SPECIFICATIONS:
Gas heated convection steamer, Vulcan-Hart Model No.
VH3616G. Two stainless steel cooking compartments with
coved interior corners. Each compartment accepts sixteen
1" deep, eight 2
1
/4" drain in each compartment. Heavy duty stainless steel
1
1
/2" deep or four 4" deep 12" x 20" pans.
"slammable" doors can be opened and closed at anytime
during the cooking cycle. Steam shuts off when door(s) are
opened. Compartment controls include 60 minute dial timer
with buzzer, green "ready" and red "cooking" indicator lights.
Convection steamer mounted on 28" high base cabinet with
stainless steel front full height doors, slip-off stainless steel
side and aluminized steel rear panel with welded 6" stainless
steel legs rear with flange foot and front with bullet. Steamer
mounted on 28" high base cabinet with stainless steel frame,
front full height doors, slip-off stainless steel side and aluminized rear panel with 6" adjustable legs with flanged feet for
anchoring. 270,000 BTU/hr. high efficiency steam boiler
with electronic ignition builds 5.5 BHP. Includes CSD-1
compliant high pressure limit switch (15 psi), low water cut-off,
automatic water fill, automatic boiler blowdown, 15 psi
pressure relief valve and 15 psi kettle connection. Service
connections include: 1" gas connection,
for boiler feed and
circuit and 1
1
1
/2" cold water condenser, 120 volt control
/4" drain connection.
1
/2" water connection
Exterior dimensions:
36"w x 357/16"d x 66"h.
SPECIFY TYPE OF GAS WHEN ORDERING.
SPECIFY ALTITUDE WHEN ABOVE 2,000 FT.
CSA design certified. Classified by U L to NSF Std. #4. Meets
ASME code.
Item # __________________________
C.S.I. Section 11420
MODEL VH3616G
GAS BOILER CONVECTION STEAMER
ON CABINET BASE
■■ VH3616G 2 compartments
STANDARD FEATURES
■ Two stainless steel cooking compartments with coved
interior corners. Each compartment accepts sixteen 1"
deep, eight 2
■ 11/4" drain in each compartment.
■ Heavy duty stainless steel "slammable" doors can be
opened and closed at anytime during the cooking cycle.
Steam shuts off when door(s) are opened.
■ Steamer mounted on 28" high base cabinet with stainless
steel frame, front full height doors, slip-off stainless steel
side and aluminized rear panel with 6" adjustable legs with
flanged feet for anchoring.
■ 270,000 BTU/hr. high efficiency steam boiler with electronic ignition builds 5.5 BHP. Includes CSD-1 compliant
high pressure limit switch (15 psi), low water cut-off,
automatic water fill, automatic boiler blowdown, 15 psi
pressure relief valve and 15 psi kettle connection.
■ Service connections include 1" gas connection,
water connection for boiler feed and 1/2" cold water condenser, 120 volt control circuit and 1
■ One year limited parts and labor warranty.
OPTIONS
■■ Correction facility package:
a. Cabinet door with hasp (lock by others).
b. Security type tamper resistant fasteners.
c. Control cover (lock by others).
■■ Control circuit step down transformer to 120V, if higher than
120 volts.
■■ Second year extended limited parts and labor warranty.
ACCESSORIES
■■ Water treatment system.
■■ Stainless steel back panel.
■■ Removable 12 x 20 sliding shelf (Qty.____).
1
/2" deep or four 4" deep 12" x 20" pans.
1
/4" drain connection.
1
/2" cold
Vulcan-Hart Co.
ISO9001
A2780
MODEL: VH3616G
High Efficiency Gas Boiler
F-32613 (5-04)
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
MODEL VH3616G
GAS BOILER CONVECTION STEAMER
ON CABINET BASE
SERVICE CONNECTIONS:
GAS CONNECTION: 1" NPT.
ELECTRICAL CONNECTION FOR CONTROLS: 120/60/1,
300 watt maximum, power supply with grounding wire required.
(For other than 120 volt supply consult factory for location of
this connection.)
DRAIN: Condenser box, compartment and boiler, 11/4" NPT.
(Provide an open air type drain within 12" of condenser box and
for best results at a distance so that steam vapors will not enter
the steamer from underneath the control area. Do not connect
solidly to any drain connections.)
COLD WATER CONNECTION: 1/2" NPT for boiler feed. Inlet
water pressure between 20 and 60 psi.
COLD WATER CONNECTION: 1/8" NPT for condensate box.
Inlet water pressure between 20 and 60 psi.
STEAM TAKE-OFF CONNECTION: 3/4" NPT.
WATER QUALITY STATEMENT:
The fact that a water supply is potable is no guarantee that it is suitable
for steam generation. Your water supply must be within these general
guidelines:
SUPPLY PRESSURE 20 - 60 psig
HARDNESS* less than 3 grains
SILICA less than 13 ppm
TOTAL CHLORIDE less than 4.0 ppm
pH RANGE 7-8
UN-DISSOLVED SOLIDS less than 5 microns
* 17.1 ppm = 1 grain of hardness
Other factors affecting steam generation are iron content, amount of
chloridation and dissolved gases. Water supplies vary from state to state
and from locations within a state. Therefore it is necessary that the local
water treatment specialist be consulted before the installation of any
steam generating equipment.
IMPORTANT:
1. A pressure regulator sized for this unit is included. Minimum supply
pressure: Natural gas 7" W.C., Propane gas 11" W.C.
2. Gas line connecting to unit must be 3/4" or larger. If flexible connectors
are used, the inside diameter must be at least the same as the 3/4" iron
pipe.
3. An adequate ventilation system is required for commercial cooking
equipment. Information may be obtained by writing to the National
Fire Protection Association, Batterymarch Park, Quincy, MA 02289.
When writing, refer to NFPA No. 96.
4. These units are manufactured for installation in accordance with
ANSZ223.1A (latest edition), National Fuel Gas Code. Copies may be
obtained from the American Gas Association, 1515 Wilson Blvd.,
Arlington, VA 22209.
5. Clearance: Combustible Non-Combustible
Rear 6" 6"
Left & Right Side 6" 6"
NOTE:
• Dimensions which locate the above connections have a tolerance of
+ or -3" (+ or -75 mm).
• Installation of backflow preventers, vacuum breakers and other specific
code requirements is the responsibility of the owner and installer. It is
the responsibility of the owner and installer to comply with local codes.
• Plastic drains are not recommended due to inherent limited tempera-
tures of the plastic. Boiler purge temperatures may exceed 180°F. The
installer may be required to provide means to reduce boiler purge water
temperature to be that of the condensate temperature of 140°F or less.
• This appliance is manufactured for commercial installation only and is
not intended for home use.
PAN CAPACITIES (Per compartment)
1" deep 21/2" deep 4" deep
16 8 6
NOTE: In line with its policy to continually improve its products, Vulcan-Hart Company reserves the right to change materials and
specifications without notice.
F-32613 (5-04)
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
Printed On Recycled Paper