Vulcan-Hart VCB-S User Manual
(Shown with optional doors)
Item # __________________________
C.S.I. Section 11420
VCB-S SERIES
HEAVY DUTY GAS CHAR-BROILER WITH OPEN
CABINET BASE
■■ VCB-36S 36" wide, 87,000 BTU/hr.
STANDARD FEATURES
■ Stainless steel front, control panel, front top ledge, backsplash
and grease trough.
■ Stainless steel 6" adjustable legs.
■ Sides finished in black epoxy powder coat paint.
1
/4" diameter front gas manifold.
■ 1
■ Full width front grease drawer.
■ Heavy cast iron char-radiants and "Flame Arrestor" broiling
grates.
1
/4" wide grates are reversible for "level" broiling or self
■ 5
cleaning. Cast-in pitched grease trough in each grate blade
provides fat run-off and controls flare-ups.
■ One 14,500 BTU/hr. cast iron burner for each broiling grate.
■ Standing pilot ignition system.
■ Underburner baffling system reflects heat upwards creating a
"Cool Zone" in the grease drawer and drip pan areas.
■ One year limited parts and labor warranty.
Vulcan-Hart Co.
ISO9001
A2780
MODELS: VCB-S SERIES
SPECIFICATIONS:
Heavy duty gas char-broiler, Vulcan-Hart Model No. VCB-36S.
Stainless steel front, control panel, front top ledge, backsplash
and grease trough. Sides finished in black epoxy powder coat
paint. 6" adjustable legs. 1
1
/4" diameter front gas manifold. Full
width front grease drawer. Heavy cast iron char-radiants and
"Flame Arrestor" broiling grates. 51/4" wide grates are reversible
for "level" broiling or self cleaning. Cast-in pitched grease trough
in each grate blade provides fat run-off and controls flare-ups.
One 14,500 BTU/hr. cast iron burner for each broiler grate.
Standing pilot ignition system. Underburner baffling system
reflects heat upwards creating a "Cool Zone" in the grease
drawer and drip pan areas.
Exterior dimensions: 36"w x 38"d x 36" working height on 6"
adjustable legs.
CSA design certified. NSF listed.
SPECIFY TYPE OF GAS AND FINISH WHEN ORDERING.
SPECIFY ALTITUDE WHEN ABOVE 2,000 FT.
OPTIONS
■■ Round rod broiling grates - for broiling fish or chicken.
■■ Diamond shaped broiling grates, sloped, not reversible.
1
/2"w x 21"d x 3/4" thick aluminum lift-off griddle plate.
■■ 16
■■ Stainless steel side(s). ■■ Left ■■ Right
■■ Stainless steel cabinet doors.
■■ Stainless steel side and rear splashes.
■■ Cap and cover manifold end(s). ■■ Left ■■ Right
■■ Leveling bolts in place of legs for curb mounting.
■■ Stainless steel dolly frame with casters, up to 72" wide.
3
/4" rear gas connection (includes gas pressure regulator.)
■■
■■ Common stainless steel front top ledge up to 96" wide.
(Drawing required showing the position of each piece of
equipment.)
ACCESSORIES
■■ Set of four 5" diameter casters, two locking.
1
/2" or 373/4" high stainless steel back riser. (Common back
■■ 26
risers available up to 72" wide.)
■■ Flexible gas hose with quick disconnect and restraining
device. Consult price book for available sizes.
Heavy Duty Cabinet Base Gas Char-Broiler
F-32500 (10-03)
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
IMPORTANT
1. A properly sized gas pressure regulator suitable for battery or
single unit application must be furnished and installed.
Natural gas 5.0" W.C., propane gas 10.0" W.C.
2. An adequate ventilation system is required for commercial
cooking equipment. Information may be obtained by writing to
the National Fire Protection Association, Batterymarch Park,
Quincy, MA 02269. When writing refer to NFPA No. 96.
3. These units are manufactured for installation in accordance
with ANSZ223.1a (latest edition), National Fuel Gas Code.
Copies may be obtained from the American Gas Association,
1515 Wilson Blvd., Arlington, VA 22209.
4. Clearances: Combustible Non-Combustible
Rear 2" 0"
Sides 20" 2"
VCB-S SERIES
HEAVY DUTY GAS CHAR-BROILER WITH OPEN
CABINET BASE
5. For proper combustion, install equipment on adjustable legs
or casters. On curb or platform, allow 3
Leveling bolts are required for curb installation. Specify when
ordering.
6. Cannot be batteried with GH series equipment.
7. This appliance is manufactured for commercial installation
only and is not intended for home use.
1
/2" front overhang.
WORKING
MODEL BTU/HR. HEIGHT SHP. WT.
NO. INPUT WIDTH DEPTH ON 6" LEGS (lbs./kg)
VCB-36S 87,000 36" 38" 36" 575 / 261
NOTE: In line with its policy to continually improve its products, Vulcan-Hart Company reserves the right to change materials and
specifications without notice.
F-32500 (10-03)
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
APPROX.
Printed On Recycled Paper
Loading...