float trap.)
4. Provide a service shut-off valve.
WATER QUALITY STATEMENT:
The fact that a water supply is potable is no guarantee that it is
suitable for steam generation. Your water supply must be within
these general guidelines:
SUPPLY PRESSURE 20 - 80 psig
HARDNESS* less than 3 grains
SILICA less than 13 ppm
CHLORIDE less than 30 ppm
pH RANGE 7-8
* 17.1 ppm = 1 grain of hardness
Other factors affecting steam generation are iron content, amount of
chloridation and dissolved gases. Water supplies vary from state to
state and from locations within a state. Therefore it is necessary that
the local water treatment specialist be consulted before the installation of any steam generating equipment.
PAN CAPACITIES (Per compartment)
MODEL 21/2" deep 4" deep
VSC 84
SERVICE CONNECTIONS:
3
Steam Supply:
Electric Connection for Controls: 120/60/1, 300 watt maxi-
mum power supply with grounding wire required. (For other
than 120 volt supply, consult factory for location of this
conneciton.)
Drain: Condenser box, compartment and boiler, 2" NPT.
(Provide an open air gap type drain within 12" of condenser box.
Do not connect solidly to any drain connection.)
Cold Water Connection: 3/8" NPT for boiler feed. Inlet water
pressure between 20 and 80 psi.
Cold Water Connection:3/8" NPT for condensate box. Inlet
water pressure between 20 and 80 psi.
Water: For swing faucet, (single) (dual) temperature
tailpiece.
Steam Take-Off Connection:3/4" NPT.
NOTE:
• Dimensions which locate the above connections have a tolerance
of + or -3" (+ or -77 mm).
• Installation of backflow preventers, vacuum breakers and other
specific code requirements is the responsibility of the owner and
installer. It is the responsibility of the owner and installer to comply
with local codes.
• This appliance is manufactured for commercial installation only
and is not intended for home use.
/4" NPT for 40 - 50 psi direct steam.
1
/4" IPS
NOTE: In line with its policy to continually improve its products, Vulcan-Hart Company reserves the right to change materials and
specifications without notice.
F-32475 (5-04)
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
Printed On Recycled Paper
Loading...